SEAT BELT TRACK JAMMED, DEALER WILL NOT COVER, ALTHOUGH THERE APPEARS TO BE A RECALL FOR THIS ISSUE ALREADY. *TR
1990 Mazda Protege
Owner reports · Recalls · Investigations
Similar to other model years
Owner complaints for the 1990 Mazda Protege do not stand out strongly from the model-year median of 66.
About this comparison →How this year compares
Owner complaints by model year
Compare all Protege years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 2 of 37 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Seat Belts. Review the 21 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Steering. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
Seat Belts complaints
21 reportsTHE FRONT AUTOMATIC PASSIVE RESTRAINT SEAT BELTS SYSTEM IS INOPERATIVE BECAUSE THE RAIL IS BAD. THE DEALERSHIP REFUSED TO REPLACE THE RAIL AS STATED IN THE AUTOMATIC SHOULDER BELT RAIL RECALL 97V211000. THERE IS CONFLICT BETWEEN THE DEALERSHIP AND MANUFACTURE CONCERNING WHAT PART IN THE PASSIVE RESTRAINT SYSTEM SHOULD BE REPLACE…
Read full complaint
THE FRONT AUTOMATIC PASSIVE RESTRAINT SEAT BELTS SYSTEM IS INOPERATIVE BECAUSE THE RAIL IS BAD. THE DEALERSHIP REFUSED TO REPLACE THE RAIL AS STATED IN THE AUTOMATIC SHOULDER BELT RAIL RECALL 97V211000. THERE IS CONFLICT BETWEEN THE DEALERSHIP AND MANUFACTURE CONCERNING WHAT PART IN THE PASSIVE RESTRAINT SYSTEM SHOULD BE REPLACED UNDER THE RECALL. *NM THE PASSENGER SIDE SHOULDER BELT IS STUCK IN THE MIDDLE OF THE RAIL THUS MAKING IT INOPERATIVE. THE DRIVER'S SHOULDER BELT IS STUCK IN THE REAR OF THE RAIL AND IS ALSO INOPERATIVE. *NM
DRIVER'S SIDE MOTOR BELT FAILED TO OPERATE, LEAVING DRIVER WITHOUT ANY RESTRAINT. DEALER NOTIFIED, AND INFORMED CONSUMER THAT VEHICLE WAS NOT COVERED UNDER MANUFACTURER'S RECALL, AND REPAIRS WOULD ONLY BE MADE AT CONSUMER'S COST.*AK
CAR WAS PURCHASED USED IN 1997. CAR HAS ALWAYS HAD SOME VIBRATION WHEN IT IDLES. IN NOVEMBER OF 1998 CAR BEGAN OVERHEATING. RADIATOR WAS REPLACED BUT DID NOT SOLVE THE PROBLEM. TOOK BACK TO HAVE REPAIRED. THERMOSTAT WAS REPLACED AND WHILE REPLACING THE THERMISTAT A CRACKED SENSOR WAS ALSO FOUND AND REPLACED. THIS CORRECTED…
Read full complaint
CAR WAS PURCHASED USED IN 1997. CAR HAS ALWAYS HAD SOME VIBRATION WHEN IT IDLES. IN NOVEMBER OF 1998 CAR BEGAN OVERHEATING. RADIATOR WAS REPLACED BUT DID NOT SOLVE THE PROBLEM. TOOK BACK TO HAVE REPAIRED. THERMOSTAT WAS REPLACED AND WHILE REPLACING THE THERMISTAT A CRACKED SENSOR WAS ALSO FOUND AND REPLACED. THIS CORRECTED THE PROBLEM. IN DECEMBER OF 1998 FRONT DRIVERSIDE SHOULDER SEAT BELT FROZE. IT WOULD NOT RETRACT ALL THE WAY BACK. IT WOULD MAKE A CONSTANT CLICKING NOSE. THE WIRES WERE ALSO OFF THE TRACK. HAD TO DISCONNECT THE FUSE TO SHUT OFF THE CLICKING NOISE. HAD AN ESTIMITE TO HAVE IT REPAIRED WHICH WAS APPROX. 900.00.
CONSUMER WAS DRIVING VEHICLE WHEN THE MOTORIZED SHOULDER RESTRAINT WOULD NOT RELEASE PROPERLY. SHE WAS PULLING AND HEARD A CLICKING NOISE, AND BELT WAS STUCK. DEALERSHIP (BIG SKY AUTO ) MECHANIC CALLED MAZDA MANUFACTURER, AND WAS TOLD THE VEHICLE WAS TOO OLD, AND THEY WOULD NOT FIX. *AK
SHOULDER HARNESS FAILED.
WHILE STOPPED, VEHICLE WAS REARENDED BY MOVING VEHICLE THAT WAS TRAVELING 35 MPH. DRIVER FELL FORWARD/BACKWARD, SEATBACK RECLINED, LEFT SIDE OF SEAT BROKE, MOTORIZED SHOULDER BELT DID NOT RETRACT. DEALER REPLACED SEAT FRAME. FOUND NO PROBLEM WITH SEAT BELT. *AK CONSUMER SUSTAINED INJURIES TO THE NECK, UPPER BACK, RIGHT SHOU…
Read full complaint
WHILE STOPPED, VEHICLE WAS REARENDED BY MOVING VEHICLE THAT WAS TRAVELING 35 MPH. DRIVER FELL FORWARD/BACKWARD, SEATBACK RECLINED, LEFT SIDE OF SEAT BROKE, MOTORIZED SHOULDER BELT DID NOT RETRACT. DEALER REPLACED SEAT FRAME. FOUND NO PROBLEM WITH SEAT BELT. *AK CONSUMER SUSTAINED INJURIES TO THE NECK, UPPER BACK, RIGHT SHOULDER, ARM, HAND, AND SHOULDER BLADE. *SLC
MOTORBELTS EXPERIENCE ERRATIC OPERATION INTERMITTENTLY. MJS
RETRACTABLE SEAT BELT LATCHES ON BOTH SIDES ARE FAILING.
THE PASENGER'S SEAT BELT RETRACTOR NEVER WORKED, ALSO CRUISE CONTROL MALFUNCTIONED, PURCHASED USED VEHICLE. *AK
Official recalls
115V674000 · Electrical System:ignition:switch
Oct 19, 2015
Mazda North American Operations (Mazda) is recalling certain model year 1989-1998 MPV, 1990-1995 323, 1990-1998 Protege, 1992-1993 MX-3, 1993-1995 929, 1993-1997 MX-6, and 1993-1998 626 vehicles. In the affected vehicles, grease applied to the contact points inside the ignition switch may become conductive and overheat.
Consequence & remedy
Consequence: If the ignition switch overheats there would be an increased risk of a fire.
Remedy: Mazda will notify owners, and dealers will replace the ignition switch, free of charge. The recall began on December 17, 2015. Owners may contact Mazda Customer Experience Center at 1-800-222-5500, option#6. Mazda's number for this recall is 8715J.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2EA94039 · Auto Restraint System Fail
Opened Nov 30, 1994 · Closed Nov 26, 1997
Status: closed (inferred from source dates) · Seat Belts
There is no summary currently available
PE94059 · Auto Restraint System Fail
Opened Jul 28, 1994 · Closed Nov 30, 1994
Status: closed (inferred from source dates) · Seat Belts
There is no summary currently available
Illustration