1997 BMW 328I

AFTER SEEING YET ANOTHER REAR END COLLISION, I WOULD LIKE TO MAKE A SUGGESTION I HAVE HAD IN MIND FOR A LONG TIME. I BELIEVE WE CAN REDUCE THE INCIDENCE OF SUCH ACCIDENTS, BY FLASHING THE STOP SIGNALS WHENEVER THE BRAKES ARE ON AND THE CAR IS STOPPED ( REQUIRES A SPEED SENSOR, OF COURSE). MANUAL FLASHING ELECTRONICS EXISTS IN EVERY MODERN CAR, BUT IS NOT NORMALLY USED WHEN STOPPED ON THE ROADWAY.

THE LOCKING DEVICE ON A 1997 BMW 328I INTERMITTENTLY MAKES IT IMPOSSIBLE FOR OCCUPANTS TO EXIT THE VEHICLE IF IT IS LOCKED WHILE OCCUPIED. THIS IS A SAFETY RISK, WHICH CREATES A HIGH DANGER AND SEVERITY OF RISK OF INJURY OR DEATH TO CONSUMERS AND/OR USERS OF THE VEHICLE IF AN OCCUPANT STAYS IN A VEHICLE THAT IS LOCKED. DESPITE KNOWLEDGE OF THIS SAFETY RISK, BMW FAILED TO CORRECT THIS DEFECT AND ADVISE OR WARN PURCHASERS OR POTENTIAL USERS, INCLUDING THE PURCHASERS, OWNERS AND/OR USERS OF THE SUBJECT 1997 BMW 328I, BY PROVIDING ADEQUATE WARNINGS AND/OR NOTICES OF THE SEVERE RISK OF INJURY OR DEATH IF AN OCCUPANT STAYS IN A VEHICLE THAT IS LOCKED. ON OR ABOUT SEPTEMBER 11, 2013, A HOT AND SUNNY DAY, A FEMALE YOUTH WHO WAS AN OCCUPANT OF A 1997 BMW 328I, BECAME TRAPPED IN THE SUBJECT 1997 BMW 328I THAT WAS LOCKED. IT WAS IMPOSSIBLE FOR THE YOUTH TO EXIT THE VEHICLE, AND SHE ULTIMATELY SUCCUMBED TO HEAT STROKE AND DIED WHILE TRAPPED IN THE VEHICLE.

1997 BMW 328IS WITH 179K MILES. AFTER DRIVING FOR MORE THAN 30 MINUTES (HIGHWAY OR CITY), MY STEERING WHEEL WILL BIND OR GET TIGHT IN A TURN. AFTER MUSCLING THROUGH THE TURN SO I DON'T CRASH, THE STEERING WHEEL "POPS" AND RETURNS TO NORMAL OPERATION. THIS HAS BEGAN TO HAPPEN DAILY AND I AM CONCERNED FOR MY SAFETY AS WELL AS ANYONE IN THE CAR WITH ME! *TT

1997 BMW 328I LESS THAN 80,000 MILES. DRIVING 40MPH WITH CRUISE CONTROL ON. SNOWING BUT STRAIGHT LEVEL CONCRETE ROAD. APPROACHING ASPHALT CURVE ENTERING SMALL MOUNTAIN VILLAGE, I TAPPED BRAKE TO DISENGAGE CRUISE. IT DIDN'T DISENGAGE SO HIT IT HARDER. CRUISE STARTED TO ACCELERATE AND THREW CAR INTO A SKID. TRIED STEERING COLUMN LEVER, NO EFFECT. CRUISE NOW ACCELERATED STRONGLY, SPUN CAR 180, CAR SLID INTO DITCH AT UNDER 30MPH AND FLIPPED OVER. CAR DRIVEN BACK 600 MILES TO HOME BUT TOTAL LOSS FROM CRUSHED IN ROOF. BMW HAS POSSESSION OF THE CAR PENDING PRODUCT SPECIALIST REVIEW. CRUISE HAD STARTED ACTING ERRATIC ON 4-5 OCCASIONS EARLIER THAT WEEK BEING RELUCTANT TO DISENGAGE WITH TWO DIFFERENT DRIVERS. AFTER ACCIDENT 3 WITNESSED THAT BRAKE LIGHTS FAILED TO LIGHT WITHOUT EXCESSIVE PETAL PRESSURE. MANY BMW OWNER REPORTS OF SAME PROBLEM ON INTERNET FROM BRITAIN. BMW SERVICE ADVISOR STATED IT WAS PROBABLY THE SWITCH STARTING TO FAIL. BMW DEALER NOW HAS CAR AND BMW CORPORATE APPEARS TO HAVE ISSUED GAG ORDER TO DEALER EMPLOYEES. *TR

