2024 Ford Ranger

The vehicle went into BAJA Mode 4wd high then 4wd low range out of nowhere while driving. It shot me off the road , and ive been researching it. There is a 6 page thread about new rangers and ranger raptors doing this on 6G ranger forum, tons of people with the same issue. Super scary. Fear injury or fatality will happen from this as it shoots you hard off the road

The contact owns a 2024 Ford Ranger. The contact stated that while driving 60 MPH, the 4WD message was displayed and the 4H warning light illuminated before the screen went blank, and the rear wheels locked up, causing the driver to lose control of the vehicle and drive into a ditch. The vehicle came to a stop after driving into the ditch. The air bags did not deploy. The vehicle was winched out of the ditch and towed to a Collision Center. The contact stated that the drivetrain and the front end needed to be replaced, and the passenger’s side fender and driver’s side front fender were damaged, and the front driver’s side step was bent. No injuries were reported. The contact stated that the vehicle was involved in another crash in March 2026. The contact stated that while driving in the rain and coming to a stop, the screen displayed the message “Slippery”, and the vehicle shifted into 4H independently and the rear wheels locked up, causing the driver to lose control of the vehicle and the vehicle drove into a ditch. The vehicle came to a stop 20 feet away from the road in the ditch. The air bags did not deploy. The vehicle was not towed. The front bumper and the passenger’s and driver’s side fender wheel openings were damaged. No property damage was reported. The message “Slippery” was displayed, and the 4H warning light was illuminated. A Police report was not filed. No injuries were reported. The failure had occurred several times. The dealer was contacted, and the vehicle was taken to the dealer prior to the crash; however, the dealer was unable to duplicate the failure. The vehicle was repaired by the insurance provider. The manufacturer was notified of the failures. The failure mileage was 3,000.

While driving, randomly and intermittently the vehicles drive mode will change on its own, usually requiring the driver to slow down to allow for a 4X4 shift, as called out by messages on the dash and an audible warning. This has happened multiple times and ford cannot replicate this issue. I was going to just replace the drive mode selection knob but as it turns out it's on national backorder.

Vehicle experienced unintended transmission gear change without driver input from the gear selector. While driving, the transmission shifted unexpectedly into 4H even though the selector was not touched. This created a safety hazard due to sudden change in vehicle behavior, including: loss of acceleration, lurching and unexpected movement. Issue occurred at approximately 30 mph. Concern is potential electronic transmission control or shift-by-wire malfunction causing unintended gear engagement.

My 2024 Ford Ranger XLT 2W has been suddenly losing power or stumbling upon initial acceleration. This has been occurring intermittently. My truck now has approximately 20,000 miles. The problem has become increasingly frequent. It seems to occur most often when accelerating from a complete stop. The loss of power can last for several seconds, then normal power is regained. Several times, the truck has lost power while making a left turn. It simply will not accelerate, and I find that I am stuck, unable to complete my turn and clear the oncoming traffic. I have taken my truck to a local dealer who attempted to diagnose the problem and they didn’t offer a solution since they were unable to reproduce the problem during their road test. It has happened many times since then and I am scheduled to return the vehicle to the same dealership to attempt to diagnose and fix the problem again soon. The problem seems to occur, regardless of which drive mode the truck is in and also occurs with Electronic Stability Control both enabled and disabled. There are no warning lights or check engine codes shown.

My 2024 Ford Ranger Raptor has been suddenly losing power or stumbling upon initial acceleration. This has been occurring intermittently since it was nearly new. My truck now has approximately 10,500 miles. The problem has become increasingly frequent. It seems to occur most often when accelerating from a complete stop. The loss of power can last for several seconds, then afterwards, normal power is regained. It poses a safety risk since it has nearly caused collisions. Several times, the truck has lost power while making a left turn in front of oncoming traffic. It simply will not accelerate, and I find that I am stuck, unable to complete my turn and clear the oncoming traffic. Once when accelerating away from a stoplight, the truck lost power, and I was nearly struck by following vehicle. I have taken my truck to a local dealer who attempted to diagnose the problem and they didn’t offer a solution since they were unable to reproduce the problem during their road test. It has happened many times since then and I am scheduled to return the vehicle to the same dealership to attempt to diagnose and fix the problem again soon. The problem seems to occur, regardless of which drive mode the truck is in and also occurs with Electronic Stability Control both enabled and disabled. There are no warning lights or check engine codes shown.

I am the original owner of this vehicle and the engine and controls have not been modified in any way. Yesterday while driving at approximately 30 mph on a surface street with dry road conditions in the “2H” setting on the Drive Modes Selection Dial my truck spontaneously shifted into four-wheel drive high and then attempted to switch into four-wheel-drive low – “Rock Crawl Mode.” The rear differential locked, speed was suddenly reduced, and the steering became more difficult. Luckily, I was able to safely pull over. I captured a video at this time documenting the control settings and display image. It took multiple attempts, even in Park and Neutral, to get out of 4WD and back into the 2H setting. Once back in 2H, the truck drove normally. I have had similar experiences at least twice before in this truck with months between them. In those cases, I wondered if I had accidentally bumped the dial control. I am certain that this was not the case yesterday, so this was a spontaneous event initiated by the truck’s computer and/or mechanical controls. I consider this to be a very serious safety hazard, as it dramatically and unexpectedly affected the speed and handling of my truck. I did some online searching today and found that multiple other Ranger Raptor owners have experienced this issue, suggesting that this may be a serious design flaw affecting multiple vehicles. I plan to schedule a service appointment with Ford and notify them directly of this problem and hazard.