2022 Ford Maverick Hybrid

I was driving in town going about 20 MPH when I approached and intersection and stepped on the brakes. The brakes locked up, multiple warning lights, messages, audible alarms went off. I though the truck died and I put it in park and turned off the key. Then I turned the key back on, all the lights and warnings came back on, but it also said ready to drive. I was not able to accelerate using the gas pedal, truck was moving slowly on its own, it gained some speed but only ran on the electric motor. No gas engine. I got 3 blocks to my destination very slowly and shut the truck off. I had to go inside to do some work and when I came back about an hour later I turned the truck on and all the alerts were gone except the check engine light. It did run normal then. After calling the dealership they said to bring it in so they could look at it. I left it there and they called later saying they had pulled multiple error codes, did not tell me what they were, they cleared all the codes and drove it and said it did not act up for them and said I could come pick it up. I do not want to drive it because I feel like this could happen again at any time and if I were driving at a higher speed or on a interstate and this happened who knows who could have been hurt. This Maverick is my daily driver for work ect. but I will not drive it unless I absolutely have to right now. I got no answers from the dealership. Before this, no warning lights had been on.

The contact owns a 2022 Ford Maverick. The contact stated while driving approximately 45 MPH, his girlfriend who was occupying the front passenger's side seat, informed him that there was an abnormal odor inside the vehicle. Additionally, the contact sustained severe headaches while driving. The contact drove to the hospital, where he was informed that there was an elevated level of carbon monoxide in his blood, and he had sustained carbon monoxide poisoning after two hours of exposure. The contact also stated that the check engine warning light was illuminated intermittently. The vehicle was taken to the dealer, where it was determined that the heater exchange needed to be replaced. The vehicle was repaired. Additionally, the contact stated while driving 70-75 MPH with the Adaptive Cruise Control engaged, a message indicating that the gear was changed forcibly was displayed, and the Eco mode was disengaged, and the engine stalled. The contact was able to pull to the side of the road. The messages "Service Advancetrac", "Service Engine Soon" "Pre-collision Assist Not Available" and "Hill Assist Not Available" were displayed on the instrument panel. Additionally, the messages "Power Train System Fault" and "Collision Assist Unavailable" were displayed on the mobile app. The traction control warning light was illuminated. The contact was able to restart the vehicle after several attempts and a Police Officer assisted the contact in driving to the other side of the road. The contact was able to continue driving at 45 MPH. The vehicle was taken to the dealer, where the failure could not duplicated because the check engine warning light was not illuminated. The vehicle was not repaired. The manufacturer was notified of the failure and a case was opened. The failure mileage was approximately 18,000.

Driving at 65mph and the vehicle began to lose power. Messages displayed on instrument cluster "Service engine soon" "Pre-Collision Asist not available" "Power train malfunction/reduced power" vehicle started losing power and was unable to maintain speed. Check engine light appeared as this was occurring. This occurred in traffic and other drivers did not expect this. I was able to pull over to the side of the road and shut the vehicle down. Once I started the truck again the check engine light remained on but I was able to accelerate back to 60mph.

Driving around 20 mph, when the car lost power /almost felt like it was stalled. Check engine light came on (yellow wrench icon) and pop up message "service soon". Had to stop vehicle and restart several times to get car going again. Ford Pass app shows a code for Power Malfunction / Reduced Power (see image from phone app). Technician at dealership pulled up error codes from the past few weeks (see images).

I was driving [XXX] on [XXX] around [XXX] yesterday morning north . Without warning I lost control of the accelerator and the speed diminished to around 35 MPH. Several warning lights flashed onto the dashboard saying systems were failing. Check engine light came on and a "wrench" symbol appeared. The light on the transition control dial for "D" started flashing. I was in a construction area with no shoulder when it happened. I was able to creep into a niche on a partial turnoff around .5 miles later. I shut the car off and restarted it. Same problems. I noticed I was .25 miles from an exit and waited for traffic to clear from behind. Managed to get to 10-15 MPH and up the exit with traffic blaring around me. Parked at a McDonald's and wait for a tow truck that never came after 2.5 hours. Made an appointment with nice folks at Classic Ford in Columbia. I was told tow truck might be another 2.5 hours so I tried to restart car. This time only the "check engine" light stayed on. I drove the car slowly in electric mode around the parking lot and it seemed safe at lower speeds. I mapped out a "less the 45 MPH" route to Classic Ford and was able to reach there without further incident. However, the "check engine" light remained on the entire trip. The car is now being checked by Classic Ford. I have had no diagnosis yet. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

Driving down highway at normal speed. Car lost all engine power, still on but indicated gear shift was not in drive. Pulled off to side of highway. Put drive in park. Dash came up with a bunch of warnings. Turned off. Turned back on. Same warnings happened. Put it in drive and it just start going forward without any input. Was injured in power. Drove it to safe spot. Turned off called for tow. Tried turning it back on and returned to normal but check engine light was on. Very unsafe to loose power in the middle of the highway. My two friends died like that!

Took my maverick for the system softward update and when I drove it after the update my truck suddenly had a loss of total power while driving on the freeway at 70mph. The dashboard cluster had all the lights come on check engine, abs ect light up and I had limit power 5mph enough to get my to the side of the freeway and all of a sudden the brake engaged and the truck jolted to a stop. I took the truck back to the dealer and they uploaded the system update again and released the truck back to me and a couple of days later the same thing happened.

Was driving on the freeway and a ton of warnings suddenly appeared on the dash. Pre-collision assist not available, stop driving now, service engine soon, powertrain malfunction, etc. The truck would not accelerate when the gas pedal was pressed and slowly slowed down. The truck would auto-accelerate (without gas pedal input) to about 20 mph unless the brake was applied (limp-mode). I pulled over, disconnected the 12V battery and reconnected which seemed to fix the problem. The dealership could not figure out the issue. I believe that the 12V battery was somehow drained to a point where it fed a low-voltage to suite of safety sensors which all went haywire.

Driving at highway speeds, the vehicle started de-accelerating with a message on the dash saying to slow down to shift in selected gear. The vehicle did not respond to any accelerating to avoid traffic to get to the side of the road and only deaccelerated. The "D" indicator in the PRNDL was flashing as i pulled off to the side of the road. Once stopped, error messages appeared on the dash; "Hill Start Assist Not Available," "Service AdvanceTrac," "Pre-Colision Assist Not Available," and "Service Vehicle Soon." After waiting 5-7 minutes with the vehicle turned off, The vehicle was again drivable with the CEL illuminated. This issue generated two codes: U1011 - The automobile fault code U1011 indicates a problem with the Controller Area Network (CAN) communication harness, a faulty Engine Control Module (ECM), or a poor harness ground connection. The most common symptom is the Engine Light ON or Service Engine Soon Warning Light. U1028 - The automobile fault code U1028 indicates a communication issue between the vehicle’s modules. This is often accompanied by the engine light turning on. The cause of this fault code could be a faulty module, an open or shorted module harness, or a poor electrical connection in the module circuit.