2013 BMW X1

I'm not sure If I need to report BMW for declining to repair a recall known as 24V-608. I went to my local BMW dealership Valley Auto World BMW In Fayetteville, NC. The first time we went they said they put a cover over the wiring connector for oil or water dripping from the PCV hose. When we went their were no engine codes and a week after they perform the inspection I got engine codes regarding the water pump codes are U0079 - U019F. I got this when It was at night. The following morning I went out and unplugged the connector and corrosion was on the connector. I proceed to clean the connector pins with isopropyl alcohol and a tooth brush. I also added Dielectric grease to the inside of the water pump connector before I found out that there was corrosion on the connector pins. The codes did not go away. The following morning the pump stopped working so I removed It and corrosion was on the pins for the water pump. I took It to the dealership and the said neither corporate or the dealership would not repair the vehicle because they said they got photos before they put the connector protector on and I said I got photos after they put It on. They are trying to pull you removed It so It was your fault. Like I have the right to repair my own vehicle and you still want to make It seem like I'm the one who put the corrosion there just to get a free pump. I stood In the rain trying to repair the vehicle on the lot but they said we had to get off the property and called the cops. The cops let us continue adding a replacement pump to the car and after I got It on there the engine lights went out.

Approximately 8 months ago, I brought my car to the BMW dealership Keeler's in Latham, NY 12110 for a Recall 24V-608:474, the dealer held my car for a day. Two weeks later after taking my car in for the recall, my check engine light started going off and on, off and on, then it comes on and stayed on. On certain occasions I smelt burning wiring and antifreeze smell, yet I assumed that those particular smells come from outside through the car vents. The weather was in the fall season, so I never turned on the AC to make sure the cold air was working, the heat was working. It wasn't until the weather was getting warm that I try to use the Cold air in my car that I notice that there was nothing but hot air coming out and not the ice-cold air that I was getting before I took it to the BMW dealer in Latham. I connected a code reader to my car and the codes that come back were U019F and U0079 which stated that is was a lost communication with the Engin coolant pump. I call BMW and tell them about my complaints; they told me to bring in my car to get it look at. I brought the car to Keeler. The Service Advisor Daniel Purpura told me that my car has be reset and a shelter cap replace and the shop mechanic drove it, and now the check engine light is off. When I went to start the car the engine light was back on, and I told him that. He told me that the code they found was code 003B97. The 003B97 is not the recall code, but it was caused by the recall work. Under federal recall law, any defect created during recall repair must be corrected at no charge. I purchased this vehicle with my own funds and am the person responsible for its maintenance, safety, and recall compliance. The vehicle is titled, registered, and insured in my fiancée name who holds the valid driver’s license for the household. Although the paperwork is in her name, I am the beneficial and equitable owner of the vehicle and who tried to get the recall.

Coolant Pump Electrical Connector Recall #24V-608 Program Control Units (DME) Recall #20E-A01 I am following up because my dealer was unable to complete the DME recall, and the coolant pump recall still shows as incomplete in NHTSA. My vehicle was moved off-site without my consent. I received no updates or documentation, and the dealer was dismissive. My car’s condition has declined due to unresolved recalls. I have already spent over $2,000 replacing the coolant pump and now face a $5,000 repair quote and potential off-site garage fees. Description of the issue: Dealer failed to complete DME recall Coolant pump recall shows as incomplete Vehicle moved off-site without your consent Customer Relations unhelpful and rude Financial impacts ($2k coolant pump repair in December, $5k quote, off-site fees) Requests: 1. Confirm in writing which recalls are open and applicable to my VIN. 2. Properly complete the DME recall (#20E-A01) at no cost, including any module replacement. 3. Ensure NHTSA reporting for #24V-608 is accurate. 4. BMW must restore my vehicle to proper operational standards. 5. Reimburse reasonable costs caused by the dealer’s mishandling, including garage fees and prior repair costs. 6. Provide a case number and timeline for all actions.

The contact owns a 2013 BMW X1. The contact stated that while shifting into park(P) and turning off the vehicle, there was white smoke coming from under the hood and entering the cabin through the air vents. No warning light was illuminated. The vehicle was driven to the residence; however, the failure progressed. The vehicle was towed to a local dealer and remained for additional tests. BMW of Minnetonka (15802 Wayzata Blvd, Wayzata, MN 55391) and Walser Subaru St. Paul (740 Concord St S, South St Paul, MN 55075) were contacted; however, the parts were not available for the repair. The contact believed that the failure was possibly related to NHTSA Campaign: 24V608000 (Engine and Engine Cooling, Electrical System); however, the contact was not notified of the recall. The contact stated that upon further investigation, Metrowerks BMW (1300 American Blvd W, Bloomington, MN 55420); was contacted for parts availability. The manufacturer was not made aware of the failure. The failure mileage was approximately 82,000.

The contact owns a 2013 BMW X1. The contact stated that after turning off the vehicle, upon return to the vehicle, there was an abnormal burning odor outside the vehicle. No warning lights illuminated. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was not yet available. The local dealer was contacted; however, the vehicle was not diagnosed or repaired due to the cost of the diagnostic test. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 80,200. Parts distribution disconnect.

The sensor on the electric water pump failed and caused the water pump thermostat and alternator to stop working and the truck to catch on fire. I uploaded proof below that I reported there was a problem since approximately 2021 to a certified bmw dealership and everything else was fixed but that. And I paid for the extra video inspection every time the same year model everything has been recalled and my family was put in danger and nothing done???? I have several other invoices as well BMW told me to contact you all Just seems like no one cares about my family’s lives I have like 10 more invoices and the final repair invoices

The contact owns a 2013 BMW X1. The contact received notification of NHTSA Campaign Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2013 BMW X1. The contact received notification of NHTSA Campaign Number: 24V608000 Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted. The vehicle was not diagnosed or repaired. The dealer confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2013 BMW X1. The contact received notification of the NHTSA Campaign to Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The dealer was contacted and confirmed that parts were not yet available. The vehicle was not diagnosed or repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

The contact owns a 2013 BMW X1. The contact received notification of the NHTSA Campaign to Number: 24V608000 (Engine and Engine Cooling, Electrical System); however, the part to do the recall repair was unavailable. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was contacted and confirmed that parts were not yet available. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.