2018 Ford Mustang

I own a 2018 Ford Mustang EcoBoost Premium with the 2.3L EcoBoost engine. The vehicle initially developed a check-engine light and was diagnosed with P0303 (Cylinder 3 misfire), P0316 (startup misfire), and P018C. On August 24, 2026, all four spark plugs and one ignition coil were replaced and a fuel/induction cleaning was performed. On September 10, the vehicle suddenly started with an extremely rough idle and produced a large cloud of white, sweet-smelling exhaust smoke. The check-engine light illuminated and the previous codes returned along with additional codes. The vehicle continued producing white exhaust smoke after several hours of diagnostic testing. Later that day, the engine shook violently while I was stopped at a traffic light and the tachometer fluctuated significantly. On September 11, the check-engine light returned and the previous diagnostic codes were again present. Firestone documented that coolant was present in the exhaust, that the coolant level was low again after coolant had been added the previous day, that the engine was burning coolant and producing white smoke, and that coolant was mixed with the engine oil. Firestone stated the engine may have a cracked head, failed head gasket, or internal engine crack and recommended complete engine replacement. The engine has now suffered a serious internal failure severe enough that the repair facility recommends replacement. The vehicle has exhibited violent shaking, unstable engine speed, repeated misfires, rapid coolant loss, coolant contamination of the engine oil, and coolant burning through the exhaust. I am concerned that continued operation could result in complete engine failure or sudden loss of engine power while driving, creating a significant safety hazard in traffic. Before September 10, the vehicle had never produced white exhaust smoke or experienced this severe shaking. I am reporting this as a potential safety defect involving the 2.3L EcoBoost engine.

I own a 2018 Ford Mustang EcoBoost Premium with the 2.3L EcoBoost engine. The vehicle initially developed a check-engine light and was diagnosed with P0303 (Cylinder 3 misfire), P0316 (startup misfire), and P018C (fuel pressure sensor circuit low). On August 24, 2026, all four spark plugs and one ignition coil were replaced, and a fuel/induction cleaning service was performed. The P018C repair was declined at that time. On September 10, 2026, the vehicle started with an extremely rough idle and produced a very large cloud of white, sweet-smelling exhaust smoke. The check-engine light came on. The original codes, including the misfire codes, were present along with additional codes. The vehicle underwent approximately three hours of diagnostics and road testing. The codes were cleared, and afterward only P018C returned. Testing reportedly did not identify a head-gasket leak, but visible white smoke was still coming from the exhaust when I left the repair facility. Possible coolant intrusion involving the turbocharger was discussed, but the source was not confirmed. Later that day, the vehicle would not crank in Park but started in Neutral. While driving home, the engine began idling so violently at a traffic light that the entire vehicle shook and the tachometer fluctuated significantly. Before September 10, the vehicle had never produced white exhaust smoke, never shaken violently at idle, and always started. The repair facility attempted to inspect the cylinders with a borescope, but both of its borescopes were not functioning. I am concerned about possible coolant intrusion or another engine defect because of the Cylinder 3/startup misfire history, heavy white sweet-smelling exhaust, and severe intermittent rough running. The cause has not yet been confirmed, and I am concerned about possible engine failure or loss of power while driving.

1. Component failed and availability for inspection: The engine assembly block failed due to a manufacturing defect known as "coolant intrusion into the cylinders." The vehicle and the defective engine are currently located at my residence and remain fully available for federal or manufacturer inspection upon request. 2. Safety risk: The safety of myself and others was severely compromised. Coolant entering the combustion chambers causes sudden, severe engine misfires across all cylinders, erratic power loss, and instantaneous stalling. Operating a vehicle where the engine can suddenly lose all power on high-speed roads creates an immediate risk of rear-end collisions and catastrophic traffic accidents. Furthermore, high-pressure internal coolant leaks pose an inherent risk of engine fires. 3. Problem confirmed by a dealer: Yes. The problem has been officially diagnosed and confirmed by an authorized Ford dealership service center, which documented internal coolant intrusion. 4. Inspected by manufacturer, police, or insurance: The component was inspected and verified by the vehicle manufacturer's authorized dealership technicians. It has not been inspected by the police or insurance representatives, as no crash has occurred yet. 5. Warning lamps, messages, or symptoms prior to failure: Prior to the diagnosis, the vehicle exhibited a "Check Engine Light." Currently, the vehicle is suffering from critical failure symptoms: the Check Engine Light is flashing constantly, the engine misfire codes are actively showing on all 4 cylinders, and the vehicle shakes violently at low RPMs (rough idling). These severe symptoms first appeared approximately 2 moths ago and have progressively worsened due to the coolant intrusion.

A check engine light turned on and the vehicle was taken to a local dealership. The check engine light was for an engine misfire and was diagnosed further. There was an engine failure due to coolant entering the system. Upon further research, I learned this is a common issue for 2016-2020 Ford Mustangs and it is due to a faulty engine design. The dealership is recommending a new engine install with a price tag of over 13,000 despite this being known to happen because of a badly designed engine with these cars.

I was told by my mechanic I have a head gasket leak. Turns out there is a class action lawsuit for my 2.3 ecoboost motor for this coolant intrusion problem. It is a known problem. It is a safety issue as I’ve heard of some engine fires. My car only has 56000 miles on it but it is a 2018 so just out of the manufacturer warranty. I’ve reached out to Ford but no definitive answer on whether they will help or not they want me to pay them to diagnose it even though I’ve already had it properly diagnosed

When driving the car, the engine temperature light came on, pulled the car over to let it cool down, when cooled, drove home and looked in the engine compartment, found the coolant reservoir empty, filled it with proper coolant, next day the engine light came on, took to O'Reilly auto parts to scan code, problem was Cylinder #3 misfire, changed out spark plug, noticed that coolant reservoir was low again, searched internet for possible causes when found that many people are having the same issue, turns out Ford manufactured the 2.3L engines with a faulty design where the cooling leaks into the cylinders "Coolant intrusion". the fix that Ford has established for this issue is to replace the engine with a "long block" version, but will not issue a recall. We have contacted Ford and explained the issue, but they will not repair. This should not be happening to a car with only 27,000 miles. now we are stuck with a car we can't drive and don't have the extra $5,000 plus dollars to replace the engine!