2018 Jeep Compass

The Uconnect System on my 2018 Jeep Compass (19,995 miles) is failing/malfunctioning and the Stop/Start Technology has stopped working. Yes, it is available for inspection. After replacing the main battery, my UConnect system stopped functioning properly. It no longer receives a GPS signal rendering the navigation system useless along with the stolen vehicle assistance. Separate from that issue, the screen on my UConnect system is delaminating, which is a bubble that's formed underneath the outer layer. The delamination extends the entire width of the screen on top and covers the area where the time is displayed. This is causing the system to continually flash "Do you want to adjust your clock settings?" and makes a beeping sound every time it flashes. Just like when someone presses on the touch screen. Nothing stops it and it's very distracting. UConnect is the "brains" of the car and controls not only the time, but also navigation, phone, electronic power (heat) to seats & steering wheel, climate, backup camera, and SOS. The screen will continue to delaminate more and cause more system malfunctions and even greater distractions. I have not taken my car to a dealership to get an "official" diagnosis. However, after searching online, I've found that numerous other Chrysler, Jeep, Dodge & Fiat owners are having the same issues with satellite failure after new battery install and delaminating Uconnect screens causing distracting screen notifications. The only warning light displayed is for the Start/Stop malfunction.

Jeep stalls while driving. Brake pedal becomes stiff and car will not start. Happens in the middle of the highway sometimes. It also will do this when I come to a complete stop. I have caused traffic interference and almost caused an accident. Sometimes I am able to get it started again after 10-15 minutes, sometimes I need to call a tow truck. The dealership said that it was the batteries in my key fab so they replaced them and it continued to happen. When researching online, I see that a lot of people have this issue and Chrysler has not responded to anyone.

The contact owns a 2018 Jeep Compass. The contact stated while stopped at a stop light, the vehicle turned off and the Start/Stop system warning light illuminated. The contact disconnected the battery and then reconnected the battery and the vehicle started operating normally. The vehicle was taken to the dealer and the second battery was replaced; however, the failure reoccurred. The manufacturer was contacted and a case was filed. The approximate failure mileage was 57,000.

The contact owns a 2018 Jeep Compass. The contact stated while driving 70 MPH, the parking brake independently activated. The contact stated no warning light was illuminated. The contact stated that she turned off the vehicle and deactivated the parking brake to continue driving to her destination. The contact's daughter also experienced the failure three times while driving. The contact called the local dealer and made them aware of the failure. The vehicle was not diagnosed or repaired. The manufacturer had not been informed of the failure. The failure mileage was approximately 139,000.

I was sitting at a stop light when the start/stop system fault warning indicator light came on. My vehicle cut off unbeknownst to me. Was unable to drive once the light changed. I had to activate my hazard lights so I could try to restart my vehicle. During the first try the vehicle did not restart it just stalled, however, it restarted during the second try. The start/stop system warning indicator light did not cut off and the light stayed illuminated. at . This was very scary and unsafe because I was at a traffic light at the bottom of an hill and it was raining which could been a high risk for an accident. I immediately called the dealership and scheduled an appointment for service.

The vehicle’s touchscreen display has begun delaminating, causing “phantom touches” where the screen starts behaving erratically, as if someone were frantically touching multiple controls. This includes launching and closing apps, changing music, activating the phone and calling people, disabling/changing navigation, and more. There is no way to stop this once it starts, leaving the screen erratically changing and becoming extremely distracting while driving. This has nearly lead to several accidents on the road. This has happened several times since August of this year, growing progressively worse and more distracting over time. The system becomes effectively unusable and the degree of distraction when it occurs while on the road has only been increasing. This is a widely known issue with the Uconnect 8.4 model screens installed in Jeep, Dodge and other FAC marque vehicles. FAC refuses to do anything about it, as it tends to happen after the vehicles are past their standard warranty. I have attempted to communicate with them, however they refuse to help in any way and essentially have told me I’m on my own, much as they have with the thousands of others who have reported this issue with their Uconnect 8.4 systems. The issue is rooted in the adhesive used to hold the digitizer to the display, which begins to melt and seep down into the mounting brackets, separating the digitizer from the screen and forming what looks like air bubbles. FAC knows this, yet refuses to accept any responsibility.

The navigation/backup camera screen is going out. I cannot see when reversing, navigating, or any other function of the screen. This is a risk because I cannot use the backup camera properly to see cross traffic or other obstructions, such as children or pets. This started occurring in July 2022. When attempting to take it to the dealership in Roseville, CA, the service personnel told me I would have to replace the entire screen, and it would cost roughly $1,500. This was without him even having a technician looking at the vehicle.

The vehicle has a backup camera that works intermittently, but frequently shows either a black screen or a frozen image. I have scheduled service at the local dealership on two occasions, had to wait at least two weeks both times because the dealership could not work us in quicker. The camera started operating a day or two before the appointment on both occasions, so the dealership didn't do anything but verify that the camera is operating correctly. Note that this problem is recurring, but the intermittent nature has prevented any real diagnosis by the dealership. There are numerous anecdotal stories on the internet regarding this issue, but there does not appear to be any action by the manufacturer. Also, it is hard to get clear pictures of the screen, but I attached two with the hopes that they help. One basically shows the screen while the other shows the indicator is in reverse.