IllustrationBRAKE FAIL ON OCCASIONS, BATTERY FAILED.
1996 Chevrolet G10
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all G10 years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 1 of 8 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Power Train. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Service Brakes, Hydraulic. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Electrical System. Review the 1 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports0 injury reports
Service Brakes, Hydraulic complaints
2 reportsBRAKE PEDAL GOES TO FLOOR.
Official recalls
296V186000 · Electrical System:wiring:fuses And Circuit Breakers
Sep 26, 1996
WATER INTRUSION INTO THE KICK PANEL AREAS IN FRONT OF BOTH THE DRIVER AND PASSENGER DOORS CAN CAUSE A CORROSION PATH BETWEEN THE BATTERY FEED AND THE ELECTRICAL GROUND.
Consequence & remedy
Consequence: THIS CONDITION CAN CAUSE AN ELECTRICAL SHORT LEADING TO IGNITION AND COMBUSION OF THE PLASTICS IN THE ELECTRICAL COMPONENTS OF THE VEHICLE RESULTING IN A VEHICLE FIRE.
Remedy: DEALERS WILL REPLACE THE 25 AMP CIRCUIT BREAKERS WITH 25 AMP FUSES IN THE FUSE BLOCK; REMOVE A TEMPORARY PAPER FUSE-BLOCK COVER; INSTALL A PLASTIC SHIELD OVER THE FUSE BLOCK; REPLACE AND REORIENT THE POWER DOOR LOCK RELAY (IF EQUIPPED); INSPECT THE REMOTE KEYLESS ENTRY MODULE (IF EQUIPPED) FOR SIGNS OF CORROSION, REPLACE IF CORRODED, AND REORIENT IT; AND APPLY ADDITIONAL BODY SEALER IN KEY AREAS.
96V187000 · Steering:linkages
Sep 26, 1996
THE STEERING LINKAGE ASSEMBY CONTAINS A RELAY ROD TAPERED-STUD ATTACHMENT NUT THAT WAS NOT TORQUED TO PROPER SPECIFICATIONS.
Consequence & remedy
Consequence: THE TAPERED STUD CAN LOOSEN AND THE DRIVER WOULD NOTICE A LAG IN THE RESPONSIVENESS TO STEERING WHEEL INPUTS. EVENTUALLY THE RELAY ROD STUD CAN FRACTURE RESULTING LOSS OF STEERING CONTROL.
Remedy: DEALERS WILL REMOVE THE EXISTING CRIMPED NUT AND INSTALL A NEW NUT TORQUED TO SPECIFICATIONS.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.