2000 Jeep Wrangler

FRAME IS ROTTING AWAY. VEHICLE IS GARAGE KEPT. NO SPECIFIC AREA BECAUSE ITS THE ENTIRE FRAME. THESE VEHICLES COST ENTIRELY TOO MUCH MONEY FOR THIS TO BE HAPPENING. THERE ARE MANY COMPLAINTS ON HERE WITH THE SAME ISSUE. CHRYSLER APPARENTLY DIDN'T FEEL IT NECESSARY TO STEP UP TO THE PLATE AND FIX THE ISSUE. IF I WAS NOT A KNOWLEDGEABLE INDIVIDUAL, THIS IS A HUGE SAFETY ISSUE FOR SOMEONE DRIVING DOWN THE HIGHWAY AND FRAME OF JEEP BREAKING. I'M SURE IT'S ALREADY HAPPENED AND IS JUST NOT BEING ACKNOWLEDGED. *TR

PURCHASED THIS VEHICLE IN 21013 FROM A PRIVATE SELLER. UPON CHANGING THE ENGINE OIL ONE DAY SHORTLY THEREAFTER, NOTICED THE PASSENGER SIDE FRAME AREA, WHERE THE REAR, LOWER CONTROL ARM IS MOUNTED, WAS COMPLETELY RUSTED THROUGH! I HAVE SINCE HAD THIS REPAIRED, AT AN ADDITIONAL COST OF $800.00. ALSO, NOTICED THE PASSENGER SIDE FRAME ALL ALONG WHERE THE TRANSMISSION SKID PLATE IS MOUNTED - IS COMPLETELY RUSTED THROUGH ALONG APPROXIMATELY 8" ALONG THE BOTTOM! I CAN RUN 4 FINGERS IN THE BOTTOM OF THIS FRAME! AND, THE FRONT SKID PLATE NUTSERTS ON BOTH SIDES OF THE SKID PLATE, ARE GONE! RUSTED AWAY - COMPLETELY! PREVIOUS OWNER HAD THE SKID PLATE ACTUALLY WELDED TO THE FRAME! THIS SHOULD NEVER, EVER HAPPEN! I HAVE A 2003 TOYOTA 4RUNNER WITH ZERO FRAME RUST - ZERO! LOOKS BRAND NEW TO THIS DAY! COME TAKE A LOOK. MANY, MANY, MANY AND WAY TOO NUMEROUS TO MENTION PEOPLE HAVE THIS SAME FRAME RUST PROBLEM ON THEIR JEEPS. WHY IS THIS? THIS IS NOT SAFE, YET THESE VEHICLES ARE RE-SOLD OVER AND OVER AGAIN. THIS IS 2015. NO OTHER VEHICLE - AMERICAN OR IMPORT - HAS THIS PROBLEM. WHY IS THIS ALLOWED TO HAPPEN? MUST PEOPLE GET KILLED DURING THEIR ENJOYMENT OF THEIR SUPPOSEDLY "SAFE", IN THIS CASE, AMERICAN MADE VEHICLE BEFORE DEALERS AND THE NHTSA WILL APPLY A REPAIR BULLETIN? TOYOTA, IS STILL BUYING BACK TRUCKS WITH FRAME RUST - WHY ISN'T THE AMERICAN COMPANY CHRYSLER? HMMMM. *TR

TL* THE CONTACT OWNS A 2000 JEEP WRANGLER. WHILE DRIVING AT 35 MPH, THE VEHICLE STARTED TO SHAKE. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC. THE MECHANIC STATED THAT THERE WAS CORROSION AROUND THE CROSS MEMBER OF THE FRAME ON THE PASSENGER SIDE. THE MECHANIC DIAGNOSED THAT THE FRAME OF THE VEHICLE NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 170,000.

TL*THE CONTACT OWNS A 2000 JEEP WRANGLER. THE CONTACT STATED THAT WHILE DRIVING AT APPROXIMATELY 15 MPH, THE VEHICLE STARTED TO MAKE AN ABNORMAL KNOCKING AND BUCKING NOISE. AFTER INSPECTING THE VEHICLE, THE CONTACT NOTICED THAT THE TRANSMISSION MOUNT WAS ROTTED AWAY FROM THE FRAME. THE VEHICLE WAS NOT TAKEN TO A DEALER AND WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 120,000. THE VIN NUMBER WAS UNAVAILABLE. UPDATED 4/15/15*CN UPDATED 9/21/2017*CN

THE ENGINE CYLINDER HEAD WAS CRACKED BETWEEN NUMBER THREE AND FOUR CYLINDERS FOR A UNDETERMINED AMOUNT OF TIME. JEEP WOULD NOT CONFIRM THAT A UPDATED CYLINDER WAS MADE TO FIX THE ISSUE. I WAS TOLD THAT JEEP HAD NO RECORDS OF CYLINDER HEADS CRACKING. A REPLACEMENT HEAD HAS BEEN INSTALLED BUT THE OIL PRESSURE IS LOW DUE TO THE EXCESSIVE BEARING WEAR CAUSE BY COOLANT IN THE OIL. *TR

TL* THE CONTACT OWNS A 2000 JEEP WRANGLER. WHILE DRIVING APPROXIMATELY 65 MPH, THE FRONT END OF THE VEHICLE SHUDDERED VIOLENTLY. AN INDEPENDENT MECHANIC STATED THAT BOTH FRONT STEERING MOUNTS WERE RUSTED AND NEEDED TO BE REPLACED. THE VEHICLE WAS NOT REPAIRED. THE MANUFACTURER WAS NOT NOTIFIED OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 193,000.

TL* THE CONTACT OWNS A 2000 JEEP WRANGLER. THE CONTACT STATED THAT THE FRAME THAT COVERED THE TRANSMISSION WAS COMPLETELY CORRODED AND THE SCREWS WERE COMING UNDONE. THE VEHICLE WAS TAKEN TO AN INDEPENDENT MECHANIC. THE TECHNICIAN RECOMMENDED FOR THE FRAME TO BE REPAIRED. THE VEHICLE WAS REPAIRED. THE MANUFACTURED WAS MADE AWARE OF THE FAILURE. THE APPROXIMATE FAILURE MILEAGE WAS 130,000.