Counts are not failure probabilities and are not adjusted for sales, age, mileage exposure or reporting. One report may name several categories. Comparison method and limitations.
I am writing to report a serious tire failure incident involving a Hankook tire that came with my brand-new 2023 Honda HR-V. While driving recently — with approximately 16,500 miles on the vehicle — the rear tire suddenly blew out without any prior warning. Fortunately, I was able to maintain control and safely stop the vehicle …
Read full complaint
I am writing to report a serious tire failure incident involving a Hankook tire that came with my brand-new 2023 Honda HR-V. While driving recently — with approximately 16,500 miles on the vehicle — the rear tire suddenly blew out without any prior warning. Fortunately, I was able to maintain control and safely stop the vehicle without harm to myself or others. There were no signs or alerts from the vehicle’s tire pressure monitoring system (TPMS) before or during the blowout. Strangely, the TPMS warning light only came on after I replaced the damaged tire with the spare, which raises concerns about the effectiveness or response delay of the TPMS. I would like to highlight: Tire size : 215/60R17 •The tire had no visible damage or issues before the blowout, and I follow routine servicing through my dealership. •As a result of the incident, the rear wheel drum has a very minor bend. •Unfortunately, the damaged tire is no longer in my possession ( I have changed it), but I do have clear photographs taken immediately after the incident, which I can share upon request. •The issue has not yet been evaluated by a dealer or third party, but I am open to doing so if needed. This unexpected failure poses a significant safety concern, and I believe it deserves further investigation to ensure no broader defect or issue exists.
NHTSA ODI #11678923
Mileage unknown · Jul 24, 2023
Tires
225 / 55R18 Bought new 2023 Honda HRV Tires need replaced at 31,000 miles tread is gone. All Honda required tire rotation completed at dealership
Honda (American Honda Motor Co.) is recalling certain 2023-2025 Acura Integra, Civic Type R, CR-V Hybrid, CR-V, HR-V, 2022-2025 Civic, Civic Hatchback, 2024-2025 Acura Integra Type S, 2025 CR-V Fuel Cell EV, Civic Hybrid, and Civic Hatchback Hybrid vehicles. The steering gearbox assembly may have been manufactured incorrectly, which can cause excessive internal friction and lead to difficulty steering the vehicle.
Consequence & remedy
Consequence: Difficulty steering can increase the risk of a crash.
Remedy: Dealers will replace the worm gear spring and redistribute or add grease as necessary, free of charge. Owner notification letters were mailed November 18, 2024. Owners may contact Honda Customer Service at 1-888-234-2138. Honda's numbers for this recall are SJS, MJU, QJT and VJV.
Honda (American Honda Motor Co.) is recalling certain 2013-2023 Honda Accord, Civic Coupe, Civic Sedan, Civic Hatchback, Civic Type R, CR-V, HR-V, Ridgeline, Odyssey, Acura ILX, MDX, MDX Hybrid, RDX, RLX, TLX, 2019-2022 Honda Insight, Passport, 2020 Honda CR-V Hybrid, 2018-2019 Honda Clarity PHEV, Fit, and 2015-2020 Honda Accord Hybrid, Pilot, Acura NSX vehicles. The fuel pump inside the fuel tank may fail.
Consequence & remedy
Consequence: Fuel pump failure can cause an engine stall while driving, increasing the risk of a crash.
Remedy: Dealers will replace the fuel pump module, free of charge. Owner letters were mailed September 6, 2024. Owners may contact Honda customer service at 1-888-234-2138. Honda's numbers for this recall are KGC and KGD. This recall is an expansion of NHTSA recall numbers 21V-215 and 20V-314.
Honda (American Honda Motor Co.) is recalling certain 2023-2024 Accord and HR-V vehicles. The front seat belt pretensioners may be missing the rivet that secures the quick connector and wire plate. As such, these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard numbers 208, "Occupant Crash Protection," 209, "Seat Belt Assembles," and 210, "Seat Belt Assembly Anchorages."
Consequence & remedy
Consequence: A seat belt pretensioner missing a rivet will not properly restrain the occupant, increasing the risk of injury during a crash.
