HJC SYMAX II MODULAR HELMET COMPLAINT BOTH MY FRIEND AND I, [XXX] (WITNESS), BOTH RIDING 30 YEARS, WERE TRAVELING.ON THE BLUE RIDGE PKWY ENTERING THE PARKWAY AT WAYNESBORO, VA TO AVOID THE SKYLINE DRIVE. AROUND 7:15 WE DECIDED TO HEAD TO ROANOKE WHERE WE WOULD HAVE CELL AND INTERNET. HEADED SOUTH ON BRP. I HAS EXPRESS…
Read full complaint
HJC SYMAX II MODULAR HELMET COMPLAINT BOTH MY FRIEND AND I, [XXX] (WITNESS), BOTH RIDING 30 YEARS, WERE TRAVELING.ON THE BLUE RIDGE PKWY ENTERING THE PARKWAY AT WAYNESBORO, VA TO AVOID THE SKYLINE DRIVE. AROUND 7:15 WE DECIDED TO HEAD TO ROANOKE WHERE WE WOULD HAVE CELL AND INTERNET. HEADED SOUTH ON BRP. I HAS EXPRESSED CONCERNS ABOUT DEER. APPROX 5 MINUTES LATER, DEER RAN ACROSS THE ROAD FORCING BOTH OF US TO BRAKE HEAVILY. APPROX 5 MINUTES LATER, SEVERAL MORE DEER RAN ACROSS THE ROAD IN FRONT OF ME. 2 COMPLETED THE CROSSING A 3RD REVERSED DIRECTION. 5 MINUTES LATER AS WE APPROACHED (SOUTHBOUND) AN OVERLOOK, 3 MORE DEER DASHED ACROSS THE ROAD FROM THE LEFT. AS BEST I CAN REMEMBER THEY WERE ADOLESCENCE. ONE PASSED IN FRONT OF MY GOLDWING, POSSIBLY CLIPPING HIS FRONT WHEEL AND DESTABILIZING HIM. A SECOND PASSED BEHIND, AND THE THIRD SLAMMED INTO THE SIDE OF THE BIKE. I WAS EJECTED FROM THE BIKE ON THE RIGHT SIDE. I BARREL-ROLLED TO THE RIGHT ONTO THE GRASS SHOULDER. THE JAW PROTECTOR FROM HIS CONVERTIBLE FULL FACE HELMET HAD BROKEN OFF HIS HELMET (HJC SYMAX II (AN APPARENT HELMET FAILURE). THOUGH THE BRACKET WAS STILL FULLY INTACT, THE RIGHT SIDE PLASTIC ATTACHMENT POINT TO THE 3/4 FACE HELMET BROKE OFF LEAVING ME WITH JUST A 3/4 FACE HELMET FOR 9 OF 10 ROLLS ON THE PAVEMENT. IF IS CLEAR THAT THE SYMAX II FAILURE RESULTED IN ME ROLLING FROM THE 2ND TO THE 10TH ROLL AS IF I WAS WEARING A 3/4 FACE HELMET. I WAS TOTALLY UNPROTECTED EXCEPT FOR A HOOD. THIS HELMET IS UNSAFE AND SHOULD BE VOLUNTARILY RECALLED BY HJC AND REPLACED WITH AT LEAST A SYMAX III, AT A MINIMUM, WHICH HAS A BOLT ATTACHING THE PLASTIC MALFUNCTIONED PIECE GOING THROUGH IT TO ENSURE THAT THIS DOES NOT HAPPEN. WEARING THE RIGHT GEAR, ALL THE TIME IS ESSENTIAL AND THE HJC SYMAX II IS NOT SAFE. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR
American Honda Motor Co., Inc. (Honda) is recalling certain model year 2001-2010 and 2012-2015 GL1800, 2001-2005 GL1800A and 2013-2015 GL1800B motorcycles. The rear brakes of the affected motorcycles may drag after the brakes are released.
Consequence & remedy
Consequence: A rear brake that drags may increase the risk of a vehicle crash. Additionally, extended riding with the rear brake dragging could generate enough heat to result in a fire.
Remedy: Honda will notify owners, and dealers will replace the secondary brake master cylinder and the rear brake master cylinder, and flush the brake fluid, free of charge. The recall began on December 7, 2015. Owners may contact Honda customer service at 1-866-784-1870. Honda's number for this recall is JV6. Note: This recall supercedes recall 14V-472.
HONDA IS RECALLING CERTAIN MODEL YEAR 2001-2010, AND MODEL YEAR 2012 GL1800 GOLDWING MOTORCYCLES. UNDER CERTAIN CONDITIONS, THERE IS A POSSIBILITY THAT THE COMBINED BRAKING SYSTEM'S SECONDARY MASTER CYLINDER MAY CAUSE THE REAR BRAKE TO DRAG.
Consequence & remedy
Consequence: UNEXPECTED BRAKING INCREASES THE RISK OF A CRASH, AND RIDING THE MOTORCYCLE WITH THE REAR BRAKE DRAGGING MAY GENERATE ENOUGH HEAT TO CAUSE THE REAR BRAKE TO CATCH FIRE.
Remedy: HONDA WILL NOTIFY OWNERS, AND DEALERS WILL INSPECT THE SECONDARY MASTER CYLINDER AND IF NECESSARY, REPLACE IT, FREE OF CHARGE. THE SAFETY RECALL BEGAN ON JANUARY 6, 2012. OWNERS MAY CONTACT HONDA CUSTOMER SERVICE AT 1-866-784-1870.
