Hino is recalling certain model year 2005 through 2013 medium duty trucks, models NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, NF8J, and NV8J, manufactured from August 18, 2003, through November 16, 2011. Over time, the main B+ circuit from the battery to the starter could potentially short to ground due to wear that accumulates as a result of interference between the B+ circuit and its convoluted tubing sheath.

Consequence & remedy

Consequence: If the B+ circuit shorts to ground, it may lead to a fire.

Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.

Additional source detail variants (2)

Electrical System:wiring

Consequence: If the B+ circuit shorts to ground, it may lead to a fire.

Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.

Electrical SYSTEM:12V/24V/48V Battery:cables

Consequence: If the B+ circuit shorts to ground, it may lead to a fire.

Remedy: Hino will notify owners, and dealers will repair the vehicles free of charge. The recall began on January 17, 2013. Owners may contact Hino at 1-248-699-9390.

08V195000 · Suspension:front

Apr 30, 2008

HINO IS RECALLING 16,805 MY 2005-2008 NA6J, NB6J, NC6J, ND8J, NE8J, NJ8J, AND NV8J TRUCKS. THE TWO VERTICAL RIGHT/LEFT SIDE FRONT SPRING BRACKET BOLTS WERE NOT TIGHTENED PROPERLY DURING THE ASSEMBLY PROCESS. THIS MAY CAUSE INCREASED STRESS ON THE SPRING BRACKET WHICH CAN LEAD TO CRACKING OF THE BRACKET.

Consequence & remedy

Consequence: THIS COULD REDUCE STEERING CONTROL INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL REPLACE THE VERTICAL FRONT SPRING BRACKET ATTACHMENT BOLTS ON RIGHT/LEFT HANGER BRACKETS AND RE-TORQUE ALL ASSOCIATED BOLTS FREE OF CHARGE. THE RECALL BEGAN ON SEPTEMBER 8, 2008. OWNERS MAY CONTACT HINO AT 248-699-9300.

07V208000 · Engine And Engine Cooling

May 9, 2007

ON CERTAIN TRUCKS EQUIPPED WITH BANDO BELT TENSIONER, CORROSION OR RUST MAY DEVELOP ON THE TENSIONER SPINDLE OR BUSHING CAUSING THE AUTO TENSIONER TO BECOME STIFF OR BIND. THIS CAN CAUSE THE DRIVE BELT TO SUDDENLY COME OFF OR THE AUTO TENSIONER MOUNTING BOLTS COULD SUDDENLY BREAK.

Consequence & remedy

Consequence: IF THE DRIVE BELT COMES OFF, THE ALTERNATOR WARNING LAMP WILL ILLUMINATE. IF THE WARNING IS IGNORED, THIS CONDITION COULD ULTIMATELY RESULT IN A LOSS OF VEHICLE POWER (ENGINE STALL) INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL REPLACE THE AUTO TENSIONER, INSTALL UPGRADED MOUNTING BOLTS, AND REPLACE THE ACCESSORY DRIVE BELT FREE OF CHARGE. THE RECALL BEGAN ON APRIL 25, 2007. OWNERS MAY CONTACT HINO MOTORS AT 248-648-6430. NOTE: THIS RECALL SUPERSEDES A PREVIOUS CAMPAIGN (PLEASE SEE 06V157).

06V169000 · Steering:linkages

May 18, 2006

ON CERTAIN TRUCKS, DURING ASSEMBLY, THE DRAG LINK ATTACHMENT NUTS AT THE PITMAN ARM AND STEERING ARM MAY HAVE BEEN INCORRECTLY TORQUED. RESIDUAL GREASE AND PAINT WHICH WAS APPLIED AS A RUST INHIBITOR ON THE STEERING ARM MAY HAVE CONTRIBUTED TO A LOSS OF TORQUE AFTER ASSEMBLY.

