The hub assembly came apart while driving which disabled the steering of the vehicle. We have replaced the hub assemblies 5 times in the last year, due to faulty design of the parts, and were well aware there could be an issue because the first time it happened it didnt lock up completely while driving and would start making a …
Read full complaint
The hub assembly came apart while driving which disabled the steering of the vehicle. We have replaced the hub assemblies 5 times in the last year, due to faulty design of the parts, and were well aware there could be an issue because the first time it happened it didnt lock up completely while driving and would start making a squealing noise. We bought this truck in 2018 with 49000 miles on it and have put 45000 mile on the truck in the last 4 years. That's not excessive and to have to replace an assembly that is supposed to last the lifetime of your vehicle 5 times in a year and a half is ridiculous.
NHTSA ODI #11451449
130,000 miles · Dec 9, 2020
SteeringSuspension
POPPING NOISE FROM THE FRONT END WHEN TURNING LEFT OR RIGHT AND APPLYING BRAKES.COME TO FIND OUT THE FRAME IS CRACKED ON BOTH LEFT AND RIGHT FRAME RAILS AT THE FACTORY WELDS. THIS TRUCK HAS NEVER BEEN IN AN ACCIDENT AND I'M THE ORIGINAL OWNER. THE CHEVY DEALER CONDEMNED THE TRUCK FOR SAFETY REASONS AND SAID THE ONLY REPAIR IS TO…
Read full complaint
POPPING NOISE FROM THE FRONT END WHEN TURNING LEFT OR RIGHT AND APPLYING BRAKES.COME TO FIND OUT THE FRAME IS CRACKED ON BOTH LEFT AND RIGHT FRAME RAILS AT THE FACTORY WELDS. THIS TRUCK HAS NEVER BEEN IN AN ACCIDENT AND I'M THE ORIGINAL OWNER. THE CHEVY DEALER CONDEMNED THE TRUCK FOR SAFETY REASONS AND SAID THE ONLY REPAIR IS TO REPLACE THE ENTIRE FRAME.
General Motors is recalling certain model year 2010-2012 Chevrolet Colorado and GMC Canyon vehicles manufactured from November 9, 2009, through August 28, 2012, for failing to comply with the requirements of Federal Motor Vehicle Safety Standard No. 113, "Hood Latch System." The hood may be missing the secondary hood latch.
Consequence & remedy
Consequence: If the primary hood latch is not engaged, the hood could open unexpectedly. During vehicle operation, this could obstruct the view of the driver and increase the risk of a crash.
Remedy: General Motors will notify owners and instruct them to inspect their vehicle for the presence of a secondary hood latch. Dealers will replace the hood on any affected vehicles, free of charge. The recall is expected to begin on January 17, 2013. Owners may contact Chevrolet at 1-800-630-2438 or GMC at 1-866-996-9463.
GENERAL MOTORS (GM) IS RECALLING CERTAIN MODEL YEAR 2012 CHEVROLET COLORADO AND GMC CANYON VEHICLES, MANUFACTURED FROM SEPTEMBER 9, 2011, THROUGH OCTOBER 19, 2011, FOR FAILING TO COMPLY WITH THE REQUIREMENTS OF FEDERAL MOTOR VEHICLE SAFETY STANDARD NUMBER 208, "OCCUPANT CRASH PROTECTION." THESE VEHICLES MAY HAVE BEEN PRODUCED WITH DRIVER SAFETY BELT BUCKLE ELECTRICAL CONNECTOR TERMINALS THAT DO NOT FIT SNUGLY WITH THE CONNECTOR PINS, CAUSING THE CONNECTION TO BE INTERMITTENT.
Consequence & remedy
Consequence: THE LOOSE CONNECTIONS MAY CAUSE THE DRIVER TO NOT RECEIVE A VISUAL OR AUDIBLE WARNING THAT THE DRIVER SEAT BELT IS NOT FASTENED, THEREBY INCREASING THE RISK OF PERSONAL INJURY IN THE EVENT OF A CRASH.
Remedy: GM WILL NOTIFY OWNERS AND DEALERS WILL REPLACE THE SEAT BELT BUCKLE ELECTRICAL CONNECTOR TERMINALS FREE OF CHARGE. THE SAFETY RECALL IS EXPECTED TO BEGIN ON OR BEFORE DECEMBER 7, 2011. OWNERS MAY CONTACT CHEVROLET AT 1-800-630-2438 AND GMC AT 1-866-996-9463.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2012 Chevrolet Colorado Problems, Complaints & Recalls | Skip That Year
Illustration