2016 BMW I3

While driving my 2016 BMW i3 with Range Extender, the vehicle experiences sudden and complete loss of propulsion at very low state of charge (0–1%). The car abruptly loses motive power, forcing me to pull over, sometimes while in traffic. After sitting for several minutes, limited power may return, but the vehicle often shuts down again, and in some cases the Range Extender engine does not engage at all. This has occurred repeatedly and creates a serious risk of being stranded or hit while merging or driving on public roads. BMW has inspected the vehicle twice (07 Nov 2025 and 13 Jan 2026) and confirmed the loss of propulsion and need to pull over but classified the behavior as “normal” without performing high-voltage battery diagnostics. The failure appears consistent with high-voltage battery voltage collapse under load, causing the battery management system to shut down the drivetrain. This is not normal power limiting — it is a sudden drivetrain shutdown that occurs without warning and poses a significant safety hazard.

Loses power "without warning"; actually, when the REX turns on it automatically mentions that power "could be" lost when the REX turns on. However, that is very understated. In fact, there is nowhere in the owner's manual that raises this issue; doesn't even mention that there could or would be a "warning" if battery is low and REX is being used. Bottom line: The REX cannot keep up with driving. Please refer to: https://www.youtube.com/watch?v=hmn58reGv8k The above is identical to my experience. Especially VERY DANGEROUS when on the interstate highway. I was looking for an exit so that the battery might recharge a bit because I could only go 25-35 mph. Seems like the REX is warming up and not outputting standard power, as expected... It might be that the problem is that the computer is not calculating the correct state of charge and therefore not giving the REX enough time to complete its warm-up cycle.? Or it should kick in earlier than single digit battery strength left. I started recording at 9% SoC and I was expecting this power loss. I found a safe(r) road to do this on with minimal traffic. Fast Forward to 2:59 to see the power-loss happen. The first time this happened I was on the highway, that was not fun. To quote another driver with the same issue (see YouTube earlier), "Power-loss due to low charge should be gradual and with a warning, not this sudden. This makes for a dangerous situation if I'm on the highway or hill. I know that enabling 'hold state of charge' before 7.5% is a 'manual workaround' but that is NOT a fix. HSOC is not even an option on the REX in the USA - you have to unhide the menu via a coding change."