1998 Fleetwood Bounder

I OWN AND OPERATE A GENERAL REPAIR SHOP. MY TECH REPLACED FRONT WHEEL ABS SENSORS ON FOR MENTIONED VEHICLE. WORKHORSE MFG PART NUMBERS (W8006778) AND (W8006803). WHILE ON TEST DRIVE THE ABS SYSTEM ENTERED FALSE DEPLOYMENT MODE AT 15MPH WHILE APPROACHING A BUSY HIGHWAY INTERSECTION. I HAD TO STAND ON THE BRAKE PEDAL WITH BOTH FEET AND SLAM THE TRANSMISSION INTO LOW TO BRING THE VEHICLE TO STOP. THE NOSE OF THE COACH ENDED BLOCKING HALF A LANE OF TRAFFIC. NO ACCIDENT. FYI, THIS VEHICLE GVW IS 20,000 LBS. ( NOTE: THE FOLLOWING IS TECHNICAL IN NATURE.) I DROVE THE VEHICLE BACK TO THE SHOP TO INITIATE INVESTIGATION. USING A DVOM I MEASURED THE VOLTAGE AMPLITUDE OUT OF THE NEW WHEEL SPEED SENSORS. THE FRONT LEFT MEASURED .068V AC AND THE FRONT RIGHT MEASURED .286V AC. THIS IS THE CAUSE OF THE FALSE DEPLOYMENT. I THEN REMOVED THE FRONT WHEELS TO INSPECT THE SENSORS AND DISCOVERED THE SOURCE OF THE FAILURE. THE REPLACEMENT SENSORS ARE MANUFACTURE WITHOUT LOCATION DOWELS. THE LOCATION DOWELS SET THE CRITICAL CLEARANCE GAP BETWEEN THE RELUCTOR AND SENSOR. THIS CLEARANCE GAP HAS A NARROW PLUS OR MINUS TOLERANCE. WHEN THE TOLERANCE IS LOST THE ABS SYSTEM WILL ENTER A FALSE DEPLOYMENT MODE ( ABS SYSTEM ACTIVATES AND BLOCKS BRAKE FLUID PRESSURE BEING APPLIED TO THE BRAKE CALIPERS ). THE NEW REPLACEMENT ABS SENSORS HAVE NO LOCATION DOWELS THERE FOR TOLERANCES AS DESIGNED ARE NOT ACHIEVED. THIS IS WHY I LOST CONTROL OF 10 TONS OF VEHICLE. THE PART SUPPLIER, PART MANUFACTURER, AND CHASSIS BUILDER HAVE BEEN SERVED FULL NOTICE OF THIS FLAW. THE GM CASE REFERENCE NUMBER IS [XXX]. THANK YOU, [XXX] MASTER ASE TRUCK CERTIFIED MASTER ASE CAR CERTIFIED MASTER ASE ENGINE MACHINIST CERTIFIED ASE L1 CERTIFIED WALWORTH COUNTY CIRCUIT COURT APPOINTED EXPERT WITNESS INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6). *TR

GASOLINE LEAKING FROM CRACKED FUEL LINE BETWEEN MAIN GAS TANK AND GENERATOR ON 1998 FLEETWOOD BOUNDER MOTORHOME. CONCERN ABOUT DANGER OF LEAKING GASOLINE BUT THERE IS ALSO SOME TYPE OF ELECTRICAL CONNECTION DIRECTLY ADJACENT TO LEAK. IF THERE WAS ANY SPARK FROM THIS CONNECTION, IT MAY CAUSE GAS TANK TO EXPLODE. I HAVE RUN THE GENERATOR 3 TIMES WITHOUT RUNNING THE MOTORHOME ENGINE AND HAVE HAD GAS LEAK EACH TIME. *TR

CONSUMER STATES THAT THERE IS A PROBLEM WITH THE GENERATOR MAKING NOISES. DEALER WAS NOTIFIED. THE FUEL LINE WAS CRACKED. CONSUMER HAD TO CHANGE FUEL LINE TO THE COACH GENERATOR (110VAC-5.5 KVA) *MR THE CONSUMER STATES THAT THE FUEL LINE IS INSTALLED FROM OEM CHASIS CHEVROLET TO THE COACH GENERATOR BY FLEETWOOD AND HAS A MATERIAL MANUFACTURING DEFECT WHICH RESULTS IN AN UNSAFE CONDITION ALLOWING HYDRO CARBONS TO VENT INTO THE ATMOSPHERE AND POTENTIALLY ALLOWING THE FUEL TO ESCAPE TO THE HOT SUFACES OF THE ONAN GENERATOR, WHICH CAN RESULT IN A FIRE/PERSONAL INJURY AND OR DEATH. *SCC

A REPAIR MAN CHANGING A FLAT TIRE DISCOVERED THE PROPANE LINE LOCATED IN FRONT OF THE WHEEL WAS BROKEN AND THE WIRE HARNESS ABOVE THE WHEEL WELL COVER WAS SPLIT, THE PROTECTIVE COVER OVER THE WHEEL WAS DESTROYED. THE MANUFACTURER REFUSED TO PAY THE DEALER TO LOOK AT THE DEFECT BECAUSE VEHICLE WAS OUT OF WARRANTY. CONSUMER WILL SEEK LEGAL REIMBURSEMENT FOR MONIES PAID. *JG

I WILL MAKE THIS SHORT. I OWN A RV MADE BY FLEETWOOD. GOING TO FLORIDA WITH FAMILY WE HAD A FLAT TIRE. THE TIRE TORE UP WHEEL WELL COVER AND THEN DESTROYED A MAIN WIRING HARNESS WITH BOTH AC/DC POWER. THE MAIN CONCERN WAS IT ALSO BROKE A GAS LINE, THAT COULD HAVE CAUSED AN EXPLOSION FROM THE SPARKING WIRES. THE MANUFACTURER HAS TOLD ME TO GO TO HELL, THAT THEY WOULD NOT PAY A DIME FOR REPAIR SINCE THE VEHICLE IS OUT OF WARRANTY. THIS IS WRONG AND NEEDS TO BE INVESTIGATED AS MY FAMILY AND I COULD HAVE BEEN INJURED OR EVEN KILLED FROM A GAS EXPLOSION.*AK