2011 BMW Z4

ELECTRONIC POWER STEERING HAS INTERMITTENT FAULTS/ERRORS DUE TO A MANUFACTURING DEFECT, RESULTING IN COMPLETE LOSS OF POWER STEERING. BMW ACKNOWLEDGED THIS ISSUE AND DID A RECALL IN 2012 FOR 2012 MODEL YEAR Z4'S - NHTSA CAMPAIGN ID NUMBER: 12V302000. THE SCOPE OF THE PROBLEM IS WELL BEYOND THE 162 VEHICLES THAT WERE ADDRESSED WITH THE RECALL IN 2012.

THE PARKING BRAKE FAILED WITH AN AMBER INDICATOR SHOWING ON THE DASHBOARD WHEN STARTING THE CAR. HAD TO PUT THE CAR IN GEAR (6SP) AND THEN GET OUT AND CHOCK THE WHEELS IN ORDER TO KEEP THE VEHICLE FROM ROLLING DOWN HILL. INDEPENDANT REPAIR STATION INFORMED ME THERE WAS AN ERROR CODE - 6017 WHEEL SPEED SENSOR DFA_EMF IN THE PARKING BRAKE MODULE. THIS ERROR IS IN FACT A BUG IN THE SOFTWARE AND REQUIRED A NEW VERION OF CODE TO BE LOADED AT THE BMW DEALER FOR A COST OF $430. BMW HAS BEEN AWARE OF THIS PROBLEM SINCE AT LEAST 2013 AND HAS NOT ISSUED A NOTICE OR RECALL. THIS ISSUE AFFECTING HUNDREDS OF BMWS NEEDS TO BE INVESIGATED DUE TO THE OBVIOUS SAFTEY CONCERNS.

EPS FAILED WHILE DRIVING ON STATE HIGHWAY. POWER STEERING ALARM CAME ON AND STEERING BECAME VERY STIFF AND HARD TO STEER. PULLED OFF THE ROAD AND TURNED CAR OFF AND BACK ON. FAULT RESET BUT THE ALARM OCASSIONALLY STILL SOUNDED. TOOK TO BMW SERVICE, CHECKED OUT AND SAID THE EPS BOX NEEDED REPLACED. DEALER SERVICED CAR AND CONTINUED TO DRIVE CAR FOR FIVE MONTHS. THIS TIME STEERING FAILED AGAIN WHILE DRIVING , BUT THE STEERING RETURNED. HEADED TO HOME AND STEERING AGAIN FAILED AND ALARM CAME ON. STEERING NOW IS STIFF AND CANNOT DRIVE. THERE WAS A RECALL (12V3002000) NOV 2011 THROUGH 2012 WAS RECALLED. MY CAR MFG IN OCT. 2011. SO BMW SAID OUR CAR WAS NOT COVERED. I FEEL BMW SHOULD LOOK AT EARLIER CARS AS THIS IS VERY DANGEROUS. IF MY WIFE WOULD HAVE BEEN DRIVING THE CAR WHEN THIS FAILED SHE WOULD NOT HAVE BEEN ABLE TO OVERCOME THE STEERING FAILURE. FIRST FAILURE AT 74,000 MILES.

TL* THE CONTACT OWNS A 2011 BMW Z4. WHILE DRIVING 35 MPH, THE BRAKE PEDAL WAS DEPRESSED, BUT IT FAILED TO STOP THE VEHICLE. THE EMERGENCY BRAKE WAS ENGAGED IN ORDER TO STOP THE VEHICLE. THE VEHICLE WAS TAKEN TO BMW OF ASHEVILLE (649 NEW AIRPORT RD, FLETCHER, NC 28732, (828) 681-9900) WHERE IT WAS DIAGNOSED THAT THE BRAKE BOOSTER NEEDED TO BE REPLACED. THE VEHICLE WAS REPAIRED. THE MANUFACTURER WAS NOTIFIED OF THE FAILURE. THE FAILURE MILEAGE WAS 36,000.

WHEN EXITING A PARKING LOT INTO A CITY STREET, WHEN THE BRAKES WHERE PRESSED, A LOUD POP NOISE WAS HEARD, THEN A HISSING NOISE AND THE BRAKE PEDAL SANK TO THE FLOOR. THERE WAS NO BRAKING POWER AFTER THAT AND MY CAR ROLLED INTO THE STREET OUT OF CONTROL, IT WAS A SCARY SITUATION BUT NO ACCIDENT OR COLLISION OCURRED AT THIS TIME. TO STOP THE CAR THE BRAKE PEDAL HAD TO BE PRESSED VERY HARD ALL THE WAY TO THE FLOOR,THERE WAS NO LEAKEAGE OF BRAKE FLUID. THE BMW DEALERSHIP DIAGNOSED A FAULTY BRAKE BOOSTER.

