2020 Chevrolet Blazer

Very bad clunnk on driver side when hitting any bump on the road and it's loud.dealer ship sold me the car like that . Electrical issue gauge cluster radio cluster turn signals your first camera anything that works off the instrument cluster of the radio TV screen goes off while I'm driving comes back on hit a bump it comes back on no headlights driving at night time. The dealership sold me the car like this.

1) Part that failed per General Motors Chevrolet dealer was the Thermostat along with Coolant Sensor. 2) I was getting warning notices on dash board screen stating (Reduced steering assist) I was also getting a ESC warning 3) Problem has been repaired at GM dealer 4) Parts were replaced by GM dealer/service center 5) ESC warning light that came on for a short time after motor stopped for auto stop / start and then restarted. If auto stop / start was turned off ESC warning did not come on. Reduced steering assist warning would come on but then go off. Finally the service engine light came on and stayed on. 6) GM Service stated Code for engine light was P01F0. Autozone read a P0128 code. 7) From investigating online this seems to be a very common problem with the 2019 and 2020 Chevrolet Blazer with the 6 cylinder engine. Note: I believe this should be a warranty repair due to the fact that 1) This is a known issue with the 2020 Blazer and known poor design 2) The warning about reduced steering assist and 3) ESC warning

Questions Answered Below: What component or system failed or malfunctioned, and is it available for inspection upon request? The vehicle is at a GM Dealership now and is available for inspection. I have not authorized repairs as of yet. I am being told by the dealership: The ball joint on the control arm on the left side seized snapping the axle shaft - causing the tire to to turn out. The dealership has suggested: Mechanical repair costs $1,850, Plus an additional $2,000 due to wheel well damage caused by the failure. Has the problem been reproduced or confirmed by a dealer or independent service center? I am being told by the dealership: The ball joint on the control arm on the left side seized snapping the axle shaft - causing the tire to to turn out. How was your safety or the safety of others put at risk? Due to my slow speed turning out of the parking lot ~10 mph - the vehicle came to a sudden halt. However, had this occurred while driving any faster - it would have been very dangerous and put myself and others at significant risk. Has the vehicle or component been inspected by the manufacturer, police, insurance representatives or others? It was towed by AAA and has been inspected by the GM Dealership. That is the only inspection thus far. Were there any warning lamps, messages or other symptoms of the problem prior to the failure, and when did they first appear? Earlier in the day while pulling out of a parking spot and turning the wheel to the left I thought I felt some type of resistance then it went away as I started driving. No other symptoms or warning prior to the failure.

I WAS DRIVING ABOUT 35MPH GOING STRAIGHT WHEN MY CHEVY BLAZER ACTED AS IF IT 'HIT A BRICK WALL' AND CAME TO A COMPLETE STOP. I GOT OUT AND NOTICED MY RIGHT, FRONT WHEEL WAS COMPLETELY SMASHED INTO MY CAR. SOMETHING HAD COME LOOSE INTERNALLY AND LOCKED UP MY WHEEL. IT DAMAGED MY CAR SO BAD WHERE MY SUSPENSION WAS DAMAGED. IT HAD TO BE TOWED. IT WAS NON DRIVABLE. MY VEHICLE ONLY HAD 1300 MILES ON IT. I DECIDED AT LAST MINUTE TO NOT GET ON HIGHWAY.