2013 Chevrolet Volt

Passenger presence does not detect people in it and makes it unsafe for passenger without airbags. This got closed and was state that there was a Chevy program to fix this as cited in the closing . I have called all over Chevy and there is no one who knows anything about this at all. If you know it or if they just started it to make it go away, please tell with with whom I can contact within Chevy to start the process

This is a reoccurring problem that is worsening. It is difficult to replicate (but becoming easier to replicate as the problem worsens). The problem conditions are as follows: -The car is fully charged The following drive conditions are required: - The beginning of a drive, with the car in the fully charged state, is driven in the “L” mode (aggressive regenerative braking), AND the beginning (first mile or two) of the trip includes some conditions that would NORMALLY engage regenerative breaking and redirect energy flow back to the high voltage battery. (E.g.: Beginning a drive by going up a small incline; then proceeding to drive down a decline.) OR - The beginning of a drive, with the car in the fully charged state, is driven in the “D” mode, AND the beginning (first mile or two) of the trip includes almost exclusively conditions that would NORMALLY trigger regenerative breaking and redirect flow back to the high voltage battery. IN BOTH cases: the instrument cluster, during conditions that would reflect regenerative breaking and energy flow back into the high voltage battery, instead reflects suddenly INCREASED electrical OUTPUT despite there being no increased demand for output from the driver. Expected behavior in these conditions would reflect a negative power output while the car is driven in regenerative conditions (e.g.: going down hill). In either of these cases, the final condition is that you fully stop the vehicle (via brake) during the regenerative conditions. DESPITE full depression of the brake, the car jerks forward violently and erratically, attempting to accelerate. Engaging the emergency brake does not cure the condition while the car is still in L or D driving mode, and it will continue to attempt to accelerate while held in place. Shifting in to neutral does stop the behavior. Shifting back to L or D from neutral will cause the vehicle to continue to attempt to accelerate. There are no error codes/lamps and sensors appear normal.

Vehicle went into reduced propulsion mode and then shut-off while driving down the highway. Same issue as recall 18V397000 that was not applied to my VIN number as part of that recall. Please apply recall 18V39000 to my vehicle VIN. Chevy Volt owners also need the NHTSA to issue an edict to GM/ that the reset codes for the ECM/HPCM2 being given to the OBD2 bi-directional scanner companies so owners don't have to pay a ransom to the dealerships and GM to get there cars back up and running.

Engine shuts off randomly...message "Engine not available". Car shut off on freeway at 60 mph. Got to shoulder, cycled start button...Engine started then resumed driving. Has now happened a few times since. Also code related to reduced propulsion... Used OBDII to clear codes but makes no difference. Sometimes the car starts and drives without problem. Other times, Engine rpm very erratic.

While driving, the car developed a brake malfunction. when the brake pedal is depressed you can feel the pedal pulsating and was not slowing down until you pressed harder then the brakes apply abruptly causing risk of rear ending. Upon pulling over to the hard shoulder the pedal pulsating/drumming continued to happen even though the car is completely stopped and is in parking gear. The symptom is similar to the service bulletin PIC5734A. [XXX] The car was driven to the nearest dealership 'Dublin Chevorlet' in Dublin CA and the car has been there for 4 weeks since GM is unable to help resolve the problem. I have reached out to GM and opened a support case. Case number [XXX] ]. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2013 Chevrolet Volt. The contact stated while driving 50 MPH, the vehicle lost motive power with the check engine warning light and low oil pressure warning light illuminated. The vehicle was towed to the dealer where a diagnostic test result was undisclosed; however, the contact was informed that the vehicle needed an ASC high-voltage battery to be replaced. The vehicle was not repaired after the ASC battery was replaced. The contact stated that the propulsion system warning light was illuminated. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 100,000.

This report is in general for EV batteries and low propulsion, BMW also. When system moves to low propulsion the break lights do not eliminate so the vehicle slows very fast as if it is breaking but no break lights turn on, this creates a risk for other drivers, this occurs on steep mountain climbs when mountain mode was not engaged. What I want to happen is when low propulsion mode engages the break lights come on so that other drives can keep safe distance as I pull to the side for battery to recharge. This does not happen that often but when it does occur it creates a scary situation. A electric BMW also did this today. Please request a break light adaption for future EV batteries/Gas Powered vehicles. Keep in mind this is generally for electric cars that have a backup gas engine that powers after battery is depleted, they most often have issues on steep mountain climbs at freeway speeds and or in some cases as I witnessed today when behind a BMW cars slowing very quickly without alarms to other drivers. If the system can generate a low propulsion error warning drivers it can turn the break lights on also in if software is coded correctly. System should turn on break lights when this occurs for BMW and or other electric cars

The contact owns a 2013 Chevrolet Volt. The contact stated that while driving at approximately 45 MPH, the vehicle stalled. The vehicle was able to be restarted. There were no warning lights illuminated. The contact stated that the failure persisted, and the propulsion system warning light was illuminated. The vehicle was taken to the dealer who diagnosed and determined that the battery needed to be replaced. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was approximately 186,000.

When starting the vehicle, which had some charge on the batteries, the engine immediately started and a message appeared on the speedometer screen which stated, "Propulsion Power Reduced,” and another message said, “speed limited to 25mph.” I was in a very busy part of Hollywood running errands for my job when this happened. I felt very unsafe driving under these circumstances as I often need to drive above 25mph to keep up with traffic and cross busy streets to avoid other cars. The vehicle is available for inspection. It has not been taken to a dealership or anywhere else to have the issue looked at. The problem has occurred a few other times. The vehicle has not been inspected by the manufacturer, police, insurance representatives or others. There were no warnings or other symptoms whatsoever prior to this issue occurring.