TL* THE CONTACT OWNS A 2011 BMW Z4. THE CONTACT RECEIVED NOTIFICATION OF NHTSA CAMPAIGN NUMBER: 17V683000 (ENGINE AND ENGINE COOLING). THE PARTS TO DO THE REPAIR WERE UNAVAILABLE. THE CONTACT STATED THAT THE MANUFACTURER EXCEEDED A REASONABLE AMOUNT OF TIME FOR THE RECALL REPAIR. THE CONTACT CALLED BILL PEARCE BMW AT (775) 337-9649 (LOCATED AT 11555 S VIRGINIA ST, RENO, NV 89511) WHERE IT WAS CONFIRMED THAT THE PARTS WERE NOT AVAILABLE FOR THE RECALL REMEDY. THE MANUFACTURER WAS NOTIFIED. THE CONTACT HAD NOT EXPERIENCED A FAILURE. VIN TOOL CONFIRMS PARTS NOT AVAILABLE.

FAILED EPS MODULE WHILE DRIVING. ON THE HIGHWAY GOING ABOUT 60MPH ON A 90 DEGREE DAY. EPS WARNING LIGHT (ALONG WITH PARKING AND ESC LIGHTS) POPPED UP AND STEERING FROZE. AFTER SOME FORCE COULD GET STEERING TO MOVE... SLOWED DOWN AND GOT OFF HIGHWAY. LUCKILY WAS ONLY GOING STRAIGHT AND WAS NOT PASSING OR IN A TURN, VERY DANGEROUS AND SCARY. AFTER TURNING THE CAR OFF/ON - ALL WARNING LIGHTS EXCEPT EPS STEERING RESET. CAR POWER ASSISTED STEERING NOW RANDOMLY GOES ON/OFF. DEALER STATED THERE IS AN OPEN RECALL FOR THIS ISSUE BUT ONLY FOR THE 2012 MODEL YEAR. WELL IT APPEARS THE SAME ISSUE IS ALSO ON THE 2011 AND IT ALMOST KILLED ME. LUCKILY I WAS GOING STRAIGHT AND NOT PASSING OR IN A TURN. DEALER ALSO MENTIONED THE FAILED MODULE IS NOT A REPARABLE BMW PART AND THE ENTIRE STEERING ASSEMBLY NEEDS TO BE REPLACED... SO A VERY EXPENSIVE INVASIVE PROCEDURE TO REPLACE A PART THAT CAN FAIL AGAIN ON A HOT DAY. VOLTAGE ISSUE APPARENTLY WAS FIXED IN THE 2012 MODEL YEAR BUT NOT ON THE 2011. NHTSA SHOULD REVIEW THE RECALL 12V302000 AS THE 2011 MODEL YEAR APPARENTLY ALSO HAS THIS SAME ISSUE AS LUCKILY I JUST LIVED THROUGH IT.

THIS PROBLEM AFFECTS WHEEL STYLE "296" A 19" OPTIONAL ALLOY WHEEL PACKAGE FOR E89 BMW Z4. BMW PART NUMBER 36116785257(REAR WHEEL 19X9) AND 36116785256(FRONT WHEEL 19X8. UNDER NORMAL DRIVING CONDITIONS, MULTIPLE CRACKS DEVELOPED ON INNER EDGE OF RIM LIP LEADING TO LARGE DROP IN TIRE PRESSURE AND POTENTIALLY UNSAFE DRIVING CONDITION. THIS HAPPENED TO (1) OF MY REAR WHEELS. AFTER DOING RESEARCH, I STRONGLY BELIEVE THIS IS A MANUFACTURERS DEFECT AS MANY OWNERS OF THE SAME PARTICULAR WHEEL MODEL "296" ARE EXPERIENCING THE SAME PROBLEMS. IT IS NOTED IN THE FOLLOWING LINK: HTTP://E89.ZPOST.COM/FORUMS/SHOWTHREAD.PHP?T=485935 CONTACTED BMWNA CUSTOMER RELATIONS AND THEY DECLINED TO PROVIDE ASSISTANCE.