2020 Jeep Gladiator

The instrument panel cluster (IPC) failed. The speedometer, fuel gauge, and other driver information displays no longer function. The vehicle and failed instrument cluster are available for inspection upon request. The failure resulted in loss of critical driving information, including vehicle speed and fuel level. This creates a safety risk because I cannot accurately monitor speed, receive warning indicators, or assess vehicle operating conditions while driving. The issue has been diagnosed by ASE certified shop No warning lamps or messages were displayed prior to the failure. The instrument cluster failed suddenly and without warning.

The contact owns a 2020 Jeep Gladiator. The contact stated that while driving at various speeds, the messages "Gear Shift Reset", and "Loss of Stability Control" were displayed, and the check engine warning light, the brake system warning light and other unknown warning lights were illuminated. Additionally, the power steering feature suddenly failed to operate as designed. The vehicle was taken to the dealer, where it was diagnosed and determined that a wiring harness needed to be replaced. The vehicle was not repaired by the dealer; however, the contact completed the repair himself. The manufacturer was not informed of the failure. The failure mileage was approximately 100,000.

I am submitting a complaint regarding my 2020 Jeep Gladiator, which has exhibited persistent and dangerous steering issues since shortly after I purchased it. The issue is commonly referred to as the "death wobble." Despite 5 separate repair attempts performed by an authorized Jeep/Stellantis dealership, the safety defect continues to occur. This issue is very commonly know to Jeep. I have even been told my the Service Agent I worked with at the dealership that the steering damper is known to be inadequate, but still continually put on the Jeep. The issue started at approximately 25,000 miles, and upon the 5th time bringing it in for the same safety defect, the car is at 92,000 miles. At highway speeds, if the vehicle hits any uneven pavement, the car will begin to shack violently and the vehicle becomes difficult to control. On multiple occasions, the vehicle felt uncontrollable. This creates an extremely unsafe driving condition for me, my family, and other drivers on the road. I have to be hyper focused to avoid any pothole or other change in pavement in order to try and prevent the steering defect to happen. Even when the steering damper has been replaced, the new one can break at any point again, creating a danger every time this vehicle is driven on the highway. I have opened a formal complaint with Jeep as I can no longer use the vehicle in good conscious with my 4-month old daughter. The defect-steering damper breaking can happen anytime, as the exact same part is replaced each time with no successful remedy. I am asking the NHTSA to investigate the steering defect, determine whether a broader safety recall is necessary, assist in compelling Stellantis to provide an appropriate remedy for a vehicle that has undergone multiple unsuccessful repair attempts for a safety-critical defect. I have included all service documents and my communication with Jeep/Stellantis.

The digital instrument cluster in my 2020 Jeep Gladiator has failed. The center display (LCD) went completely black, even though the backlight still glows faintly. This screen typically displays critical information such as vehicle speed, warnings, messages, and alerts. Without this display, I cannot monitor key safety information while driving. The analog gauges still function, but the central digital panel remains blank regardless of ignition mode (RUN or ON). After diagnosing the issue myself, I confirmed power was present at the fuse terminals. I inspected and replaced fuse F36, which was damaged and likely contributed to the display losing power or shorting. I also inspected related fuses F43 and F57 (BCM and IOD power supply), which were intact. This is not an isolated problem. Research shows that other Jeep Gladiator owners (especially 2020 models) are experiencing identical symptoms — black instrument displays, “Push Brake to Start” messages that stay on after shutdown, and modules not entering proper sleep mode. These issues align with the symptoms listed in TSB 08-002-21A, which relates to software and communication faults between the BCM and IPC. Jeep dealership confirmed the failure and quoted $700–$1,000 for full cluster replacement, stating there are no DTC codes and no reflash updates available, and that the cluster must be replaced outright. Jeep has not issued a recall, yet this is clearly a widespread failure affecting visibility and safety of vehicle operation. The problem poses a safety risk to myself and others. I cannot see alerts or diagnostic messages while driving. If this happened at night or during highway travel, it could increase accident risk. Jeep should issue a recall or warranty coverage extension for the instrument cluster failure in affected 2020 Gladiators.

My vehicle has a 3.6 pentastar engine. Around 75,000 miles the check engine light came on. I took it to the dealership to run diagnostics and find the problem. After completing the diagnostics the service tech informed me that is was an issue related to a TSB 09-011-25. This is a major manufacturing issue that causes engine failure. My engine needs to be replaced. This issue affects many vehicles in the Stellantis lineup and should be a recall. They have not made any effort to inform customers of this issue to have it inspected

The information screen in the instrument cluster between the speedometer and tachometer went blank. Sometimes it will light up blue or even function. The screen is the display for fuel, temperature, odometer, gear selected, etc. From what I have read this happens to many of these vehicles. The fix dealers are using is to use remanufactured parts which are back ordered with no known date of delivery. I am informed the remanufactured part is about $500 not including labor. The vehicle will run and drive, however I won't know how much gas I have, I don't know if the vehicle is overheating, and I don't know how many miles I have traveled without trying to track it. If I want the new part to have an accurate odometer I have to leave it with the dealer for an unknown period of time. This seems potentially unsafe and likely to impact many vehicles given that the part is remanufactured and back ordered. A systemic flaw of this nature seems like something which could warrant a safety recall.

My 2020 Jeep Gladiator has a defective instrument panel screen. This appears identical to the current documented model recall yet Jeep does not include my VIN on the list of recalled vehicles. The current recall number is: NHTSA 24V-652. This presents a serious safety issue and I hope that someone from NHTSA is looking into this.

The instrument panel on my 2020 Jeep Gladiator has gone blank. No water temp, no oil pressure, no odometer, no gas gauge (VIN [XXX] ). This is 2nd complaint form. I realize gov shutdown has effected the process but 2 days after report 1st I saw an article that said NHSTA had opened investigation on this problem. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)