2008 Chevrolet Corvette

ON OCTOBER 10, 2020. I WAS DRAG RACING MY 2008 CORVETTE (THAT I DRIVE DAILY ON THE PUBLIC ROADS) AT THE LOCAL TRACK AS I HAVE BEEN ALL THIS SEASON AND PART OF LAST YEAR'S TOO AFTER ACQUIRING THE CAR MID 2019. I HAVE BEEN DRAG RACING FOR THE BETTER PART OF 40 YEARS. I AM SAYING THIS TO ALLEVIATE ANY POSSIBLE THOUGHTS OF ROOKIE MOVES ON MY PART ON THE TRACK, ETC. THE LOCAL TRACK IS AN NHRA SANCTIONED TRACK THAT TAKES SAFETY VERY SERIOUSLY AND THEIR TRACK PREP IS SECOND TO NONE, ESPECIALLY AT THIS PARTICULAR EVENT, THAT IS ATTENDED BY HUNDREDS OF RACERS FROM MANY STATES. I STAGED MY CAR IN THE RIGHT LANE OF THE TRACK WITH "COMPETITION MODE" ENGAGED, AS I HAVE EVERY TIME IN THE PAST. THE CAR LAUNCHED STRAIGHT AND TRUE AS IT NORMALLY DOES. THE RUN WAS COMPLETELY NORMAL AND STRAIGHT UNTIL AFTER CROSSING THE QUARTER MILE FINISH LINE, WHEN I LET OFF THE GAS, THE CAR MADE AN IMMEDIATE HOOK TO THE RIGHT, DIRECTLY INTO THE CONCRETE RETAINING WALL. I BOUNCED OFF THAT WALL, CROSSING THE PATH OF MY OPPONENT IN THE LEFT LANE, IN A NEAR COLLISION, BOUNCING OFF THE LEFT WALL, AND THEN BACK OVER AGAIN INTO THE RIGHT WALL. I WAS ABLE TO GET OUT OF THE CAR ON MY OWN. I WAS COMPLETELY STUNNED, BECAUSE AT THE TIME I HAD ABSOLUTELY NO IDEA WHAT CAUSED ANY OF THIS. NOTHING MADE SENSE. BY THE TIME YOU CROSS THE FINISH LINE, UNLESS THERE'S SOMETHING ON THE TRACK, LOSS OF TRACTION IS HIGHLY UNLIKELY. IN MY OWN INVESTIGATION I RAN ACROSS MULIPLE EVENTS OF THIS PARTICULAR MAKE AND MODEL THAT HAS HAD ACTIVE HANDLING ISSUES THE ONLY THING THAT MAKES SENSE TO ME THAT COULD HAVE CAUSED THIS TYPE OF ACTION WOULD PROBABLY HAVE BEEN A HEAVY BRAKING OF THE RIGHT REAR WHEEL. MY SON RECORDED THIS PASS AND ACCIDENT ON HIS PHONE AND IT SHOWS THE CAR TURNING RIGHT BEFORE ANY BRAKE LIGHTS COME ON. ANY HELP OR INFORMATION YOU CAN SUPPLY WOULD BE GREATLY APPRECIATED. THANK YOU

AN INSTANCE OCCURRED WHERE THE BATTERY LEAKED ACID DOWN PAST THE BATTERY TRAY AND ONTO THE WIRING HARNESSES BELOW. SUBSEQUENT CORROSION OF WIRINGS WITHIN THE HARNESS (OF WHICH CONTAIN APPROXIMATELY FORTY INDIVIDUAL WIRES), CAUSING BREAKS AND SHORTS IN SEVERAL CREATING A HAZARDOUS SITUATION. A NO START CONDITION OCCURRED RESULTING FROM THE AFFECTED WIRES LEADING TO THE ECM AS WELL AS OTHERS CONTAINED IN THE HARNESS. EITHER THE BATTERY TRAY SHOULD BE MODIFIED TO CONTAIN OR ROUTE POSSIBLE ACID FROM LEAKING DOWN PAST IT OR THE FABRICATION OF A LIQUID TIGHT COMPARTMENT BE INSTALLED TO CONTAIN THE WIRING HARNESS ITSELF. SINCE THE HARNESS IS NO LONGER AVAILABLE FROM GM THE CHEVROLET SERVICE TECHNICIAN SPLICED IN NUMEROUS LENGTHS OF NEW WIRES TO BYPASS THE AFFECTED AREAS WITHIN THE HARNESS. LABOR COST OF APPROXIMATELY $3000 FOR THE REPAIR. THERE IS CURRENTLY NO SOLUTION TO PREVENT FUTURE OCCURRENCES OF THIS ISSUE. THUS MAKING THE VEHICLE UNSAFE TO DRIVE OR HOUSE IN PROXIMITY TO PEOPLE AND THEIR PROPERTY.

CATASTROPHIC ABS SYSTEM FAILURE. WHILE TRAVELING ABOUT 30 MPH ON DRY PAVEMENT, THE TAIL END OF THE CAR SUDDENLY FISHTAILED LEFT THEN RIGHT, TURNING AROUND 180 DEGREES, TOTALLY OUT OF CONTROL. THE RIGHT REAR WHEEL STRUCK THE CURB OF THE MEDIAN, SEVERELY BENDING THE RIGHT REAR WHEEL, AND DAMAGING THE RIGHT REAR WHEEL BEARING TOO. UPON EXAMINATION OF THE ELECTRONIC BRAKE CONTROL MODULE AND MAIN ENGINE HARNESS PLUG THAT CONNECTS TO IT, I FOUND MASSIVE ELECTRICAL DAMAGE WITH A HOLE BURNED COMPLETELY THROUGH THE PLUG AND RECEPTACLE, AND PRINTED CIRCUIT BOARD OF THE ELECTRONIC BRAKE CONTROL MODULE. THE ENTIRE ABS PUMP ASSEMBLY AND EBCM HAD TO BE REPLACED AND A NEW PLUG SPLICED INTO THE MAIN ENGINE HARNESS. I NOTIFIED GM BUT THEY REFUSED TO STAND BEHIND THE PRODUCT OR HELP WITH THE REPAIR.