2008 BMW 550I

Vehicle abruptly shut off while reversing out of my driveway. Vehicle restarted after a long crank and appeared to enter a reduced power mode/limp mode with a transmission fault that locked the transmission in 4th gear. Reading OBD2 codes revealed a code for the crankshaft position sensor. Inspection of the 3 terminal sensor revealed 2 of the terminal contacts on the sensor to be shorted out with melted plastic on both the sensor and the wiring connector plug. Shorted wire could be a result of a leaking coolant passage at rear of engine within bellhousing where sensor is located. Coolant intrusion into sensor connector resulted in electrical short and melted connections.

The contact owns a 2008 BMW.The contact stated that he was getting ready to drive the vehicle, however when he started the vehicle, the ABS and check engine lights illuminated.The contact stated that he noticed the vehicle was overheating and turned the vehicle off.The contact heard an unusual sound which came from under the hood.The contact inspected and noticed that the coolant reservoir lid had detached and dented the hood due to the vehicle overheating.The vehicle was not diagnosed or repaired by an independent mechanic or dealer.The manufacturer was made aware of the failure and provided no assistance.The failure mileage was approximately 65,000.

The daytime running lights aka Angel Eyes wiring is sub-standard. The plastic coating on the wires for the daytime running lights/Angel Eyes has melted away exposing bare wiring that has fused causing the lights to malfunction and not work. I believe the manufacturer is aware of this sub-standard issue and needs to provide a suitable fix or replacement for the sub-standard wiring of their product.

I was driving and came to a stop and noticed smoke and an odd smell coming from under the hood. The heater control valve and the wire connector started to smolder and melt the plastic. If it wasn’t for me disconnecting the connector wire to the heater control valve, it would have definitely would have caught on fire.There was no warning other than the smoke and smell coming from the car. I am in the process of the car getting inspected from a bmw service center

The contact owns a 2008 BMW 550I. The contact stated while driving 65 MPH, the accelerator pedal was depressed however, the vehicle failed to respond. There was no warning light illuminated. The contact pulled over to the side of the roadway and turned off and restarted the vehicle however, the battery warning light illuminated and remained illuminated. The vehicle was taken to an unknown dealer and was previously repaired under an unknown recall. The vehicle was not repaired. The manufacturer was notified of the failure. The approximate failure mileage was 141,000.

I WAS DRIVING ON THE FREEWAY AND THE POWER TRAIN LIGHT CAME ON AND THE CAR BEGAN TO LOOSE A LOT OF POWER THEN WHEN I PULLED TO SIDE OF THE ROAD THE CAR TURNED OF AND WOULD NOT START UNTIL SEVERAL ATTEMPTS . I WAITED ABOUT 8 MIN THEN STARTED TO DRIVE . AND IT DOES THIS ALL THE TIME NOW . THEN THE LIGHT GOES OUT AND DRIVES FINE . BUT THIS ALWAYS HAPPENS . AND IT'S VERY DANGEROUS. I'VE BEEN IN SOME TIGHT SITUATIONS.

I HAVE BEEN IN CONTACT WITH BMW OF NORTH AMERICA FOR 8 WEEKS. MY 2008 BMW 550I CAUGHT FIRE WHILE STATIONARY AT A GAS STATION AT THE GAS PUMP. THE FIRE DEPARTMENT WAS CALLED OUT TO CONTAIN THE FIRE. THE FIRE INSPECTOR AND THE FIRE CHIEF BOTH STATED THAT IT WAS A WIRING ISSUE. I HAVE THE FIRE REPORT. I WAS FINALLY ABLE TO GET BMW OF NORTH AMERICA TO INSPECT THE VEHICLE ON FEB. 5, 2018 AND WAS TOLD THERE 'LOOKS LIKE THERE COULD HAVE BEEN'WORK DONE TO THE WIRING OF THE CAR. I HAVE OWNED THE VEHICLE SINCE APRIL 2017 (7 MONTHS) AND HAVE NOT DONE ANY WORK TO THE WIRING. I ALSO PULLED A CARFAX REPORT BEFORE PURCHASING THE VEHICLE. IT SHOWED 0 ACCIDENTS AND 0 MAJOR MECHANICAL WORKING. I ASKED BMW FOR A COPY OF THE INSPECTOR'S REPORT AND WAS DENIED. THAT REALLY MADE ME SUSPECT SOMETHING FOUL FROM BMW.