2013 CAN-AM Spyder St

WHEN BRAKES WERE APPLIED WHITE SMOKE WOULD COME OUT OF THE VENTS AND THERE WAS AN ODOR. THE NEXT DAY WHEN THE SPYDER WAS STARTED WITH THE BRAKE APPLIED MORE SMOKE STARTED POURING OUT AND THE "BRAKE FAILURE" LIGHT CAME ON THE LCD PANEL. THE VEHICLE WAS TRAILERED TO THE DEALERSHIP AND WHEN IT WAS UNLOADED FROM THE TRAILER THE BRAKE FLUID STARTED POURING OUT. THE DEALERSHIP SAID THAT THE MASTER BRAKE CYLINDER HAD MELTED. *TR

THE HEAT BUILD UP UNDER THE BODY COVERINGS HAS MELTED THE TOP COVER OF THE BRAKE MASTER CYLINDER. THE MASTER CYLINDER IS LOCATED INCHES FROM THE EXHAUST PIPE FROM THE REAR CYLINDER. CONTINUED DEGRADATION OF THE PLASTIC COVER WOULD LEAK BRAKE FLUID DIRECTLY ONTO THE EXHAUST, AND COULD LEAD TO A FIRE HAZARD, AS THE BRAKE FLUID WOULD LEAK ONTO THE EXHAUST PIPE JUST BEFORE THE CATALYTIC CONVERTER. *TR

PLASTIC CAP ON TOP OF MASTER CYLINDER MELTED CAUSING BRAKE FLUID TO POUR OUT ONTO THE GROUND. THIS COULD HAVE BEEN A DANGEROUS SITUATION CAUSING A FIRE OR EXPLOSION, SINCE THE MASTER CYLINDER IS TO THE RIGHT AND BELOW THE GAS TANK. ALSO, A RIDER COULD BE TRAVELING AT A HIGH RATE OF SPEED AND SUDDENLY LOSE BRAKE PRESSURE AND HAVE NO WAY TO STOP. ABOUT 3-4 INCHES IN FRONT OF THE MC IS AN EXHAUST PIPE THAT GETS VERY HOT. BRP, THE MANUFACTURER, SHOULD ADDRESS THIS PROBLEM WITH A HEAT SHIELD OR SOME OTHER REMEDY TO KEEP HEAT OFF THE PLASTIC CAP OR REPLACE THE CAP WITH A MORE HEAT-RESISTANT MATERIAL. MORE AND MORE RIDERS THAT OWN 2013 SPYDERS ARE REPORTING THIS PROBLEM. THIS LOOKS LIKE A DESIGN DEFECT. *TR