Consequence: ENGINE COOLANT COULD DISCHARGE ONTO THE ENGINE AND ITSEXHAUST MANIFOLD CREATING THE POTENTIAL FOR A FIRE DUE TO THE HIGH ENGINEEXHAUST MANIFOLD TEMPERATURES.

Remedy: REPLACE HOSES AND RADIATOR CAPS; INSTALL HIGH HEAT RESISTANCE ALUMINIZED STAINLESS STEEL MUFFLERS.

87V144000 · Engine And Engine Cooling:exhaust System:emission Control

Sep 9, 1987

VEHICLES ARE SUBJECT TO EXCESSIVE UNDERHOOD TEMPERATURES AND FUEL SYSTEM PRESSURES IN SEVERE DUTY APPLICATIONS.

Consequence & remedy

Consequence: THIS CREATES POTENTIAL FOR FUEL EXPULSION FROM THE FUELFILLER PIPE WHICH IN THE PRESENCE OF AN IGNITION SOURCE, COULD RESULT IN AFIRE.

Remedy: INSTALL MODIFICATION KITS TO MINIMIZE POSSIBILITY OF FUEL EXPULSION AND TO SHIELD UNDERBODY COMPONENTS FROM EXHAUST SYSTEM HEAT.

85V061000 · Fuel System, Diesel

May 14, 1985

WHEN FRONTALLY IMPACTED INTO A FIXED BARRIER AT 30 MPH, AS SPECIFIED IN FEDERAL MOTOR VEHICLE SAFETY STANDARD (FMVSS) NO. 301, THE LEFT FRAME RAILS OF SUCH VEHICLES MAY DISPLACE INBOARD, PINCHING THE FUEL/WATER SEPARATOR CANISTER BETWEEN THE FRAME RAIL AND ENGINE SUFFICIENTLY TO DISPLACE THE FUEL/WATER SEPARATOR DRAIN ROD, ALLOWING THE CONTENTS OF THE CANISTER TO DRAIN. CONSEQUENCE OF DEFECT: FUEL LEAK DURING OR AFTER A CRASH INCREASES THE POSSIBILITY OF A FIRE.

Consequence & remedy

Consequence: Not supplied

Remedy: INSTALL A CANISTER SHIELD, A REVISED DESIGN DRAIN ROD SHIELD, AND MODIFY FUEL/WATER SEPARATOR MOUNTING BRACKET.

82V124000 · Fuel System, Gasoline:delivery:fuel Pump

Dec 13, 1982

SOME OF THE INVOLVED VEHICLES MAY HAVE A DIODE IN THE ELECTRICAL FUEL PUMP CIRCUIT THAT MAY SHORT DURING ENGINE STARTING DUE TO INADEQUATE CAPACITY TO WITHSTAND CURRENT DRAW. A SHORT CIRCUIT WOULD RESULT IN NORMAL ENGINE STARTING, BUT THE PUMP WILL NOT CONTINUE TO SUPPLY THE ENGINE WITH FUEL.

Consequence & remedy

Consequence: Not supplied

Remedy: THE DEALER WILL REPLACE DEFECTIVE ELEMENT IN THE ELECTRICAL FUEL PUMP CIRCUIT WITH A NEW RELAY FEED WIRING ASSEMBLY WHICH CONTAINS A LARGER CAPACITY DIODE, FREE OF CHARGE.

82V104000 · Power Train:axle Assembly

Oct 26, 1982

ON CERTAIN VEHICLES, THE LOCK WEDGES USED TO SECURE THE AXLE BEARING NUTS TO THE AXLE HOUSING MAY FALL OUT OF POSITION, ALLOWING THE NUT TO LOOSEN. THE NUT ON THE LEFT SIDE MAY FALL OFF, ALLOWING MOVEMENT OF THE AXLE SHAFT.

Consequence & remedy

Consequence: Not supplied

Remedy: THE DEALER WILL REPLACE DEFECTIVE LOCK WEDGES WITH AN IMPROVED VERSION. WHEEL BEARINGS WILL BE INSPECTED AND ADJUSTED OR REPLACED, IF NECESSARY.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

EA87002 · Filler Neck Spurt

Opened Nov 4, 1986 · Closed Apr 29, 1987

Status: closed (inferred from source dates) · Vehicle Speed Control:linkages

SUMMARY OF INFORMATION FROM MANUFACTURER:FORD HAS SUPPLIED INFORMATION REQUESTED CONCERNING VEHICLE POPULATIONAND THE NUMBER OF COMPLAINTS.ANALYSIS:THE PROBLEM APPEARS TO BE ONE OF EXCESSIVE HEAT COLLECTING UNDER THEVEHICLES, USUALLY WHILE STATIONARY WITH THE ENGINE IDLING.THIS HEATCAUSES THE FUEL TO VAPORIZE IN THE FUEL TANK AND DEVELOP PRESSURES INEXCESS OF WHAT THE VENT SYSTEM CAN HANDLE.STATUS:IR TO FORD SENT ON 2/20/87. MEETING WITH FORD AND FINAL STAGE MANUFACTUR-ERS HELD ON MARCH 11 & 12, 1987. ADDITIONAL MEETING HELD ON MARCH 7, 1987.ALSO ON APRIL I, 1987.FORD ANNOUNCED SERVICE CAMPAIGN, NO SAFETY RECALL.RECALL REQUEST LETTER SENT ON 4/7/87. FORD DID NOT AGREE TO A SAFETYRECALL, CONSEQUENTLY A PANEL MEETING WAS HELD ON 4/29/87 AND INVESTIGATIVECASE C87-003 WAS OPENED.THIS EA WAS CLOSED AS A RESULT OF THE CASE OPEN-ING ON 4/27/87.===