2020 Chrysler Pacifica

Transmission shifts very hard from 2nd to 3rd gear and 4th to 5th gear at random times and at random speeds. Sometimes it occurs in parking lots at less than 15mph and other times at highway speed above 65 mph while cruising. This has caused the engine and transmission mounts to fail prematurely. When it was taken to the dealership multiple times, the service department said they could not replicate the issue but opted to reset the computer anyways. This fixed it for about 2 weeks before the issues came back. A computer reset will wipe the transmission shift learning but with normal daily driving it comes back. This should not be considered "normal" or expected behavior.

The contact owns a 2020 Chrysler Pacifica. While the contact's wife was driving at an undisclosed speed, the engine seized in the middle of the road. The contact stated that there was no power to the vehicle. The contact stated that the failure occurred close to the residence, and there was not a lot of traffic. The driver was able to exit the vehicle and get to a safe area. The contact's brother-in-law was contacted for assistance; however, the driver became impatient waiting for assistance. The driver attempted to restart the vehicle, and the vehicle started. The help arrived, disconnected and reconnected the battery cables, and the vehicle was driven to the residence. The vehicle was not diagnosed or repaired by an independent mechanic or dealer; however, the dealer was made aware of the failure. The contact was informed that a recall was issued, but for Hybrid vehicles. In addition, the contact referenced an open investigation for the failure. The contact stated that the failure had occurred twice within two weeks. Additionally, the warning light that the “Auto START/STOP Unavailable” had remained illuminated since August 2025. The manufacturer was not made aware of the failure. The failure mileage was approximately 52,000. The VIN was unavailable.

The vehicle is unsafe to operate and presents an immediate highway safety risk. Shortly after purchase, the vehicle experienced multiple safety-related failures. Headlights were inoperable from the time of delivery, requiring use of high beams at night to see the roadway. This created visibility and traffic safety issues from day one. Within the first month of ownership, the vehicle required towing. The vehicle is a hybrid and could not be shifted into neutral, yet it was dragged with the wheels locked during towing rather than transported on a flatbed. This caused damage to multiple systems. Following the tow, all four tires developed visible bulges consistent with being dragged while immobilized, creating a significant risk of tire blowout at highway speeds. Steering and alignment became unstable, with grinding noises and loss of predictable control. The hybrid underbody shielding was also damaged, leaving components exposed. These conditions have persisted despite repeated notice to the seller and service administrator. A repair facility has confirmed the vehicle is not safe for long-distance or highway travel. The vehicle must regularly be driven at interstate speeds, and continued operation poses a serious risk of crash or injury. The vehicle remains in service only due to lack of alternatives, despite known safety defects affecting steering, lighting, and tires.

I purchased this van in March 2025, it was used about 62000 miles, but dealer said it was in good condition, no issues. In September 2025, a battery light came on, that also activated the Start/Stop could not be used and needed service as well as Service Shifter. I brought the vehicle in and they simply replaced the auxiliary battery and sent me on my way. On November 13th, I was driving and a battery light came on as well as the Stop/Start not available error, and then moments later said "Stop Safely Vehicle will shut off soon". Thankfully I was only moments from home, and made it safely with my 5 children who were also in the van. Obviously this is dangerous as the vehicle stopping while driving can kill myself, my children, anyone in my vehicle, as well as cars around me as I live in a busy area, Tampa, FL. This car had just been given a review in March when put up for sale, and I had brought it in for an oil change, as well as a motor mount replacement, and the aux battery change, before this. My car has been serviced multiple times and this should have been checked or errors/updates reviewed. This auto/stop start seems to be a key in the safety issues as well since that light comes on every time there is an issue. Now the dealer states they are going to replace my PDC, main fuse box, and see if that fixes the error, but I have read that this is an error in many Chrysler Pacificas and mine is another.

Component/System: The propulsion system of my 2020 Chrysler Pacifica Hybrid, specifically a suspected internal transmission wiring-connector short—the exact hardware defect identified in Recall 23V-010 as capable of causing sudden loss of motive power. In my case, both propulsion sources (gas and electric) simultaneously ceased providing power, leaving the vehicle unable to accelerate. The vehicle, its transmission, and all hybrid-system components are available for inspection upon request. When inspected at the Chrysler dealership, technicians retrieved a diagnostic trouble code they acknowledged corresponds to the known wiring-connector short condition. This code was present before any recall procedures were performed. Safety Risk: I was traveling at highway speed with my family, the vehicle abruptly lost all motive power and began decelerating without my ability to maintain speed. I was forced to coast to the shoulder while surrounded by faster-moving traffic, exposing me and other motorists to the danger of a high-speed rear-end collision. Dealer Confirmation: The Chrysler dealer confirmed the presence of the wiring-connector-related fault code and agreed that it aligned with the recall defect pattern. However, they performed only the software update required under Recall 23V-010 and informed me that they would not undertake further inspection or physical diagnosis unless I paid out-of-pocket, despite the safety-critical nature of the failure. They are ignoring the fact that the physical underlying defect is not fixed by the software update, much to my frustration. With this unfixed, the car is not safe to drive IMO. Inspection: The vehicle has been inspected by an authorized Chrysler dealer. No additional parties have inspected it. The dealer did not examine or repair the wiring harness or connector itself, refusing my request to do so. Warnings/Symptoms: A hybrid/electrical-system warning message appeared moments before the shutdown. No prior symptoms

My 12v battery failed and damaged other system components. This is a description of the flaw from a mechanic that had the same problem: There is a major flaw in the Chrysler Pacifica Hybrid. The BPCM (high-voltage battery control unit) has no protection against high-voltage pulses on the 12-volt network. Moreover, the connection diagram of the high-voltage contactors does not contain any elements that could extinguish the counter-induction EMF pulses when the contactors are turned off. That is, when turned off, the contactors in the 12-volt network create high-voltage surges that can burn anything, any block that is connected to the 12-volt network. In my case, the power supply module of the high-voltage battery control unit BPCM was burned. The LG chem battery modules themselves were in perfect order during this malfunction. The circuit of this module is quite complex, the board is multilayered and it was difficult for me to repair it. I have a sloped driveway, and the failure led to my car starting to roll uncontrollably forward into my house. I was luckily able to stop it by throwing blocks under the tires while my wife held down the breaks. When I (or my wife) let go of the powerless vehicle's breaks, it would continue to roll as the power failure prevented the vehicle from either entering park or engaging the emergency break. We barely avoided significant property damage.

At low speeds while turning the wheel there is a severe shudder originating from the steering system resulting in a feeling of loss of control. Possible it’s happening at higher speeds and not as easily detectable. Countless users in online forums report the same exact problem with the solution from the dealer being that the rack and pinion system must be replaced. The volume of complaints seems like this is a defective part. This began when the car had under 30k miles but dealer would not fix under warranty as they “could not reproduce the problem”.

I have a power problem and could not get my wheelchair ramp down. The manual said to push it manually. this would not work, and my wife and I were trapped in this vehicle where we could possibly burn to death. This is a Braun Ability modified vehicle.2 men tried to get it down and couldn't. We called the factory, and they said to pull a fuse at the battery. How can we do this if we are in wheelchairs and beside, we can't get the ramp down to get out.