Electrical SystemEngine And Engine CoolingSuspension
I HAVE HAD A HEAD GASKET REPLACE ON THIS 1998 MAZDA B4000 WITHIN 61,000 MILES. THE FIRST HEAD GASKET REPLACEMENT WAS 1-21-2008. NOW THE SAME THING SEEMS TO BE HAPPENING AT 78,100 MILES ARE THERE ANY ISSUES WITH THIS MODEL? I ONLY DRIVE THE TRUCK TO WORK AND BACK WHICH IS ONLY ABOUT 5 MILES FROM MY HOME. ALSO THE FRONT END SUSPE…
Read full complaint
I HAVE HAD A HEAD GASKET REPLACE ON THIS 1998 MAZDA B4000 WITHIN 61,000 MILES. THE FIRST HEAD GASKET REPLACEMENT WAS 1-21-2008. NOW THE SAME THING SEEMS TO BE HAPPENING AT 78,100 MILES ARE THERE ANY ISSUES WITH THIS MODEL? I ONLY DRIVE THE TRUCK TO WORK AND BACK WHICH IS ONLY ABOUT 5 MILES FROM MY HOME. ALSO THE FRONT END SUSPENSION MAKES A LOUD SQUEAKING/POPPING NOISE WHEN YOU TURN THE STEERING WHEEL OR HIT A ROUGH PLACE IN PAVEMENT. THE "KEY IN THE IGNITION" BUZZER KEEPS DINGING AFTER YOU TAKE THE KEY OUT OF THE IGNITION. *TR
NHTSA ODI #10452845
128,131 miles · Oct 13, 2008
SteeringSuspension
I OWN A 1998 MAZDA PICKUP, 2500 MODEL. IT HAS ALWAYS BEEN A FLORIDA VEHICLE. I DID A FRONT END SUSPENSION CHECK, AND FOUND ALL 4 BALL JOINTS WITH DEEP RUST, NO RUBBER SEALS LEFT OTHER THAN BRITTLE AND CRACKED REMAINS OF THE RUBBER BOOT AROUND THE JOINTS. THE RUBBER BUSHINGS ON THE FRONT STABILIZER ASSEMBLY WERE ALSO EITHER TOTAL…
Read full complaint
I OWN A 1998 MAZDA PICKUP, 2500 MODEL. IT HAS ALWAYS BEEN A FLORIDA VEHICLE. I DID A FRONT END SUSPENSION CHECK, AND FOUND ALL 4 BALL JOINTS WITH DEEP RUST, NO RUBBER SEALS LEFT OTHER THAN BRITTLE AND CRACKED REMAINS OF THE RUBBER BOOT AROUND THE JOINTS. THE RUBBER BUSHINGS ON THE FRONT STABILIZER ASSEMBLY WERE ALSO EITHER TOTALLY DISINTEGRATED OR MISSING. THE MECHANIC TOLD ME THE CONDITION HAD BEEN PRESENT FOR SOME TIME, THE BALL JOINTS WERE BADLY WORN, AND CATASTROPHIC FAILURE WOULD HAVE OCCURRED WITHIN MONTHS. THIS VEHICLE WAS BUILT BY FORD. I BELIEVE THE QUALITY AND DURABILITY OF THE RUBBER BOOTS PROTECTING THESE VITAL PARTS WAS DEFECTIVE. ACCORDING TO SOME OTHERS I HAVE DISCUSSED THIS WITH, ROTTED BOOTS ARE NOT UNCOMMON. IN THE PAST I HAVE KEPT VEHICLES FOR OVER 20 YEARS WITHOUT ANY PROBLEM WITH BALL JOINT AND STEERING KNUCKLES GREASE COVERS. REQUEST THIS BE INVESTIGATED AS A MANUFACTURES DEFECT. THANKS IN VIEW OF THE POTENTIAL FOR ACCIDENTS, THIS NEEDS FOLLOWUP. *TR
NHTSA ODI #10245218
Mileage unknown · Aug 18, 2000
SuspensionTires
WILDERNESS AT P23575R15, ORIGINAL EQUIPMENT WITH MAZDA B3000 1998. FRONT TWO TIRES WERE WEARING OFF FROM THE SIDES AT ONLY 18,000 MILES. ALSO, WHEN DRIVING AT APPROXIMATELY 50 MPH AND OVER, DIP THE VEHICLE AND IT WILL SWAY, MAKING IT DIFFICULT TO CONTROL.*AK
NHTSA ODI #868096
Mileage unknown · Nov 5, 1998
Suspension
TRUCK SHAKES SIDE TO SIDE WHILE DRIVING DEALER ATTEMPTED TO FIX BUT PROBLEM STILL EXIST.
