2018 Ford Fusion

I heard fluid from what seemed like my dashboard and a puff of white smoke, no sensors came on. My Ford fusion continued but ran rough. I was pulling out of a parking lot onto the street and my Ford fusion was nearly t-boned because it would not accelerate. Later that day my overheat sensor came on and my fusion left me stranded on the side of the road in the middle of nowhere with a baby in 100 degree heat. I called a local mechanic, he put water in it and drove it to his shop. After 400 dollars worth of work the problem persistent, he then checked it for the notorious coolant intrusion issue and confirmed a misfire and coolant intrusion in cylinder 2. It's now parked and has not been driven in 3 months.

I have a 2018 ford fusion 2.0L ecoboost with around 77k miles and started to see coolant loss with no visible signs in engine bay or below.car, rough start with error P0316 and occasional misfire. White smoke comes from exhaust on start sometimes. Also have to fill coolant every other day or so. It looks as coolant intrusion issue very common with these engines.

My cars coolant is leak and I don't know where it goes. It overheats and the coolant continually needs to be added. The coolant cap has cracked twice and its is hard to find a replacement cap and we can't drive the car. I have taken it to two auto repair shops, and they said the issue can NOT be fixed. I am in fear of it overheating all the time. This is causing me fear and I believe it is dangerous and I am stuck paying for a car I can't drive.

The contact owns a 2018 Ford Fusion. The contact stated that while driving at an undisclosed speed, the temperature gauge indicated that the engine was overheating, and the vehicle briefly shuddered. The check engine warning light was illuminated. The vehicle was taken to an independent mechanic, who diagnosed failures with the head gasket and turbo charger. The vehicle was not repaired. The manufacturer was notified of the failure but referred the contact to the NHTSA Hotline for assistance. The failure mileage was 75,000.

M 19 year old daughter purchased the 2018 Ford Fusion 1.5L FWD certified on May 10th from AutoNation Ford of Orange Park, FL on 5/10/2023. Car broke down on 7/31/23 at 93032 miles and had it towed back to AutoNation. Was told that the flexplate broke and that there was coolant intrusion in one or more cylinders. Had the car repaired using the extended warranty plan that was purchased for the engine repair. Also paid to have the flexplate replaced. Received the car back on 9/22/23 with 93041 miles. On 9/26/23, check engine light at 93173. Code read oxygen sensor and emission purge valve sensor. Did not have repaired right away so that we can save up for the cost since it wasn't covered by the extended warranty plan. The cost was going to be about 700.00. Then the car started to hesitate in traffic while making a loud "farting" noise and eventually breaking down on 11/8/23 . We were able to get it to Garber Ford in Green Cove Springs but was told by the mechanic that the car is to dangerous to drive anymore. After a diagnostic was performed, we were told that not only is the evap purge valve bad, the car now needs a new transmission. The transmission pours out as fast as they can put it in. Due to the broken flexplate being noted during the first repair, its highly likely that the warranty company will cover. Estimated cost is 10k if we approve the breakdown and they deny. If we do not approve the breakdown so that insurance can inspect and just replace the transmission it will be 7-8k.

On 11/17, I received a shift system failure alert. The car would not go into park and I could not start the vehicle. We contacted the dealer to have the car towed. The dealer indicated there was a current recall for the same issue however this car was not included. There is a known issue with other ford fusions. As a result I am having to pay out of pocket for the fix. The recall should be expanded to include 2017-2018

The contact owns a 2018 Ford Fusion. The contact stated that upon taking the vehicle into the dealer for an oil change, the contact was informed that the engine was empty of coolant. No warning lights were illuminated. The vehicle was taken to the dealer, who determined coolant intrusion had caused damage to the cylinder head, requiring a replacement. The vehicle was not repaired. After investigating the failure, the contact related it to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure but referred the contact to the NHTSA Hotline for assistance. The failure mileage was 47,000.

The contact owns a 2018 Ford Fusion. The contact stated that after starting the vehicle, he observed excessive smoke coming from the engine compartment as well as the rear exhaust. The check engine warning light was illuminated. The vehicle was taken to the dealer, who determined there was coolant intrusion into the engine cylinder that caused damage to the cylinder head. The contact was informed that the engine needed to be replaced. The vehicle was not repaired. After investigating the failure, the contact related the failure to Customer Satisfaction Program: 21N12. The manufacturer was notified of the failure, and a case was opened. The failure mileage was 89,000.