TL*THE CONTACT OWNS A 1997 BMW 328I CONVERTIBLE. DUE TO HIS BODY STATURE, THE CONTACT WOULD HAVE TO LEAN THE SEAT BACK IN ORDER TO USE THE SEAT BELT EFFECTIVELY. HE CONSULTED THREE DEALERS FOR SEAT BELT EXTENDERS, BUT NONE HAD THEM AVAILABLE OR WERE NOT BEING SOLD. THE MANUFACTURER STATED THAT THEY DID NOT HAVE SEAT BELT EXTENDERS FOR THAT MODEL. THE CURRENT MILEAGE WAS 159,882 AND FAILURE MILEAGE WAS APPROXIMATELY 159,800.

SUDDEN FAILURE OF IGNITION COIL RESULTING IN A SHAKING/VIBRATING VEHICLE. WHILE ACCELLERTING IN CITY TRAFFIC THE CAR CAN LUNGE AND JERK WHILE ACCELLERATING, RESULTING IN UNPREDICTABLE ACCELLERATION. IN CITY TRAFFIC THIS IS VERY DANGEROUS. I HAVE INVESTIGATED THE IGNITION COILS FOR BMW 3 SERIES CARS AND IT APPEARS THEY FAIL A LOT, YET THERE IS NO RECALL CAMPAIGN! AFTER INVESTIGATING FURTHER IT APPEARS BMW HAS SOME RECALL CAMPAIGNS FOR SOME OF THE NEWER CARS. THEY SUGGEST REPLACING ALL IGNITION COILS WITH A NEW BOSCH MODEL. MY CAR HAS BREMI MODEL COILS (PART NO. F3000-86682) AND THERE IS NO BOSCH SUBSTITUTE ACCORDING TO THE BMW DEALER (PLAZA MOTORS IN ST. LOUIS, MO). I FOUND AN EPA RECALL NUMBER FOR THE BREMI COILS FOR ANOTHER MODEL BMW AT THIS WEB SITE: REFERENCE: HTTP://WWW.EPA.GOV/OTAQ/CERT/RECALL/420B04018.PDF EPA# 2061 IT DESCRIBES AN INTERNAL FAILURE AS FOLLOWS: "BECAUSE OF PRODUCTION PROCESS FAILURES, THE IGNITION COIL OF ONE SUPPLIER (BREMI)MAY HAVE AN INTERNAL INSULATION BREAK-DOWN IN THE PRIMARY ELECTRIC 2121 CIRCUIT, THE SECONDARYELECTRIC CIRCUIT AND/OR A DISRUPTIVE DISCHARGE. REMEDY: BMW HAS DECIDED TO IMPLEMENT A VOLUNTARY EMISSION RECALL CAMPAIGN TO REPLACE ALL IGNITION COILS WITH A NEW IMPROVED VERSION." THE SAME EXACT THING IS HAPPENING TO BMW 3 SERIES CARS. A REVIEW OF BMW FORUMS ON THE INTERNET EXPLAINS THAT THIS PROBLEM IS OCCURRING MORE FREQUENTLY BY THE DAY. I WOULD LIKE THIS TO BE INVESTIGATED AND A RECALL CAMPAIGN INITIATED AS SOON AS POSSIBLE BEFORE SOMEBODY GETS HURT!