Latches/locks/linkages. Review the 16 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Seat Belts. Review the 11 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
Engine And Engine Cooling. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

5 crash reports0 fire reports3 injury reports

Structure complaints

3 reports

Clear category filter

Mileage unknown · Mar 1, 2000

Structure

WHILE VEHICLE WAS BEING DRIVEN AT 75 MPH, LATCH ON THE HOOD ON DRIVER'S SIDE BROKE, CAUSING THE HOOD TO FLY UP AND BREAK WINDSHIELD. DRIVER WAS ABLE TO PULL TO SHOULDER SAFELY. MANUFACTURER WAS NOTIFIED ABOUT THE PROBLEM. HOOD AND WINDSHIELD HAVE NOT BEEN REPLACED. CONSUMER BELIEVES THAT THERE WAS A RECALL ON THE HOOD LATCH …

Read full complaint

NHTSA ODI #857690

Mileage unknown · Jun 6, 1996

Seat BeltsStructure

HATCHBACK PISTONS WILL NOT PROPERLY SUPPORT THE WEIGHT OF THE DOOR. *SD

NHTSA ODI #505318

Mileage unknown · Jan 18, 1995

Structure

RECALL REPAIRS ON MISLOCATED HOOD STRIKER ASSEMBLY ATTACHMENT IS NOT TO OWNER'S SATISFACTION. *SKD

NHTSA ODI #480387

Official recalls

95V103007 · Seat Belts:front:buckle Assembly

May 24, 1995

THE FRONT SAFETY BELT BUCKLE RELEASE BUTTONS CAN BREAK. THESE RED PLASTIC RELEASE BUTTONS ARE MARKED "PRESS." IF A BUTTON BREAKS, PIECES CAN FALL INTO THE BUCKLE ASSEMBLY CAUSING THE BUCKLE TO OPERATE IMPROPERLY.

Consequence & remedy

Consequence: THE SAFETY BELTS WOULD NOT PROVIDE ADEQUATE PROTECTION TO AN OCCUPANT IN A VEHICLE CRASH.

Remedy: OWNERS SHOULD PROMPTLY CHECK THE CONDITION AND OPERATION OF BOTH FRONT SAFETY BELT BUCKLES AND CAREFULLY INSPECT THE RED RELEASE BUTTON FOR ANY BREAKS OR CRACKS. THEY SHOULD ENSURE THAT BOTH BUCKLES ARE OPERATING PROPERLY BY INSERTING EACH LATCH PLATE INTO ITS BUCKLE, TUGGING ON THE BELT TO MAKE SURE THE LATCH IS SECURELY LOCKED, AND THEN PRESSING THE RELEASE BUTTON. THE LATCH PLATE SHOULD POP OUT OF THE BUCKLE WHEN THE BUTTON IS PRESSED. IF EITHER RELEASE BUTTON SHOWS A SIGN OF BREAKING OR CRACKING OR IF EITHER BUCKLE FAILS TO OPERATE PROPERLY, OWNERS SHOULD PROMPTLY CONTACT THEIR AUTHORIZED DEALER TO SCHEDULE AN APPOINTMENT TO HAVE THE BUCKLE REPLACED OR REPAIRED, FREE OF CHARGE. THE MANUFACTURER IS DEVELOPING A REMEDY DESIGNED TO PREVENT FAILURE OF THE BUTTONS THAT ARE NOT CURRENTLY BROKEN.

93V189001 · Latches/locks/linkages:hood:latch

Nov 23, 1993

MISLOCATED ATTACHING SPOT WELDS OF THE HOOD STRIKER ASSEMBLY CAUSE CRACKS TO START ON THE HOOD INNER PANEL. IF CRACKS OCCUR, THE HOOD STRIKER ASSEMBLY MAY NOT PROPERLY ENGAGE THE HOOD LATCH WHEN THE HOOD IS CLOSED.

Consequence & remedy

Consequence: AN IMPROPERLY ENGAGED HOOD LATCH MAY RESULT IN A HOODFLY-UP WHILE THE VEHICLE IS IN MOTION. THIS WOULD OBSTRUCT THE DRIVER'S VIEWAND COULD CAUSE A VEHICLE CRASH.

Remedy: GM DEALERS WILL (A) INSTALL TWO BOLTS AND NUTS TO SECURE THE STRIKER ASSEMBLY TO THE HOOD INNER PANEL, AND (B) ENSURE THAT THE HOOD LATCH ASSEMBLY FASTENERS ARE PROPERLY TIGHTENED.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