THE BRACKETS ON THE FRONT AND BACK OF THE POWER STEERING PUMP HAVE BROKEN 3+ TIMES AND HAVE CAUSED THE VEHICLE TO BE TOWED, PUMP, SERPENTINE BELT, BRACKETS, FLUID, AND HOSE TO BE REPLACED. I WOULD LIKE TO KNOW WHY AND WHAT CAN BE DONE TO PREVENT THIS FROM HAPPENING AGAIN. PLEASE HELP. THANK YOU. THIS HAS HAPPENED SEVERAL TIM…
Read full complaint
THE BRACKETS ON THE FRONT AND BACK OF THE POWER STEERING PUMP HAVE BROKEN 3+ TIMES AND HAVE CAUSED THE VEHICLE TO BE TOWED, PUMP, SERPENTINE BELT, BRACKETS, FLUID, AND HOSE TO BE REPLACED. I WOULD LIKE TO KNOW WHY AND WHAT CAN BE DONE TO PREVENT THIS FROM HAPPENING AGAIN. PLEASE HELP. THANK YOU. THIS HAS HAPPENED SEVERAL TIMES THE MOST RECENT WAS LAST WEEK. 08/18/2011 *TR
NHTSA ODI #10420867
Mileage unknown · May 22, 1999
Steering
WITHOUT WARNING THE TIE ROD RIPPED ITSELF OUT OF THE FRAME. IF THIS VEHICLE HAD BEEN TRAVELING AT NORMAL SPEED, THE DRIVER WOULD HAVE COMPLETELY LOST THE ABILITY TO STEER THE VEHICLE. ONE BODY SHOP OWNER SAID THAT HE HAS NEVER SEEN OR HEARD OF ANYTHING LIKE THIS.
NHTSA ODI #706774
Mileage unknown · Nov 1, 1998
Seat BeltsSteering
REAR SEAT BELT FAILED UNDER HARD BRAKING. ALSO, POWER STEERING PUMP REAR BRACKET MALFUNCTIONED.
NHTSA ODI #781443
Mileage unknown · Jun 19, 1997
Seat BeltsSteeringCrashInjury
WHILE DRIVING VEHICLE AT 60 MPH VEHICLE WENT OUT OF CONTROL. DRIVER WAS EJECTED FROM SEAT BECAUSE THE LAP BELT DID NOT HOLD. FURTHERMORE VEHICLE WOULD PULL TO THE RIGHT WHEN GOING OVER 55 MPH. *AK
NHTSA ODI #812141
Mileage unknown · Nov 19, 1996
Steering
POWER STEERING PULLEY CAME APART, CAUSING SERPENTINE BELT TO BREAK
NHTSA ODI #511482
Mileage unknown · Jan 4, 1996
Exterior LightingPower TrainSteering
STEERING COLUMN BOLT THAT HOLDS THE STEERING COLUMN IN PLACE, BECOMES VERY LOOSE, CAN NOT SHIFT GEARS AND USE TURN SIGNALS. TT
NHTSA ODI #977419
Mileage unknown · Sep 5, 1995
Steering
BOLT THAT CONNECTS THE POWER STEERING UNIT TO THE MOTOR SHEARED OFF, REPLACED WITH STEEL BOLT, THEN THE BRACKET CRACKED CAUSING POWER STEERING UNIT TO COME OFF.
THE RECLINER MECHANISM AND THE SEAT FRAME MAY HAVE FOAM AND/OR VINYL BETWEEN THEM, CREATING A "SOFT" JOINT. THIS "SOFT" JOINT RESULTS IN LOWER THAN SPECIFIED BOLT TORQUE WHICH LEADS TO JOINT LOOSENESS, CAUSING BOLT FATIGUE AND EVENTUAL BOLT FAILURE.
Consequence & remedy
Consequence: IF BOLT FAILURE OCCURS TO THE DRIVER'S SEAT, IT WOULDALLOW THE SEAT BACK TO SUDDENLY RECLINE, AND COULD RESULT IN LOSS OF VEHICLECONTROL AND A VEHICLE CRASH WITHOUT PRIOR WARNING.
Remedy: DEALERS WILL REMOVE THE FOAM AND/OR VINYL FROM BETWEEN THE RECLINER MECHANISM AND THE SEAT FRAME "SOFT" JOINT AND REPLACE THE RECLINER BOLTS.
SEVERE CORROSION DUE TO ROAD SALT AT THE JOINT OF THE STAMPED STEEL CENTER SECTION AND THE CAST OUTER SECTION CAN CAUSE THE SECTIONS TO SEPARATE.
Consequence & remedy
Consequence: SEPARATION OF THE ROTOR SECTIONS CAN CAUSE LOSS OFBRAKING ABILITY IN THE AFFECTED WHEEL. THIS COULD RESULT IN INCREASED STOPPINGDISTANCE AND/OR LOSS OF VEHICLE CONTROL AND AN ACCIDENT.
Remedy: REPLACE THE FRONT BRAKE ROTORS WITH NEW ROTORS WITH A CORROSION PROTECTION COATING. HOWEVER, IF REPLACEMENT OF BRAKE LININGS ARE NECESSARY, IT WILL BE DONE AT OWNER'S EXPENSE SINCE BRAKE LININGS ARE NORMAL MAINTENANCE ITEMS.
Illustration