ON CERTAIN TRUCKS EQUIPPED WITH A SPEED CONTROL SYSTEM, THE SPEED CONTROL DEACTIVATION SWITCH MAY, UNDER CERTAIN CONDITIONS, LEAK INTERNALLY AND THEN OVERHEAT, SMOKE, OR BURN.
Consequence & remedy
Consequence: THIS COULD RESULT IN AN UNDERHOOD FIRE.
Remedy: DEALERS WILL INSTALL A FUSED WIRING HARNESS. AN INTERIM NOTICE WAS SENT TO OWNERS ON SEPTEMBER 7, 2007, DIRECTING THEM TO HAVE THE SPEED DEACTIVATION CONTROL SWITCH DISCONNECTED TEMPORARILY. A SECOND NOTIFICATION LETTER TO OWNERS WAS IN FEBRUARY 2008 ADVISING THEM TO RETURN TO DEALERS FOR INSTALLATION OF THE REPAIR PART. OWNERS OF AFFECTED VEHICLES WHO DID NOT RECEIVE A PHASE 2 NOTICE AND HAVE NOT HAD THE RECALL COMPLETED WILL BE NOTIFIED BEGINNING AUGUST 6, 2008. OWNERS MAY CONTACT MAZDA AT 1-800-222-5500.
VEHICLE DESCRIPTION: CERTAIN 1998-1998 MAZDA B-SERIES TRUCKS (B2500, B3000 AND B4000) EQUIPPED WITH CRUISE CONTROL AND BUILT FROM JANUARY 1998 THROUGH MARCH 4, 1999. A CRUISE CONTROL CABLE CAN INTERFERE WITH THE SPEED CONTROL SERVO PULLEY AND NOT ALLOW THE THROTTLE TO RETURN TO IDLE WHEN DISENGAGING THE CRUISE CONTROL.
Consequence & remedy
Consequence: IF THE CRUISE CONTROL IS USED AND THIS CONDITION IS PRESENT, A STUCK THROTTLE COULD RESULT, WHICH COULD POTENTIALLY RESULT IN A CRASH.
Remedy: DEALERS WILL REPLACE THE CRUISE CONTROL CABLES. AT THE PRESENT TIME, THE REPLACEMENT CABLES ARE NOT AVAILABLE. CUSTOMERS ARE BEING ADVISED NOT TO USE THE CRUISE CONTROL SYSTEM UNTIL A REPLACEMENT CAN BE MADE.
VEHICLE DESCRIPTION: LIGHT DUTY 4X2 AND 4X4 PICKUP TRUCKS EQUIPPED WITH 4.0L ENGINES. THE FLEXIBLE SECTION OF THE CHASSIS MOUNTED FUEL LINE THAT CONNECTS TO THE ENGINE WAS ROUTED TOO CLOSE TO THE EXHAUST MANIFOLD. THE LINE COULD CONTACT THE MANIFOLD.
Consequence & remedy
Consequence: THIS COULD POTENTIALLY RESULT IN DAMAGE TO THE FUEL LINE, OR IN SOME CASES, CAUSE A FUEL LEAK. FUEL LEAKAGE IN THE PRESENCE OF AN IGNITION SOURCE COULD RESULT IN A FIRE.
Remedy: DEALERS WILL INSTALL AN ADDITIONAL CLIP TO HOLD THE FUEL LINE IN THE INTENDED DESIGN POSITION.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
1998 Mazda B-SERIES Truck Problems, Complaints & Recalls | Skip That Year
Illustration