ON SOME MOTORCYCLES, CERTAIN FRAME WELDS DO NOT MEET MANUFACTURING SPECIFICATIONS. HIGH LOADS CREATED WHEN RIDING ON ROUGH ROAD SURFACES OR THROUGH POTHOLES CAN CAUSE THE AFFECTED WELDS TO CRACK.
Consequence & remedy
Consequence: THE WELDED AREA COULD BREAK, RESULTING IN REAR SUSPENSION COLLAPSE OR LOWER CROSS MEMBER SEPARATION, INCREASING THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REINFORCE THE WELDS ON 2001-2002 MOTORCYCLES FREE OF CHARGE. ON 2003-2004 MOTORCYCLES, THE UNITS WILL BE REPAIRED, NO INSPECTION WILL BE NECESSARY. THE RECALL BEGAN ON FEBRUARY 9, 2005. OWNERS MAY CONTACT HONDA AT 1-866-784-1870.
CERTAIN MOTORCYCLES EQUIPPED WITH COMBINED-BRAKE SYSTEMS HAVE A PROPORTIONING CONTROL VALVE (PCV) THAT MECHANICALLY PROPORTIONS BRAKE FORCE WHEN THE REAR BRAKE IS APPLIED. A SEAL IN SOME PCVS IS IMPROPERLY SHAPED, AND BRAKE FLUID LEAKAGE MAY OCCUR.
Consequence & remedy
Consequence: IF THE MOTORCYCLE CONTINUES TO BE USED AFTER A LEAK OCCURS, THE REAR BRAKE WOULD EVENTUALLY BECOME INOPERATIVE. A LOSS OF REAR BRAKE FORCE COULD INCREASE THE RISK OF A CRASH.
Remedy: DEALERS WILL INSPECT THE REAR BRAKE FORLEAKAGE. IF LEAKAGE IS CONFIRMED, THE DEALER WILL REPLACE THE PCV FREE OF CHARGE. THE RECALL BEGAN ON JANUARY 31, 2005. OWNERS MAY CONTACT HONDA AT 866-784-1870.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
AQ12001 · Southern Honda Powersports
Opened May 14, 2012 · Closed May 13, 2013
Status: closed (inferred from source dates) · Unknown Or Other
NHTSA opened Audit Query (AQ) 12-001 to determine whether Southern Honda Powersports (Southern Honda) of Chattanooga, Tennessee, had complied with the requirements of the National Traffic and Motor Vehicle Safety Act, as amended, 49 U.S.C. Chapter 301 (Safety Act) and its implementing regulations. The Safety Act requires, among other things, that a motor vehicle or equipment manufacturer notify its dealers of defects related to motor vehicle safety and non-compliances with federal motor vehicle safety standards.In turn, a dealer may not sell and deliver a new vehicle subject to a recall unless the recall remedy has been performed.(see 49 U.S.C. 30120(i); 49 C.F.R. 573.11)NHTSA issued an information request to Southern Honda on May 14, 2012 to which they responded on July 6, 2012.NHTSA?s inquiry led it to believe that Southern Honda had failed to complete the requirements of five recalls that required inspections and/or repairs of motorcycles prior to their sale or delivery.NHTSA believes that 329 motorcycles affected by recalls had not been inspected and/or repaired prior to their sale and delivery between 2007 and 2012.The agency is unaware of any deaths or injuries involving these vehicles.NHTSA concluded that it had a potential civil penalty claim against Southern Honda for violations of the Safety Act.Southern Honda denied any violations of the Safety Act.In order to settle this matter, Southern Honda agreed to pay a civil penalty in the amount of $125,000, to be paid in five annual installments.This AQ is closed.
RQ04009 · Frame Crossmemeber Weld Failures
Opened Sep 21, 2004 · Closed Feb 2, 2005
Status: closed (inferred from source dates) · Structure:frame And Members
HONDA IS AMENDING THE SCOPE OF 03V-350 TO ADD 34,919 POTENTIALLY AFFECTED GL1800 GOLD WING MOTORCYCLES.THE INITIAL RECALL RANGE INCLUDED FRAMES MANUFACTURED WITH ONE OF A NUMBER OF WELDING PROCESSES.HONDA BELIEVED, ON THE BASIS OF DATA AVAILABLE AT THAT TIME, THAT ONLY THOSE GL'S BUILT WITH THAT ONE PROCESS WERE AT RISK OF FAILURE.WITH THE ORIGINAL RECALL (IN SEPTEMBER, 2003), HONDA INTRODUCED YET ANOTHER WELD PROCESS.SUBSEQUENTLY, HONDA BECAME AWARE OF INCIDENTS INVOLVING GL'S NOT INCLUDED IN THE ORIGINAL RECALL, BUILT USING ANOTHER EARLY WELDING PROCESS.THUS, HONDA HAS DECIDED TO RECALL ALL GL1800'S BUILT PRIOR TO SEPTEMBER 20, 2003 REGARDLESS OF WHAT WELD PROCESS WAS BEING USED AT THE TIME.THIS RECALL EXPANSION AFFECTS THE 2001, 2002, 2003 AND 2004 MODEL YEARS AND THE TOTAL NUMBER OF AFFECTED U.S. GL1800 MOTORCYCLES INCREASES FROM 8,196 TO 43,115.
2004 Honda GL1800 Problems, Complaints & Recalls | Skip That Year
Illustration