2019 CAN-AM Ryker

The contact owns a 2019 Can Am Ryker. The contact stated that while making sharp left turns at moderate speeds, the vehicle independently slow downed without warning. The contact stated that the handlebars and the rear tire would vibrate during the failure. Upon investigation, the contact linked the cause of the failure to a defective turn sensor. The contact had taken the vehicle to two dealers for inspection. The manufacturer was notified of the failure. The vehicle was not diagnosed or repaired. The failure mileage was approximately 2,200.

The Stability Control System engages on low speed left turns when it is not required. It does not engage on right turns at similar speed and sharpness of corner. Power is cut to the rear wheel and the right brake engages, causing a "wobble", unsteady, and jumping sensation. This creates unease and the sense of losing control. I've been told this is a common problem that the YAW sensor and sas system is faulting. please get this fixed as it is dangerous.

When making a left hand turn, at any speed over 35mph, the rear of the bike wobbles, and the front tires, at least one if not both begin to automatically brake. I’ve looked into it, it appears to be related to a SAS/VSS issue with the suspension and stability having too much play. I’ve researched and found that so many people reported it to NHTSA that you have an article, 137209. They will not fix this issue under recall because they claim it’s not an issue being reported enough. I can’t afford to have this issue that came from factory fixed because they don’t want to fix their issue. This is a major concern, at highway speed on an overpass I experience this issue daily and I’m afraid it’s going to cause an accident, because when it occurs the bike automatically slows 10-15 mph without me hitting the brakes, and I am worried I’m going to get hit by someone because of a defect in their product.

When making a left hand turn, at any speed over 35mph, the rear of the bike wobbles, and the front tires, at least one if not both begin to automatically brake. I’ve looked into it, it appears to be related to a SAS/VSS issue with the suspension and stability having too much play. I’ve researched and found that so many people reported it to NHTSA that you have an article, 137209. They will not fix this issue under recall because they claim it’s not an issue being reported enough. I can’t afford to have this issue that came from factory fixed because they don’t want to fix their issue. This is a major concern, at highway speed on an overpass I experience this issue daily and I’m afraid it’s going to cause an accident, because when it occurs the bike automatically slows 10-15 mph without me hitting the brakes, and I am worried I’m going to get hit by someone because of a defect in their product.

VSS code is triggered with three codes making the Ryker go into limp mode. It started happening when I was going around turns (left) then eventually it locked me out of full performance. YAW/SAS C0063 and/or C0052 and *C006C) I hit a guard rail as it jolted me. Turns out there are many that have had the same problem when noted threw BRP dealers. So this is a known problem with the pitman steering arm bushings. Mine is most defiantly loose.