Illustration2013 CAN AM SPYDER ST-S. CONSUMER WRITES IN REGARDS TO MOTORCYCLE BRAKE LIGHT REMAINS ON AFTER ENGINE IS OFF, CRUISE CONTROL WILL NOT SET AND MOTORCYCLE GOES INTO "LIMP MODE"(VSS FAULT). *SMD THE CONSUMER STATED THE MOTORCYCLE WOULD GO INTO LIMP MODE WHILE RIDING. *JB
2013 CAN-AM Spyder St
Owner reports · Recalls · Investigations
Limited comparison data
There is not enough comparable history to draw a useful model-year comparison.
About this comparison →How this year compares
Owner complaints by model year
Compare all Spyder St years →Counts vary with age, sales and reporting. They are not failure rates.
What owners reported most
All reported categories
Tap a category to read its complaints. One report may name several components.
When problems were reported
Mileage at the reported incident
Limited mileage data: 19 of 21 reports include usable mileage. There isn’t enough coverage to show a useful chart.
NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.
What to inspect
Issues worth paying extra attention to based on owner reports.
- Fuel/propulsion System. Review the 7 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Engine. Review the 6 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
- Fuel System, Gasoline. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
NHTSA owner reports · September 18, 2026 snapshot.
0 crash reports0 fire reports4 injury reports
Service Brakes, Hydraulic complaints
1 reportsOfficial recalls
113V386000 · Service Brakes, Hydraulic:foundation Components:master Cylinder
Aug 28, 2013
Bombardier Recreational Products (BRP) is recalling certain model year 2013 Can-Am Spyder RT series and ST series motorcycles. The tandem brake master cylinder manifold inlet may melt allowing the brake fluid to leak out.
Consequence & remedy
Consequence: Brake fluid may leak onto a heat source, increasing the risk of a fire.
Remedy: BRP will notify owners and dealers will install heat shields and a heat deflector, free of charge. The recall is expected to begin in early September 2013. Owners may contact BRP at 1-888-638-5397.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0No exact-year investigations in this snapshot.