Owner reports · Recalls · Investigations
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →Owner complaints by model year
Compare all Coe years →Counts vary with age, sales and reporting. They are not failure rates.
No component reports in this snapshot.
Tap a category to read its complaints. One report may name several components.
Mileage at the reported incident
Limited mileage data: 0 of 0 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
NHTSA owner reports · September 18, 2026 snapshot.
No matching complaints in this snapshot.
Jul 24, 1989
THE STEERING GEAR MOUNTING BRACKET WELDS MAY CRACK UNDER CERTAIN STEERING LOAD CONDITIONS.
Consequence: STEERING CONTROL WOULD BE ADVERSELY AFFECTED WITHPOTENTIAL FOR LOSS OF TRUCK CONTROL AND AN ACCIDENT.
Remedy: REPLACE STEERING GEAR MOUNTING BRACKET WITH A REDESIGNED BRACKET.
Jun 5, 1989
CORROSION OF THE GRABHANDLE AT ITS MOUNTING SURFACE MAY LEAD TO CRACKING OR LOSS OF STRENGTH.
Consequence: FAILURE OF GRABHANDLE DURING USE COULD RESULT INPERSONAL INJURY.
Remedy: REPLACE GRABHANDLE AND ITS FASTENER WITH IMPROVED GRABHANDLE; ALSO, INSTALL GASKET BETWEEN THE HANDLE AND AIR STARTER RESERVOIR.
Oct 11, 1988
STEERING ARM MAY FAIL IF USED ON EATON EFA12F4 FROM AXLE IN CONJUNCTION WITH ROSS HFB70 POWER STEERING GEAR.
Consequence: A FAILED STEERING GEAR ARM COULD LEAD TO LOSS OF VEHICLECONTROL AND VEHICLE CRASH.
Remedy: INSTALL A NONADJUSTABLE 1500 PSI POWER STEERING PUMP PRESSURE RELIEF VALVE TO LIMIT STEERING ARM FORCES. REPLACE STEERING ARM WITH A DESIGN CAPABLE OF WITHSTANDING HIGHER FORCES. ADJUST MAXIMUM POPPET VALVE SETTINGS TO 500 PSI AND ADJUST AXLE STOPS.
Jun 15, 1987
BUCKLING OF THE TILT CYLINDERS MAY OCCUR WHILE LOWERING THE VEHICLES CAB DUE TO IMPROPER USE OF THE CAB TILT SYSTEM.
Consequence: CAB MAY DROP TO ITS LOWERED POSITION.
Remedy: REPLACE THE 1 1/2 IN. DIAMETER TILT CYLINDERS ON ALL 104 IN. CABS WITH 2 IN. DIAMETER CYLINDERS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
No exact-year investigations in this snapshot.
Illustration