BRAKE PEDAL GOES TO THE FLOOR AT ANY SPEED. VEHICLE DOES SLOW DOWN, BUT NOT FAST ENOUGH. IF SOMEONE SUDDENLY CROSSES IN FRONT OF VEHICLE, HE WOULD BE HIT. PLEASE PROVIDE ANY FURTHER INFORMATION.*AK
1992 Dodge B250
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all B250 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 0 of 11 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Electrical System. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Power Train. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine And Engine Cooling. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
What owners actually said
11 reportsSPEED SENSOR PART HAD BROKEN TWICE. BOLT ATTACHING THE PIECE TO TRANSMISSION WOULD SEVERLY CRACK ACROSS IT INSTEAD OF UP & DOWN. DISTANCE SPEED SENSOR (SPEEDOMETER/ODOMETER) PART WAS 5602.7014. HAVE TAKEN TO DEALER 3 TIMES & THE PART WAS REPLACED 3 TIMES. *AK THE BOLT CRACKED ACROSS ITS DIAMETER IN A CPMPLETE CIRCULAR PIECE.…
Read full complaint
SPEED SENSOR PART HAD BROKEN TWICE. BOLT ATTACHING THE PIECE TO TRANSMISSION WOULD SEVERLY CRACK ACROSS IT INSTEAD OF UP & DOWN. DISTANCE SPEED SENSOR (SPEEDOMETER/ODOMETER) PART WAS 5602.7014. HAVE TAKEN TO DEALER 3 TIMES & THE PART WAS REPLACED 3 TIMES. *AK THE BOLT CRACKED ACROSS ITS DIAMETER IN A CPMPLETE CIRCULAR PIECE. *YH
WIRING UNDER STEERING COLUMN OVERHEAT, CAUSING SMOKING AND MELTING OF PLASTIC COLLAR, WHEN BLOWER MOTOR IS OPERATED ON HIGH FOR OVER A FEW MINUTES. VERY SIMILAR AS '94 TRUCK RECALL #00V135000. REPORTED TO DEALER AND WAS TOLD WIRE HEATING WAS NORMAL.
WHILE DRIVING OWNER SMELLED A BURNING ODOR. WHEN VAN WAS CHECKED FOR THE PROBLEM, THE IGNITION SWTICH / FUSIBLE LINK AND CONNECTORS WERE FOUND BURNED. THEY WERE REPLACED AT OWNER'S EXPENSE. *ML
FAN MOTOR IS DRAWING TOO MUCH CURRENT WHEN A/C IS ON HIGH, CAUSING INSULATION TO MELT, RESULTING IN A FIRE HAZARD.TSB REMEDY DOES NOT WORK.PART HAS BEEN REPLACED 3 TIMES. SWITCH WAS SMOKING INDICATING IMMINENT FIRE HAZARD. *AK
PAINT IS PEELING ON SEVERAL LOCATION ON THIS VAN I UNDERSTAND THIS IS A LARGE PROBLEM WITH DODGE VEHICLES I AM CONCERNED THE WINDSHIELD MAY PULL AWAY WITH THE PEELING PAINT AND LOOSE BOND. I HAVE CONTACTED DODGE ABOUT THIS THEY OFFERED TO PAY FOR HALVE A PAINT JOB BUT IT WAS NO FAULLT OF MINE THAT THE PAINT IS FALLING OFF THIS 3…
Read full complaint
PAINT IS PEELING ON SEVERAL LOCATION ON THIS VAN I UNDERSTAND THIS IS A LARGE PROBLEM WITH DODGE VEHICLES I AM CONCERNED THE WINDSHIELD MAY PULL AWAY WITH THE PEELING PAINT AND LOOSE BOND. I HAVE CONTACTED DODGE ABOUT THIS THEY OFFERED TO PAY FOR HALVE A PAINT JOB BUT IT WAS NO FAULLT OF MINE THAT THE PAINT IS FALLING OFF THIS 30,000 DOLLAR VAN. NO SAFETY DEFECT MENTIONE DIN SUMMARY.
THROTTLE POSITION SENSOR FAILED, CAUSING SUDDEN ACCELERATION.
INTERMITTENT FAILURE OF IGNITION SWITCH TO TURN OVER, ALSO A/C WINDOW BLOWER/POWER WINDOWS/PARKING BRAKE LIGHTS FAILED DUE TO BURNED TWO TERMINALS IN SWITCH.*AK
PURCHASE TRUCK THE FUEL GAUGE WAS REPLACE THREE TIME IS ON IT FOUR ONE PLEASE DESCRIBE . *AK
AUTOMATIC TRANSMISSION FAILURE, WHEN PARKED UPHILL VEHICLE ROLL DOWN INCLINE WHEN AUTO TRANSMISSION WAS PLACED IN PARKED. TT
Official recalls
194V177000 · Seats:front Assembly:head Restraint
Sep 14, 1994
THE FRONT DRIVER AND PASSENGER SEAT BACK HEIGHT DOES NOT CONFORM TO THE REQUIREMENTS OF FMVSS NO. 202, "HEAD RESTRAINTS."
Consequence & remedy
Consequence: CONSEQUENCE OF NON-COMPLIANCE: SEAT OCCUPANTS ARE SUBJECT TO INCREASED RISK OF INJURY IN THE EVENT OF A SUDD STOP OR ACCIDENT.
Remedy: SHERRY DESIGNS WILL PROVIDE AN ATTACHABLE HEADREST FOR THE DEALER OR CUSTOMER TO ADD TO THE SEATS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.
Illustration