2019 GMC Acadia

WHEN I PUT THE CAR IN PARK, I GET AN ERROR MESSAGE THAT SAYS SHIFT TO PARK AND IT TAKES PUTTING IN PARK NUMEROUS TIMES TO GET IT TO CLEAR SO I CAN TRUN THE CAR OFF AND LOCK IT. I KNOW THERE HAVE BEEN SOME MODELS THAT HAVE BEEN RECALLED DUE TO THIS PROBLEM, HOWEVER MINE IS NOT INCLUDED IN THAT RECALL. I WOULD LIKE TO KNOW WHY IT IS NOT INCLUDED AND IF THERE IS ANY HELP AVAILABLE TO CORRECT THIS ISSUE.

I purchased vehicle used 2 years ago last year. I noticed the air conditioner was not cooling. I summed it up too, and extremely hot summer.This summer I did the same thing.I took it in immediately. Catastrophic, I think I bought it like this. It fell apart, the air conditioning compressor fell apart.There is like shrapnel through everything, and they have to go through and clean everything out.It's gonna cost me over two grand. But it only be in 40000 miles on it. I understand it's a twenty nineteen, but owner said at forty thousand miles.This should never happen.

Shortly after purchasing my 2019 GMC Acadia with 52,000 miles on it, my wife parked the vehicle in our driveway and shifted the transmission into Park. When she pressed the push button to shut the vehicle off, the instrument cluster displayed a "Shift to Park" message even though the shifter was already in the Park position. Because the vehicle did not recognize that it was in Park, it would not shut off completely. The radio remained on, and the doors could not be locked. The only way to get the vehicle to shut off was to repeatedly shift from Drive to Park until it finally recognized Park. This occurred multiple times. After researching the problem, I discovered that many other GM owners have experienced the same "Shift to Park" failure. I believe this is a widespread defect that should be investigated because it can prevent a vehicle from shutting off properly, leave electrical accessories powered on, drain the battery, and prevent the vehicle from being secured when parked.

Shortly after purchasing my 2019 GMC Acadia with approximately 52,000 miles, the vehicle displayed a "Steering Assist is Reduced. Drive with Care." warning message and illuminated the check engine light with diagnostic code P0128 00 (Engine Coolant Temperature Below Thermostat Regulating Temperature). I disconnected and reconnected the battery, after which both the warning message and check engine light disappeared. However, the engine coolant temperature gauge then began behaving erratically. On multiple cold starts, the gauge would immediately indicate that the engine was already at normal operating temperature even though the engine had been sitting long enough to be completely cold. This led to a diagnosis of a thermostat and/or engine coolant temperature sensor failure. After researching the issue, I found many other owners reporting the same thermostat and engine coolant temperature sensor failures. I believe this is a widespread defect that should be investigated because incorrect coolant temperature readings can prevent the driver from knowing the true engine temperature and may result in improper engine temperature regulation, overheating, and possible engine damage.

Problem 1: I got the car 2 years ago, and it keeps telling me to "Shift to Park" even though its in park. That's been happening for the whole time I've had it. It does throw a code for it on the scanner machine. I have to shift it back and forth sometimes 3 times and sometimes 17 times. It just keeps beeping over and over and won't shut off. I am having a mechanic look at it Tuesday but hoping it doesn't cost a lot. But no recalls on my car. Problem 2: For the last 4 months or so it keeps saying steering assist is reduced drive with car. It's being looked at Tuesday as well. I have 109K on my car, and got it at 86K.

The contact owns a 2019 GMC Acadia. The contact stated that upon parking and attempting to turn off the vehicle, the message “Action Required. Shift to Park” was displayed while the gear shifter was in park(P). The vehicle failed to turn off. The contact moved the gear shifter back and forth until the vehicle registered it was in park (P). The vehicle was taken to the dealer, who replaced a wiring harness and switch. The manufacturer was not made aware of the failure. The failure mileage was approximately 56,757.