Owner reports · Recalls · Investigations
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →Owner complaints by model year
Compare all Conventional years →Counts vary with age, sales and reporting. They are not failure rates.
No component reports in this snapshot.
Tap a category to read its complaints. One report may name several components.
Mileage at the reported incident
Limited mileage data: 0 of 0 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
NHTSA owner reports · September 18, 2026 snapshot.
No matching complaints in this snapshot.
Aug 16, 1988
THE HEATER/AIR CONDITIONER BLOWER MOTOR SPEED CONTROL RESISTORS CAN UNDER CERTAIN CONDITIONS OVERHEAT AND STALL.
Consequence: THIS COULD RESULT IN LOW AIR FLOW ACROSS THE RESISTORNETWORK AND HIGH AMPERAGE, ALLOWING THE AIR DUCT TO REACH ELEVATED TEMPERATURESWITH THE POSSIBILITY OF A FIRE.
Remedy: INSTALL A THERMO CUTOFF DEVICE IN THE HEATER/AIR CONDITIONER SYSTEM AND/OR REPLACE THE BLOWER MOTOR SWITCH.
Oct 20, 1986
SEAT BELTS CAN LOOSEN AS THE TRUCK IS DRIVEN. CONSEQUENCE OF DEFECT: DRIVER AND PASSENGER WOULD NOT BE PROPERLY RESTRAINED IN EVENT OF A SUDDEN STOP OR CRASH.
Consequence: Not supplied
Remedy: REPLACE THE NON LOCKING RETRACTOR SEAT BELTS WITH AUTOMATIC LOCKING RETRACTOR SEAT BELTS.
Aug 26, 1986
THE HANDHOLD MOUNTING SYSTEM, WHICH CONSISTS OF A TUBULAR HANDLE HELD IN THREE PLACES BY CAST ALUMINUM BRACKETS AND ATTACHED TO THE ENGINE EXHAUST MUFFLER HEAT SHIELD. VIBRATION FROM THIS SYSTEM CAUSES THE HANDHOLD PARTS TO WEAR. CONSEQUENCE OF DEFECT: IF THE PARTS WEAR THIN THE POSSIBILITY EXISTS THAT THE HANDHOLD MIGHT GIVE WAY UNDER THE WEIGHT OF A DRIVER. THIS COULD RESULT IN PERSONAL INJURY.
Consequence: Not supplied
Remedy: REPLACE THE END BRACKETS WITH A MODIFIED DESIGN UTILIZING A RUBBER ISOLATER. ALSO, ADD A PLASTIC SLEEVE TO THE CENTER BRACKET FOR ISOLATION.
Sep 7, 1983
THE PINCH BOLT INSTALLED ON THE STEERING GEAR COMPONENT IS OF A SMALLER SIZE THAN SPECIFIED.
Consequence: Not supplied
Remedy: DEALER WILL REPLACE THE INCORRECTLY SIZED PINCH BOLT WITH A PROPERLY SIZED ONE IF NECESSARY.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
No exact-year investigations in this snapshot.
Illustration