2008 HARLEY-DAVIDSON Fltr

TL* THE CONTACT OWNS A 2008 HARLEY-DAVIDSON ROAD GLIDE (FLTR). WHILE RIDING AT VARIOUS SPEEDS, THE THROTTLE BODY SENSOR FAILED. AS A RESULT, THE VEHICLE STALLED AND LOST POWER WITHOUT WARNING. THE CONTACTED PULLED OVER, RESTARTED THE VEHICLE, AND RESUMED NORMAL RIDING. WHEN THE FAILURE RECURRED, THE CONTACT TOWED THE VEHICLE TO BAER SPORT CENTER HARLEY-DAVIDSON AND POLARIS (330 GRANDVIEW AVE, HONESDALE, PA 18431, (570) 253-2000) WHERE THEY REPLACED THE PLUGS ON THE THROTTLE BODY. THE FAILURE RECURRED. THE CONTACT TOOK THE VEHICLE TO OTHER UNKNOWN HARLEY-DAVIDSON DEALERS TO HAVE THE VEHICLE SERVICED, BUT THE FAILURE PERSISTED EACH TIME. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND REFERRED THE CONTACT TO NHTSA TO FILE A COMPLAINT. THE VEHICLE WAS NOT REPAIRED. THE FAILURE MILEAGE WAS UNKNOWN.

WHILE RIDING ON 3/31/2018 I WAS APPROACHING A STOPLIGHT AND BEGAN MY DOWN SHIFTING AND BRAKING. I STEPPED ON THE REAR BRAKE PEDAL AND TO MY SURPRISE THERE WAS LITTLE RESISTANCE, I PUMPED THE PEDAL AGAIN ONLY TO HAVE THE SAME RESULT. I THEN PUMPED THE PEDAL SEVERAL TIMES NOTING SAME RESULT AS PREVIOUS ATTEMPTS BUT WAS ABLE TO STOP USING MY FRONT BRAKE. WE PULLED OFF INTO A GAS STATION PARKING LOT TO ASSESS THE PROBLEM. UPON INSPECTION, I FOUND ONE OF TWO WIRES (RED) ON THE REAR BRAKELITE SWITCH SENSOR HAD MELTED OFF FROM THE SWITCH AN WAS LYING NEXT TO THE SWITCH SENSOR AND FLUID HAD LEAKED/SPRAYED OUT COVERING THE SURROUNDING AREA. LOOKING MORE CLOSELY, I FOUND THAT THE BRASS TERMINAL POST OF THE SWITCH HAD MELTED OFF THE SWITCH HOUSING AND WAS STILL LODGED WITHIN THE WIRE CONNECTOR. I RECALLED THIS HAPPENING TO A RELATIVE A FEW YEARS AGO AND IN RESEARCHING THE ISSUE THROUGH FORUMS AND GENERAL ONLINE RESEARCH, I FOUND THERE ARE SEVERAL CASES REGARDING THIS PROBLEM AND EVEN A RECALL (HARLEY DAVIDSON RECALL 0145) WHICH ONLY COVERED 2009-2011. THIS SAFETY ISSUE OBVIOUSLY APPLIES TO THE 2008 MODEL FLTRI AS WELL AND SHOULD HAVE BEEN INCLUDED.

TL* THE CONTACT OWNS A 2008 HARLEY-DAVIDSON FLTR. WHILE DRIVING 5-65 MPH, THE REAR BRAKES SEIZED SEVERAL TIMES WITHOUT WARNING. THE VEHICLE WAS TAKEN TO THE DEALER (FORT WORTH HARLEY-DAVIDSON, 3025 W LOOP 820 S, FORT WORTH, TX 76116, (817) 717-4325) FOR DIAGNOSTIC TESTING AND REPAIR. MONTHS LATER, THE CONTACT WAS NOTIFIED OF NHTSA CAMPAIGN NUMBER: 18V076000 (ELECTRONIC STABILITY CONTROL) BY EMAIL. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE AND THE CONTACT CALLED TO DETERMINE THE RECALL SOLUTION TO REPAIR THE MOTORCYCLE. THE APPROXIMATE FAILURE MILEAGE WAS 50,000. *TT *TR

