IllustrationWHEN BRAKES WERE APPLIED SLIGHTLY HARDER THAN NORMAL THE VEHICLE JERKED VIOLENTLY TO THE LEFT CROSSING CENTER LINE OF ROADWAY. DRIVER STUGGLED TO PULL IT BACK TO THE RIGHT. THE RIGHT FRONT BRAKES FAILED CAUSING THAT WHEEL TO LOCK UP.
1990 Jaguar Xjs
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Xjs years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 15 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Fuel System, Gasoline. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
1 crash reports2 fire reports0 injury reports
What owners actually said
15 reportsVEHICLE WAS TRAVELING AT 25MPH WHEN ABS WERE APPLIED AND DID NOT FUNCTION. VEHICLE CRASHED INTO BRICK WALL.
VEHICLE VIBRATES TO THE POINT THAT IT CANNOT BE DRIVEN AND HAS BEEN UNABLE TO BE REPAIRED.
PIRELLI TIRE BLEW OUT AT SIDEWALL WHILE IN SPARE TIRE COMPARTMENT, CAUSING ACCIDENT/LOSS OF CONTROL. *SD
NOISY DIFFERENTIAL. *TW
Official recalls
392V009000 · Electrical System:ignition
Jan 23, 1992
THE HIGH TENSION LEAD FROM THE IGNITION COIL CAN MOVE FROM THE PRODUCTION LOCATION CLOSER TO THE #4A FUEL INJECTOR HOSE. THIS COULD LEAD TO THE OUTER AND INNER INJECTOR HOSES CRACKING OR SPLITTING FROM OZONE DETERIORATION.
Consequence & remedy
Consequence: SPLITTING OF THE INJECTOR HOSES WOULD CAUSE EXPULSION OFFUEL IN THE ENGINE COMPARTMENT AND RESULT IN A FIRE WHEN EXPOSED TO A SOURCE OFIGNITION.
Remedy: REPLACE THE HIGH TENSION LEADS WITH SHORTER HIGH TENSION LEADS. REPLACE BOTH THE FUEL INJECTOR AND THE #4A FUEL INJECTOR HOSE AS NECESSARY.
90V123000 · Fuel System, Gasoline:storage:tank Assembly
Jul 2, 1990
EXCESSIVE FUEL VAPOR PRESSURE CAN OCCUR THAT, AFTER PROLONGED CYCLING, COULD WEAKEN THE FUEL TANK STRUCTURE.
Consequence & remedy
Consequence: THIS CAN CAUSE FUEL TANK LEAKS WHICH, IN THE PRESENCE OFAN IGNITION SOURCE, COULD RESULT IN A VEHICLE FIRE.
Remedy: INSTALL A REVISED FUEL PURGE SYSTEM WHICH ELIMINATES EXCESSIVE VAPOR PRESSURE BUILD-UP.
90V035000 · Vehicle Speed Control
Feb 20, 1990
ELECTRONICALLY CONTROLLED VALVES IN THE CRUISE CONTROL ACTUATOR MAY NOT FUNCTION PROPERLY DUE TO DIRT ENTERING THE VALVES.
Consequence & remedy
Consequence: CRUISE CONTROL WOULD NOT DISENGAGE UNDER NORMAL OPERATINGCONDITIONS WHICH COULD RESULT IN LOSS OF CONTROL AND AN ACCIDENT.
Remedy: REPLACE CRUISE CONTROL ACTUATOR AND INSTALL ADDITIONAL VACUUM DUMP VALVE.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
1PE93042 · Passive Restraint Failure
Opened May 4, 1993 · Closed Nov 4, 1993
Status: closed (inferred from source dates) · Seat Belts
There is no summary currently available