Consequence & remedy

Consequence: INCREASED WEAR FOR THE DRAGLINK CONNECTIONS CAN OCCUR CREATING A NOTICEABLE INCREASE IN THE AMOUNT OF STEERING WHEEL FREE PLAY. IF THIS CONDITION WAS IGNORED, A LOSS OF STEERING CONTROL OF THE VEHICLE COULD OCCUR WHICH COULD RESULT IN A CRASH.

Remedy: DEALERS WILL INSPECT THE STEERING ARM TIGHTNESS AND REMOVE ALL GREASE AND PAINT FROM THE STEERING ARMS AND RETORQUE THE DRAGLINK ATTACHMENT NUTS AT THE STEERING ARM AND PITMAN ARM. THE RECALL BEGAN ON MAY 12, 2006. OWNERS MAY CONTACT HINO AT 1-248-648-6430.

05V240000 · Service Brakes, Air:supply:hoses, Lines/piping, And Fittings

May 25, 2005

ON CERTAIN TRUCK CAB AND CHASSIS VEHICLES, A BRAKE AIR LINE COULD BECOME DISCONNECTED.

Consequence & remedy

Consequence: THIS COULD CAUSE A DECREASE OF BRAKING ABILITY OR THE PARKING BRAKE TO APPLY WITHOUT BEING ACTIVATED, INCREASING THE RISK OF A CRASH.

Remedy: DEALERS WILL INSPECT EACH VEHICLE AND CHECK THE TORQUE ON THE NUTS. IF THE NUTS ARE NOT TORQUED PROPERLY, THEY WILL BE TIGHTENED TO THE PROPER SPECIFICATION. THE RECALL BEGAN ON JUNE 4, 2005. OWNERS MAY CONTACT HINO AT 1-248-648-6400.

04V448000 · Steering

Sep 20, 2004

ON CERTAIN TRUCKS, WHEN THE STEERING WHEEL IS BEING TURNED, THE DUST COVER MAY TWINE WITH THE STEERING SHAFT AND COULD RESULT IN THE STEERING WHEEL OPERATION BECOMING HEAVY.

Consequence & remedy

Consequence: LOSS OF STEERING CONTROL MAY OCCUR, WHICH COULD RESULT IN A CRASH.

Remedy: DEALERS WILL REMOVE THE OLD DUST COVER AND INSTALL A NEWLY DESIGNED COVER. THE RECALL BEGAN OCTOBER 8, 2004. OWNERS SHOULD CONTACT HINO AT 1-845-365-1400.

04V439000 · Vehicle Speed Control:accelerator Pedal

Sep 13, 2004

ON CERTAIN CAB AND CHASSIS TRUCKS, WHEN EXCESSIVE FORCE IS APPLIED TO THE ACCELERATOR PEDAL, BEYOND THAT REQUIRED TO ACHIEVE FULL ACCELERATION, THE PEDAL MAY BECOME WEDGED BETWEEN THE FLOOR PANEL AND THE CARPET.

Consequence & remedy

Consequence: WHEN THIS OCCURS, THE ACCELERATOR PEDAL WILL BECOME WEDGED IN THE FULL THROTTLE POSITION WHICH COULD RESULT IN A CRASH WITHOUT WARNING.

Remedy: DEALERS WILL INSPECT THE ACCELERATOR PEDAL HEIGHT TO DETERMINE IF IT IS WITHIN SPECIFICATIONS. IF EITHER THE PEDAL HEIGHT OR THE ACCELERATOR ROD IS NOT WITHIN SPECIFICATIONS, REPLACE THE ACCELERATOR ASSEMBLY. IN ADDITION, A NEW BRACKET CONTAINING AN ACCELERATOR PEDAL STOPPER WILL BE INSTALLED. THE RECALL BEGAN ON SEPTEMBER 8, 2004. OWNERS SHOULD CONTACT HINO CUSTOMER SERVICE AT 1-845-365-1400.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

No exact-year investigations in this snapshot.