12/6/2014 @ 18:20 C.S.T. TO WHOM IT MAY CONCERN, (HOPEFULLY A SUPERVISOR OR DIRECTOR) THE DRIVERS SIDE SEAT BELT FLOOR CLASP FAILS. I RELEASES THE SEAT BELT WHILE DRIVING. AFTER TWO OR THREE TIMES OF RE-HOOKING THE SEAT-BELT TO THE HOLD DOWN CLASP BOLTED THROUGH FLOOR BOARD OF THE VEHICLE, IT WILL NO LONGER ACCEPT AND HOLD THE…
Read full complaint
12/6/2014 @ 18:20 C.S.T. TO WHOM IT MAY CONCERN, (HOPEFULLY A SUPERVISOR OR DIRECTOR) THE DRIVERS SIDE SEAT BELT FLOOR CLASP FAILS. I RELEASES THE SEAT BELT WHILE DRIVING. AFTER TWO OR THREE TIMES OF RE-HOOKING THE SEAT-BELT TO THE HOLD DOWN CLASP BOLTED THROUGH FLOOR BOARD OF THE VEHICLE, IT WILL NO LONGER ACCEPT AND HOLD THE SEAT BELT IN PLACE. THIS HAS HAPPENED TO BOTH OF MY VEHICLES, THE 1993 OCCURRED AT APPX. 190,000 MILES AND WHEN I CONTACTED FORD ABOUT THIS SAFETY ISSUE AND FAILURE OF THE SEAT BELT TO REMAIN CLASPED, THEY SIMPLY SAID, IT IS AN OLDER VEHICLE AND YOU HAVE TO PURCHASE THE ENTIRE SEAT BELT ASSEMBLY FOR OVER $500.00...[XXX]. THIS IS A SAFETY ISSUE...AND FORD NEEDS TO REPLACE THE HOLD DOWN CLASP WHICH IS BOLTED THROUGH THE FLOOR BOARD FREE OF CHARGE. LABOR AND PART FREE. IF I HAD BEEN ATTEMPTING TO AVOID AN ACCIDENT OR WAS IN AN ACCIDENT AND THAT BELT LET LOOSE, I MIGHT BE DEAD. THIS SHOULD NEVER HAPPEN. MY 1976 FORD TORINO NEVER HAD THIS PROBLEM, NOR THE OTHER VEHICLES REFERENCED, NOR ANY OTHER VEHICLE I HAVE EVER OWNED. THIS IS A SAFETY AND DRIVER SAFETY WHICH NEEDS TO BE ADDRESSED, AND NO MATTER THE AGE OF THE VEHICLE, IT IS A SAFETY FEATURE MANDATED BY ALL STATES MOTOR VEHICLE LAWS TO BE ENGAGED AT ALL TIMES WHILE DRIVING. IF THE ITEM IS DEFECTIVE BY DESIGN, AND AS IN MY CASE, IT ARBITRARILY AND WITHOUT NOTICE OF ITS IMMINENT FAILURE, FAILS WITH NO PRESSURE ON IT, IT NEEDS TO BE A RECALLED ITEM. I ALSO SUSPECT THAT FORD IS STILL PURCHASING FROM THE SAME SUPPLIER AND IF THIS IS TRUE, THEN ALL SUBSEQUENT SEAT BELT HOLD DOWN CLASPS WILL FAIL LIKEWISE AT THE 6 - 9 YEAR RANGE, WITHOUT NOTICE AND EXPOSE FORD TO WRONGFUL DEATH SUITS DUE TO MECHANICAL DEFECTS IN THOSE SEAT BELT HOLD DOWN CLASPS. I AM CUTTING AND PASTING A COPY OF THIS FORMAL COMPLAINT SO THAT I HAVE A RECORD OF ITS SUBMISSION TODAY DECEMBER 6, 2014 @ 18:20 C.S.T. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR
VEHICLE DESCRIPTION: MINI VANS. THESE VEHICLES WERE PRODUCED WITH A HIGHER THAN SPECIFIED ELECTRICAL LOAD THROUGH THE ACCESSORY POWER FEED CIRCUIT. THE POTENTIAL FOR CONTACT BETWEEN THE B2 (BATTERY), A2 (ACCESSORY), AND P1 (PROOF) CIRCUITS CAN OCCUR, CREATING A SHORT CIRCUIT, ALLOWING CURRENT TO FLOW THROUGH THE GROUND WIRE.
