IllustrationTHE PASSENGER SEATBELT DOES NOT WORK. THE SEATBELT WILL NOT SLIDE BACK AND FORTH DUE TO CABLE POPPING OUT. PLEASE ADD VIN.*JB
1992 Dodge Colt
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Colt years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 14 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Seat Belts. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Latches/locks/linkages. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
What owners actually said
14 reportsGLASS WAS SCRATCHING BADLY, AND WAS GETTING WORSE. IT WAS WHITE IN COLOR. NOT ABLE TO SEE OUT OF WINDOWS. NOT VISIBLE TO DRIVE. *AK
HARMONIC BALANCER BOLT "BACKED" OUT - WAS ADVISED IT WAS MANUFACTURE DEFECT BUT BECAUSE IT WAS OUT OF WARRANTY IT WOULD NOT BE COVERED - WAS ADVISED THAT IF THEY HAD TO COVER EVERY MANUFACTURE DEFECT THAT WAS OUT OF WARRANTY THAT THEY WOULD "GO BROKE"- I HAD TO REPLACE THE ENGINE WITH A '93 ENGINE (COMPATIBLE W/ MY '92) WHICH HA…
Read full complaint
HARMONIC BALANCER BOLT "BACKED" OUT - WAS ADVISED IT WAS MANUFACTURE DEFECT BUT BECAUSE IT WAS OUT OF WARRANTY IT WOULD NOT BE COVERED - WAS ADVISED THAT IF THEY HAD TO COVER EVERY MANUFACTURE DEFECT THAT WAS OUT OF WARRANTY THAT THEY WOULD "GO BROKE"- I HAD TO REPLACE THE ENGINE WITH A '93 ENGINE (COMPATIBLE W/ MY '92) WHICH HAD 30,000 MILES ON IT, 35,000 MILES AFTER INSTALLING THE ENGINE, THE HARMONIC BALANCER BOLT "BACKED" OUT AGAIN, CAUSING THE ENGINE TO SEIZE UP. I WILL NEVER BUY A CHRYSLER PRODUCT AGAIN!!!!!
THE HOOD OF THE CAR FLEW OPEN WHILE DRIVING IN TRAFFIC. *AK
AUTOMATIC SEAT BELT DOES NOT RETRACT FROM THE RETRACTING MECHASIM , CAUSING IT TO BECOME INOPERABLE. PLEASE GIVE ANY FURTHER DETAILS. *AK
RECALL # 97V073000; MITSUBISHI/DRIVER'S SIDE GUIDE RAIL/CONSUMER STARTED HAVING TROUBLE AFTER HAVING RECALL SERVICE. THE MOTORIZED SHOULDER BELT DOES NOT TRAVEL ON THE RAIL. DEALER WANTS TO CHARGE CONSUMER TO CORRECT PROBLEM. *AK
EXHAUST MANIFOLD IS PRONE TOO WIDE/CRACKING, CAUSING THE EXHAUST TO ESCAPE INTO THE FRESH AIR INTAKE AND THEN INTO THE VEHICLE. WHEN SEARCHING FOR REPLACEMENT, DIFFICULT TO FIND ONE WITHOUT THE SAME PROBLEM. *AK *ML
DRIVER'S SIDE SEAT BELT WOULD NOT RELEASE TO BE USED. BELT WILL RETRACT WHEN DOOR IS UNLOCKED. BELT IS ONLY TRIGGERED BY DOOR CLOSING OR OPENING. *AK SOMETIMES THE DOOR HAS TO BE REPEATEDLY OPENED AND CLOSED TO GET THE BELT TO CROSS OVER CHEST. * YH
VEHICLE STOPPED SUDDENLY WITH NO ENGINE POWER.
AUTOMATIC SEAT BELTS FASTEN TIGHTLY, PINNING FRONT PASSENGERS AGAINST THE BACK OF THE SEAT, CAUSING DISCOMFORT/IMMOBILITY.
Official recalls
297V063002 · Latches/locks/linkages:doors:latch
May 12, 1997
EXCESS LUBRICATION CAN CAUSE THE RUBBER DOOR LATCH SWITCH COVER TO DEFORM, AND THE DOOR LATCH SWITCH TO MALFUNCTION, SO THAT THE SHOULDER BELT ANCHORAGE WOULD REMAIN AT THE A-PILLAR WHEN THE DOOR WAS CLOSED.
Consequence & remedy
Consequence: IN THE EVENT OF A CRASH, THE SEAT OCCUPANT MAY NOT BE PROPERLY RESTRAINED.
Remedy: DEALERS WILL REPLACE THE DOOR LATCH SWITCH WITH A SWITCH THAT UTILIZES REDUCED LUBRICATING GREASE, IMPROVED CONTACT SURFACE, AND A DIFFERENT RUBBER ISOLATION BOOT.
97V073002 · Seat Belts:front:anchorage
May 12, 1997
THE GUIDE RAIL ON THE DRIVER'S SIDE CONTAINS A COVERED CABLE AND ALSO AN ANGLED BELT GUIDE AT THE TOP END OF THE WEBBING. THE COMBINATION OF THESE FACTORS CAN LEAD, OVER TIME, TO THE CABLE'S MOVEMENT EXERTING ABRADING FORCE TO THE LOWER EDGES OF THE CABLE'S CHAMBER, SUFFICIENT TO CAUSE THE CABLE TO DROP OUT OF THE CHAMBER WITH THE SHOULDER BELT ANCHORAGE BECOMING STUCK.
Consequence & remedy
Consequence: IN THE EVENT OF A CRASH, THE SEAT OCCUPANT MAY NOT BE PROPERLY RESTRAINED.
Remedy: DEALERS WILL INSTALL A NEW REPLACEMENT GUIDE RAIL THAT INCORPORATES A DOUBLE LIP DUST SEAL AND AN ANODIC OXIDE COATING.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
2EA96014 · Automatic Shoulder Belt Failure
Opened Jun 28, 1996 · Closed Jun 12, 1997
Status: closed (inferred from source dates) · Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
Additional source detail variants (3)
Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS
PE96007 · Auto Shoulder Belt Failure
Opened Jan 19, 1996 · Closed Jun 28, 1996
Status: closed (inferred from source dates) · Seat Belts
THE AUTOMATIC SHOULDER BELT ALLEGEDLY MALFUNCTIONS OR FAILS