Engine And Engine Cooling. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Power Train. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Steering. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

2 crash reports2 fire reports1 injury reports

Structure complaints

1 reports

Clear category filter

119,037 miles · Aug 3, 2005

SteeringStructure

1987 HYUNDAI EXCEL HAS A BROKEN MOTOR MOUNT AND BOTH CROSSMEMBERS ARE BENT.*MR THE CONSUMER BELIEVES THE VEHICLE WAS POORLY WELDED ON THE RIGHT SIDE OF THE SUBFRAME. THE COVER SUPPORT BENT. THE RACK AND PINION LEAKED. THE UPPER TIE BAR BENT. *NM

NHTSA ODI #10132401

Official recalls

93V167000 · Power Train:manual Transmission

Oct 4, 1993

THE MANUAL TRANSMISSIONS MAY LOCK UP FROM INSUFFICIENT LUBRICATION OF THE GEARS IN THE TRANSMISSION CASE. THIS CAN CAUSE THE DRIVE WHEELS TO SEIZE AND THE VEHICLE TO COME TO A SUDDEN STOP.

Consequence & remedy

Consequence: SUDDEN STOPS WITHOUT PRIOR WARNING CAN CAUSE VEHICLEOCCUPANTS TO BE THROWN AROUND IN THE CAR, AND CAUSE LOSS OF VEHICLE CONTROLWHICH COULD RESULT IN AN ACCIDENT.

Remedy: HYUNDAI WILL PERFORM A COST FREE TRANSMISSION OIL CHANGE.

91V225000 · Engine And Engine Cooling:exhaust System

Dec 31, 1991

DETERIORATION OF THE REED VALVE SUBASSEMBLY MAY LEAD TO A MALFUNCTION WITHIN THE SECONDARY AIR SUPPLY PORTION OF THE EMISSION CONTROL SYSTEM. THE SCREWS WHICH ATTACH THE REEDS TO THE REED VALVE SUBASSEMBLY MAY RUST, AND IF THE RUSTING BECOMES SEVERE, THE SCREW HEADS WILL ERODE AND ALLOW THE REEDS TO SEPARATE FROM THE REED VALVE SUBASSEMBLY. CORROSION MAY ALSO OCCUR ON THE REED VALVE SUBASSEMBLY, DEFORMING THE REED SEATS AND PREVENTING THE REEDS FROM CLOSING PROPERLY. SEPARATION OF THE REEDS FROM THE REED VALVE SUBASSEMBLY OR IMPROPER CLOSING OF THE REEDS ALLOW HOT EXHAUST GASES TO FLOW BACKWARD INTO THE PLASTIC SECONDARY AIR FILTER CASE WHEN THE VEHICLE IS BEING DRIVEN. THESE HOT EXHAUST GASES MAY MELT THE SECONDARY PLASTIC AIR FILTER CASE.

Consequence & remedy

Consequence: THE MELTING PLASTIC AIR FILTER CASE MAY LEAD TO A FIREIN THE ENGINE COMPARTMENT.

Remedy: REPLACE THE REED VALVE SUBASSEMBLY WITH ONE WHOSE METAL COMPONENTS ARE FABRICATED FROM CORROSION RESISTANT STAINLESS STEEL.

89V100000 · Vehicle Speed Control

Jun 19, 1989

IF CRUISE CONTROL MAIN SWITCH IS IN THE ON POSITION WHEN ENGINE IS STARTED, SYSTEM CAN BE AFFECTED BY A SHORT DURATION VOLTAGE DROP CAUSED BY OPTIONAL HI-POWER (H340) RADIO.

Consequence & remedy

Consequence: THIS COULD CAUSE ERRATIC CRUISE CONTROL OPERATION, WHICHCOULD RESULT IN AN ACCIDENT.

Remedy: REPLACE ELECTRONIC CONTROL MODULE.

87V180000 · Service Brakes, Hydraulic:foundation Components:disc:pads

Nov 25, 1987

VEHICLE MAY FAIL TO CONFORM TO THE BRAKE FADE AND RECOVERY PORTION OF FMVSS 105.

Consequence & remedy

Consequence: THERE MAY BE A LOSS OF BRAKING EFFICIENCY DURINGREPEATED HARD APPLICATION OF BRAKES WHICH COULD RESULT IN A CRASH WITHOUT PRIORWARNING.

Remedy: REPLACE FRONT BRAKE PADS WITH NEWLY DESIGNED SEMI METALLIC BRAKE PADS.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