IllustrationWHILE DRIVING AT AN UNDETERMINED SPEED AND WITH NO WARNING REAR SUSPENSION COLLAPSED. THE CONSUMER HAD THE VEHICLE TOWED TO THE SERVICE DEALER. *AK THE FAILURE WAS DUE TO SALT CORROSION. THE VEHICLE SPUN AROUND, SLID ACROSS THE LEFT LANE AND INTO THE MEDIAN. *SC
1988 Mazda MX6
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all MX6 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 16 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Seat Belts. Review the 9 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
1 crash reports1 fire reports1 injury reports
What owners actually said
16 reportsCONSUMER STATES THAT THERE IS AN ELECTRICAL SHORT THAT DRAINS THE BATTERY IN AS LOW AS HALF AN HOUR AFTER THE BATTERY HAS BEEN CHARGED, THE ALTERNATOR HAS BEEN REPLACED THREE TIMES ALONG WITH THE BATTERY, MAIN FUSE AND DISTRIBUTOR, HOWEVER THE PROBLEM CONTINUES. *SLC
CONSUMER BOUGHT FOUR TIRES, AND THREE HAD TREAD SEPARATION. *AK
SEAT BELT LOCK AND RELEASE MECHANISM JAMMED RENDERING SEATBELT USELESS. NLM
INITIALLY WHEN THIS PROBLEM OCCURRED, I DISCOVERED THE DOOR HANDLE MECHANISM IS MADE OF POT METAL AND NOT OF A VERY STRONG NATURE FOR THE FREQUENT USE IT GETS. CHECKING WITH THE DEALER I FIND IT WILL COST $300 TO FIX. TO SAVE MONEY I RESEARCHED USED PART PLACES. I DISCOVERED THIS IS A WIDE SPREAD PROBLEM AND DOOR HANDLES ARE …
Read full complaint
INITIALLY WHEN THIS PROBLEM OCCURRED, I DISCOVERED THE DOOR HANDLE MECHANISM IS MADE OF POT METAL AND NOT OF A VERY STRONG NATURE FOR THE FREQUENT USE IT GETS. CHECKING WITH THE DEALER I FIND IT WILL COST $300 TO FIX. TO SAVE MONEY I RESEARCHED USED PART PLACES. I DISCOVERED THIS IS A WIDE SPREAD PROBLEM AND DOOR HANDLES ARE RARE TO COME BY AS MOST ARE ALREADY BOUGHT UP. I HAVE SEARCHED NORTHERN AS WELL AS SOUTHERN CA, AND WILL NOW TRY IN TX. I FEEL THIS IS A SAFETY ISSUE BECAUSE MY 2 YEAR OLD WAS LOCKED IN THE CAR THE OTHER DAY AND THE HANDLE OF COURSE BEING BROKEN WOULDN'T OPEN. LUCKILY I WAS ABLE TO PUT SOMETHING DOWN THROUGH THE GLASS TO OPEN IT FROM THE INSIDE. THIS IS OBVIOUSLY A DEFECTIVE PART, IS THERE ANYWAY TO HAVE IT FIXED BY THE DEALER?.
HAD PARKED VEHICLE & PUT WINDOWS DOWN. WHILE PUTTING POWER WINDOWS DOWN, STARTED TO MAKE NOISES & GOT STUCK. POWER WINDOWS HIT A ROD. THE DOOR BECAME UNLOCKED & OPEN. TRIED CLOSING DOOR, BUT DOOR DID NOT CLOSE PROPERLY. WILL BE TAKING VEHICLE TO DEALER TO HAVE DOOR & WINDOWS CHECKED. *AK
FRONTAL COLLISION, IMPACT 12:00 POSITION, LAP/SHOULDER BELT DID NOT RETRACT, VEHICLE WAS COMPLETELY STOPPED. *AK
THE DEALERSHIP DOES NOT HAVE THE PARTS AVAILABLE AND HASN'T HAD THE PARTS IN A MONTH 95V1003005. PLEASE DESCRIBE. *AK
WHILE DRIVING SMOKE STARTED COMING FROM THE ENGINE AND THROUGH THE HEATING DUCTS, DRIVER PULLED OVER THE FIRE HAD STARTED. TT
THE FRONT PASSENGER SIDE SEATBELT WILL NOT LATCH AND WHEN IT IS LATCHED IT WILL NOT UNLATCH. PLEASE DESCRIBE. TT
Official recalls
595V103005 · Seat Belts:front:buckle Assembly
May 24, 1995
THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.