TL* THE CONTACT OWNS A 2008 HARLEY-DAVIDSON FLTR ROAD GLIDE. WHEN THE BRAKE PEDAL WAS DEPRESSED, THE BRAKES FAILED TO STOP THE VEHICLE. THE CONTACT HAD TO APPLY THE EMERGENCY BRAKE TO STOP. THERE WERE NO WARNING INDICATORS ILLUMINATED. THE VEHICLE WAS NOT DIAGNOSED OR REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE, BUT DID NOT OFFER ASSISTANCE. THE FAILURE MILEAGE WAS 50.

TL* THE CONTACT OWNED A 2008 HARLEY-DAVIDSON FLTR ROAD GLIDE. WHILEDRIVING APPROXIMATELY10 MPH, THE BRAKE PEDALWAS DEPRESSED,BUT THE VEHICLE FAILED TO RESPOND WITHOUT WARNING. AS A RESULT,THE CONTACT SIDESWIPED ANOTHER VEHICLE AND CRASHED INTO AN ALUMINUM BRIDGE.A POLICE REPORT WAS FILED. THE CONTACT SUSTAINED INJURIES TO THE LEFT ARM, LEFT FOREARM, LEFT KNEE, AND ANKLES THAT REQUIRED MEDICAL ATTENTION. THE VEHICLE WAS TOWED TO A DEALER, BUT WAS NOT DIAGNOSED OR REPAIRED. THE VEHICLE WAS DESTROYED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 36,000.

THE ABS MODULE ON MY BIKE HAS QUIT WORKING. WITH THE IGNITION ON THE MODULE CLOSES AND THE FRONT BRAKES CANNOT BE APPLIED. IF THIS WERE TO HAPPEN WHILE RIDING, A CRASH WOULD BE INEVITABLE. THE MODULE SHOULD BE DESIGNED SO THAT THERE IS AN EMERGENCY BYPASS IN THE EVENT THE INTERNALS INSIDE THE MODULE BECOMES STUCK SO THAT THE RIDER IS NOT SUDDENLY WITHOUT BRAKES. HARLEY DAVIDSON SHOULD ISSUE AN IMMEDIATE RECALL.

THE PASSENGER FLOORBOARD/FOOTBOARD MOUNTING BOLT IS PRONE TO SHEER OFF. THIS EJECTS THE 10-15 POUND PART FROM THE MOTORCYCLE CAUSING A SERIOUS SAFETY HAZARD. THIS IS A COMMON OCCURRENCE AND EVEN THOUGH THE PART WAS REDESIGNED IN 2010 TO INCLUDE 2 MOUNTING BOLTS THE HARLEY DAVIDSON CORPORATION HAS DENIED THAT THERE IS A PROBLEM WITH THE EARLIER SINGLE MOUNT BOLT DESIGN. *TR

THE REAR BRAKE LIGHT SWITCH FAILED WHILE TRAVELING ON I-85 IN ATLANTA, GA. ON BRAKING TO EXIT THE INTERSTATE THE PEDAL WENT TO THE FULL DOWN POSITION WITH NO EFFECT ON BRAKING. I WAS CLOSE TO WORK AND WHEN I GOT TO WORK, I PRESSED THE PEDAL TO FIGURE OUT WHAT WAS WRONG AND NOTICED A PUDDLE OF FLUID UNDER THE BIKE. WHEN I DEPRESSED THE PEDAL A LARGE AMOUNT OF FLUID STREAMED OUT OF THE AREA WHERE THE PLASTIC PART OF THE SWITCH INSERTS INTO THE METAL HOUSING. ALL OF THE FLUID LEAKED OUT. THERE WERE TWO PUDDLES APPROXIMATELY 8-10 INCHES IN DIAMETER. THE WIRING CONNECTOR IS ALSO CHARRED FROM HEAT COMING FROM THE EXHAUST. THE EXHAUST IS STOCK. *TR