2018 GMC Sierra 1500

I was driving down the highway when my vehicle loss control of operation and check engine light came on. After taking it to the GMC dealership it was determined to be a bad lifter in the motor. The garage had to take the motor completely apart to repair a bent rod and cylinder in the motor. There are numerous reports and a pending class action lawsuit concerning this device in the GMC Sierra trucks and other GMC vehicles. The lifters in the cylinder of this motor are designed to switch the engine from V4 to V6 to save on gasoline. My vehicle has been repaired by the GMC garage but I've seen reports of this problem repeatedly happening in these vehicles and it causes me great concern because if there is a lot of traffic in the area I could get hit or cause an accident by not being able to operate the truck. My vehicle is available for inspection upon request. The safety of myself and others is put at risk because the sudden equipment breakdown could cause an accident. The problem was confirmed by the dealer. No other parties have inspected the vehicle. No warning lamps went off prior to this happening and the vehicle is only a 2018 and only has 36,000 miles on it.

The contact owns a 2018 GMC Sierra 1500. The contact stated that while driving at various speeds, the vehicle experienced shifting while shifting into a lower gear, causing the vehicle to suddenly lurch forward. The cause of the failure was not determined. The local dealer was notified of the failure but no assistance was offered. The manufacturer was not contacted. The failure mileage was 50,000.

During down shifting in lower gears while reducing speed , transmission makes a loud noise followed by vehicle hard lounging forward . Occurance is intermittent and unpredictable . In city traffic this has potential to cause an accident because vehicle lounges forward when speed is reduced . Vehicle has 18900 miles . Made in 2017 .

The contact owns a 2018 GMC Sierra 1500. The contact stated that upon depressing the accelerator, the vehicle shuddered while upshifting. There was no warning light illuminated. The contact had taken the vehicle to a local dealer where they were unable to service the vehicle. The contact had also taken the vehicle to an independent mechanic who informed him that there was a TSB placed on the vehicle. He explained that the incorrect type of transmission fluid had been placed in the transmission which would cause the failure that he had experienced. The contact then called Sewell Buick GMC of Dallas (7474 Lemmon Ave, Dallas, TX 75209) where he was informed that he would be charged a diagnostic fee prior to the repair. The manufacturer was notified of the failure but offered no assistance. The vehicle was not repaired. The failure mileage was approximately 45,000.

The contact owns a 2018 GMC Sierra 1500. The contact stated while driving at various speeds, the vehicle lost power steering assist causing the steering wheel to become firm. The steering wheel jerked while turning and the vehicle stalled on several occasions almost causing a collision. The vehicle was taken to the dealer and the dealer informed the contact that the failure was related to Technical Service Bulletin 18-NA-161. The vehicle was not repaired. The manufacturer was made aware of the failure. The manufacturer promised to provide a callback. The failure mileage was 47,184.

I HAVE TAKEN MY TRUCK TO TEMECULA VALLEY BUICK GMC ON 3 SEPARATE OCCASIONS AFTER NOTICING MY TRANSMISSION SHIFTS HARD. I HAVE EXPERIENCE CLUNKING SHIFTS BOTH IN THE UP SHIFT AND DOWN SHIFT, TYPICALLY AT LOWER SPEEDS. THERE ARE TIMES WHEN THE TRANSMISSION SHIFTS GEARS IT PROPELS THE VEHICLE FORWARD IN A JERKING FASHION, VERY SIMILAR TO A REAR END FENDER BENDER. THE LAST TIME I TOOK MY VEHICLE TO THE DEALERSHIP, I WAS TOLD THAT THE VEHICLE IS SHIFTING AT NORMAL SPECS AND IF IT KEEPS ACTING UP, TO BRING IT BACK WHEN IT IS MORE CONSISTENT. THE VEHICLE'S WARRANTY RUNS OUT IN A FEW MONTHS.