Consequence & remedy
Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.
Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.
88V022000 · Vehicle Speed Control:accelerator Pedal
Feb 22, 1988
AT AMBIENT TEMPERATURES BELOW 0 DEGREE F, FROST MAY ACCUMULATE WITHIN THE THROTTLE BODY UNDER EXTENDED CONSTANT SPEED OPERATION.
Consequence & remedy
Consequence: FROST ACCUMULATION ON THE THROTTLE VALVE MAY PREVENT THEVALVE FROM RETURNING SMOOTHLY.
Remedy: INSTALL A NEW TYPE THERMOSTAT DESIGNED TO RAISE THE COOLANT TEMPERATURE AND WARM THE THROTTLE BODY TO A LEVEL ABOVE FREEZING.
87V196000 · Service Brakes, Hydraulic:foundation Components:drum:shoes/linings
Dec 29, 1987
VEHICLES EQUIPPED WITH REAR BRAKE DRUMS TRANSPORTED BY TRAIN MAY EXPERIENCE SEPARATION OF THE BRAKE SHOE FROM THE WHEEL BRAKE CYLINDER PISTON.
Consequence & remedy
Consequence: SHOULD SEPARATION OCCUR, REPEATED BRAKE OPERATION MAYDAMAGE THE WHEEL BRAKE CYLINDER DUST BOOT, ALLOWING WATER OR DUST INTRUSION ANDSUBSEQUENT PISTON CONTAMINATION.
Remedy: ALL VEHICLES WILL BE INSPECTED AND IF NO SEPARATION IS FOUND GREASE WILL BE APPLIED TO THE COMPONENT INTERFACE TO LOWER FRICTION AND AVOID SUBSEQUENT RELATIVE MOTION. IF SEPARATION IS FOUND THE WHEEL BRAKE CYLINDER DUST BOOT WILL BE REPLACED.
87V186000 · Fuel System, Gasoline:storage:tank Assembly
Dec 7, 1987
FUEL TANK FIXING BAND RETENTION IS NOT SUFFICIENT, ALLOWING THE BAND TO RUB AGAINST THE FUEL TANK BY VEHICLE VIBRATIONS.
Consequence & remedy
Consequence: THIS COULD WEAR A HOLE IN THE FUEL TANK WHICH COULDRESULT IN FUEL LEAKAGE.
Remedy: REPAIR FUEL FIXING BAND BY INSTALLING A RUBBER SHEET.
87V149000 · Vehicle Speed Control:linkages
Sep 17, 1987
FLOOR MAT COULD INTERFERE WITH RELEASE OF ACCELERATOR PEDAL DUE TO IMPROPER SHAPE OF MAT.
Consequence & remedy
Consequence: THIS COULD RESULT IN LOSS OF ACCELERATOR CONTROL ANDCREATE POTENTIAL FOR AN ACCIDENT.
Remedy: REMOVE PRESENT MAT AND REPLACE WITH NEW IMPROVED MAT.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
3EA95005 · Takata Seat Belt Buckle Failure
Opened Mar 10, 1995 · Closed Aug 1, 1995
Status: closed (inferred from source dates) · Seat Belts:front:buckle Assembly
There is no summary currently available
PE91088 · Throttle Sticking
Opened Jun 18, 1991 · Closed Oct 21, 1991
Status: closed (inferred from source dates) · Vehicle Speed Control:linkages
There is no summary currently available
PE89167 · Transmission Oil Line Fire
Opened Sep 15, 1989 · Closed Dec 21, 1989
Status: closed (inferred from source dates) · Power Train
There is no summary currently available