2018 MERCEDES-BENZ E 400 4MATIC

Component/System: The intake camshaft positioner/adjuster on cylinder bank 2 of the M276 V6 engine has failed, along with associated timing components. The vehicle (2018 Mercedes-Benz E400, VIN [XXX]) remains unrepaired and is available for inspection upon request. Safety Risk: The engine produces a loud metallic rattle on cold starts, indicating loss of proper camshaft timing control. If unaddressed, camshaft timing deviation can progress to timing chain failure, which on interference engines can cause valve-to-piston contact and sudden, severe engine damage or loss of power while driving, posing a risk to vehicle control. Confirmed by Dealer: Yes. Mercedes-Benz of Catonsville (RO# [XXX]) diagnosed the issue and confirmed stored fault code P002177, indicating the intake camshaft position on cylinder bank 2 deviates from its specified value. The dealer's own notes state camshaft adjusters "are prone to failure and commonly damage camshafts when they fail." Manufacturer Notified: I contacted Mercedes-Benz USA directly (Case #[XXX]) to request they address this repair, citing that this camshaft/timing failure is a known, recurring issue on M276-equipped vehicles, supported by Mercedes' own technical service bulletins (TSB LI05.10-P-056435 and TSB LI05.20-P-059966) describing this exact failure pattern. Despite multiple attempts, including a promised callback that was never received and nearly an hour on hold with no resolution, Mercedes-Benz USA has not adequately responded or taken action. Warning Signs: The check engine light illuminated in early August 2026, prompting a dealer visit. The cold-start rattle was identified by the dealer during diagnosis the following day. No prior symptoms were noticed beforehand. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2018 Mercedes-Benz E400 4MATIC. The contact stated that while driving at an undisclosed speed, the accelerator pedal was depressed and the driveshaft felt loose, with an abnormally loud knocking sound coming from the vehicle. The contact associated the failure with NHTSA Campaign Number: 26V216000 (Power Train). The dealer was contacted; however, the vehicle was not diagnosed or repaired. The manufacturer was contacted and informed the contact that the remedy was not yet available. The failure mileage was approximately 84,000.