Remedy: Dealers will inspect and replace the seat belt pretensioner assemblies as necessary, free of charge. Owner notification letters were mailed January 8, 2024. Owners may contact Honda customer service at 1-888-234-2138. Honda's numbers for this recall are MG7 and NG5.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
Defect investigations
1
RQ24006 · Front Seat Belt Assemblies May Be Missing The Rivet That Secures The Quick Connector And Wire Plate
On April 4, 2024, the Office of Defects Investigations (ODI) opened RQ24006 to investigate American Honda Motor Co.’s (Honda’s) proposed remedy for recall 23V-782 as well as scope of the vehicles involved. Honda issued recall 23V-782 on November 21, 2023, which concerns certain model year (MY) 2023-2024 Honda Accord, Honda Accord Hybrid, and Honda HR-V vehicles. Recall 23V-782 states that the driver and front passenger seat belt pretensioner assemblies may have been manufactured without a rivet that secures the pretensioner quick connector and wire plate. Recall documentation states that seat belt pretensioner assemblies that are missing the rivet will not properly restrain the occupant in the event of a collision, increasing the risk of injury.Subject defective seat belt assemblies are installed as original equipment for both the driver and front passenger positions for the HR-V, but only for the driver position for the Accord and Accord Hybrid. The recall remedy for 23V-782 instructs the technician to inspect both front seat belt pretensioner assemblies and, if necessary, replace them. The inspection procedure requires the technician to utilize a pull force gauge to determine whether the subject component is missing the subject rivet and requires replacement. Parts requiring replacement are determined by whether the pretensioner quick connector separates from the pretensioner assembly while the technician is pulling on the seat belt. If no separation occurs, then the part is determined to be not defective and not require replacement. There have been no reports alleging a failure of seat belt pretensioner assemblies after the inspect and replace remedy for recall 23V-782 was performed. Additionally, no comparable failures have been observed in field data for similar vehicles outside of the scope of the recall. As of the 4th quarter of 2024, the recall completion rate is at approximately 84% of the total recalled population. In view of the lack of failures after the remedy for recall 23V-782 was performed, and the lack of failures in similar vehicles outside of the scope of the recall, ODI is closing this Recall Query (RQ). The Agency reserves the right to take additional action if warranted by future circumstances.
Additional source detail variants (2)
Seat Belts:front
On April 4, 2024, the Office of Defects Investigations (ODI) opened RQ24006 to investigate American Honda Motor Co.’s (Honda’s) proposed remedy for recall 23V-782 as well as scope of the vehicles involved. Honda issued recall 23V-782 on November 21, 2023, which concerns certain model year (MY) 2023-2024 Honda Accord, Honda Accord Hybrid, and Honda HR-V vehicles. Recall 23V-782 states that the driver and front passenger seat belt pretensioner assemblies may have been manufactured without a rivet that secures the pretensioner quick connector and wire plate. Recall documentation states that seat belt pretensioner assemblies that are missing the rivet will not properly restrain the occupant in the event of a collision, increasing the risk of injury.Subject defective seat belt assemblies are installed as original equipment for both the driver and front passenger positions for the HR-V, but only for the driver position for the Accord and Accord Hybrid. The recall remedy for 23V-782 instructs the technician to inspect both front seat belt pretensioner assemblies and, if necessary, replace them. The inspection procedure requires the technician to utilize a pull force gauge to determine whether the subject component is missing the subject rivet and requires replacement. Parts requiring replacement are determined by whether the pretensioner quick connector separates from the pretensioner assembly while the technician is pulling on the seat belt. If no separation occurs, then the part is determined to be not defective and not require replacement. There have been no reports alleging a failure of seat belt pretensioner assemblies after the inspect and replace remedy for recall 23V-782 was performed. Additionally, no comparable failures have been observed in field data for similar vehicles outside of the scope of the recall. As of the 4th quarter of 2024, the recall completion rate is at approximately 84% of the total recalled population. In view of the lack of failures after the remedy for recall 23V-782 was performed, and the lack of failures in similar vehicles outside of the scope of the recall, ODI is closing this Recall Query (RQ). The Agency reserves the right to take additional action if warranted by future circumstances.
Seat Belts
On April 4, 2024, the Office of Defects Investigations (ODI) opened RQ24006 to investigate American Honda Motor Co.’s (Honda’s) proposed remedy for recall 23V-782 as well as scope of the vehicles involved. Honda issued recall 23V-782 on November 21, 2023, which concerns certain model year (MY) 2023-2024 Honda Accord, Honda Accord Hybrid, and Honda HR-V vehicles. Recall 23V-782 states that the driver and front passenger seat belt pretensioner assemblies may have been manufactured without a rivet that secures the pretensioner quick connector and wire plate. Recall documentation states that seat belt pretensioner assemblies that are missing the rivet will not properly restrain the occupant in the event of a collision, increasing the risk of injury.Subject defective seat belt assemblies are installed as original equipment for both the driver and front passenger positions for the HR-V, but only for the driver position for the Accord and Accord Hybrid. The recall remedy for 23V-782 instructs the technician to inspect both front seat belt pretensioner assemblies and, if necessary, replace them. The inspection procedure requires the technician to utilize a pull force gauge to determine whether the subject component is missing the subject rivet and requires replacement. Parts requiring replacement are determined by whether the pretensioner quick connector separates from the pretensioner assembly while the technician is pulling on the seat belt. If no separation occurs, then the part is determined to be not defective and not require replacement. There have been no reports alleging a failure of seat belt pretensioner assemblies after the inspect and replace remedy for recall 23V-782 was performed. Additionally, no comparable failures have been observed in field data for similar vehicles outside of the scope of the recall. As of the 4th quarter of 2024, the recall completion rate is at approximately 84% of the total recalled population. In view of the lack of failures after the remedy for recall 23V-782 was performed, and the lack of failures in similar vehicles outside of the scope of the recall, ODI is closing this Recall Query (RQ). The Agency reserves the right to take additional action if warranted by future circumstances.
An investigation is not a finding of a defect, and closure does not prove a vehicle is problem-free.
Illustration