Consequence & remedy
Consequence: THIS CAN CAUSE OVER HEATING AND THE POTENTIAL FOR A VEHICLE FIRE.
Remedy: DEALERS WILL INSTALL A JUMPER HARNESS WITH A RELAY WHICH WILL RE-ROUTE AND ACTIVATE ALL A2 ACCESSORIES THROUGH THE RELAY.
VEHICLE DESCRIPTION: ALL WHEEL DRIVE PASSENGER MINIVANS. THESE VEHICLES CAN DEVELOP POWERTRAIN BENDING RESONANCE OR TRANSFER CASE OUTPUT SHAFT BUSHING DISPLACEMENT. THE POWERTRAIN BENDING RESONANCE OR THE OUTPUT SHAFT BUSHING DISPLACEMENT CAN RESULT IN STRUCTURAL FAILURE OF THE TRANSMISSION AND/OR TRANSFER CASE. FLUID EXPLUSION, DRIVESHAFT SEPARATION OR LOSS OF VEHICLE DRIVE CAN RESULT.
Consequence & remedy
Consequence: THIS CONDITION CAN CAUSE A LOSS OF VEHICLE CONTROL, AND, IF THE EXPELLED FLUID CONTACTS THE EXHAUST SYSTEM, A VEHICLE FIRE COULD OCCUR.
Remedy: DEALERS WILL INSTALL A NEW TRANSFER CASE REAR OUTPUT SHAFT BUSHING AND AN ALUMINUM DRIVESHAFT WILL BE INSTALLED.
THE CERTIFICATION LABELS ON THE INVOLVED VEHICLES HAS INCORRECT REAR TIRE INFLATION PRESSURE DESIGNATIONS. THIS DOES NOT COMPLY WITH FMVSS NO. 120, "TIRE SELECTION AND RIMS FOR MOTOR VEHICLES OTHER THAN PASSENGER CARS."
Consequence & remedy
Consequence: INCORRECT INFLATION PRESSURES COULD CAUSE PREMATURE WEAR OF THE REAR TIRES. .
Remedy: OWNERS WILL BE PROVIDED WITH CORRECT CERTIFICATION LABELS AND INSTRUCTIONS FOR INSTALLING THESE LABELS. DEALERS CAN INSTALL THIS LABEL IF THE OWNER SO DESIRES.
WHEN IN THE SECONDARY LATCHED POSITION, THE DRIVER DOOR LATCHES MAY OPEN WHEN SUBJECTED TO TRANSVERSE LOADS LESS THAN THAT SPECIFIED IN FMVSS NO. 206, "DOOR LOCKS AND DOOR RETENTION COMPONENTS."
Consequence & remedy
Consequence: THE DRIVER'S DOOR, WHEN CLOSED ONLY TO THE SECONDARY LATCHED POSITION, MAY NOT SUSTAIN A 1,000 POUND TRANSVERSE LOAD.
Remedy: DEALERS WILL INSPECT AND, IF NECESSARY, REPLACE THE DRIVER DOOR LATCH.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2
EA99002 · Transfer Cases And Rear Drive Shaft
Opened Jan 7, 1999 · Closed Nov 14, 2000
Status: closed (inferred from source dates) · Power Train
There is no summary currently available
RQ98012 · Transfer Cases And Rear Driveshaft
Opened Jul 31, 1998 · Closed Jan 7, 1999
Status: closed (inferred from source dates) · Power Train:transfer Case (4-WHEEL Drive)
There is no summary currently available
1996 Ford Aerostar Problems, Complaints & Recalls | Skip That Year
Illustration