2022 Audi E-TRON

While driving, the vehicle displayed three simultaneous warnings — “Drive system malfunction, safely stop vehicle,” “Electrical system malfunction, restart not possible, contact service,” and “All-wheel drive malfunction, limited stability” — and lost propulsion completely. This occurred on at least two separate occasions while driving. After each event, the vehicle would not restart for approximately 15 minutes, after which it began working again temporarily. The vehicle was taken to an authorized Audi dealer, which found no coolant in the front drive motor and diagnosed a fault in the SX6 high-voltage battery switching module, which controls connection of the high-voltage battery. The SX6 module was replaced. This followed a separate repair approximately three months earlier for a failure of the J1050 high-voltage battery charger control module, which had to be replaced twice due to communication failures with the vehicle’s electrical system. I am concerned this represents a recurring high-voltage electrical system defect that creates a risk of sudden loss of vehicle control/propulsion while driving.

The vehicle is experiencing an intermittent but active 'Electrical system: malfunction!' safety alert on the dashboard and myAudi app, caused by an internal high-voltage battery cell circuit fault (Diagnostic Trouble Code P0DB400 / U04A300) and a failure in the battery thermal runaway detection system. When the fault occurs, the vehicle suffers a complete loss of regenerative braking, severely affecting stopping predictability and vehicle handling. An authorized Audi dealership (Audi West Chester) confirmed the internal module failure under TAC Case NF-1675032 and directed a full battery module replacement. Diagnostic scans have confirmed two highly critical manufacturer trouble codes: P0DB400 (Hybrid/EV Battery Cell Balancing Circuit "C") and U04A300 (Invalid Data Received From Hybrid/EV Battery Interface Control Module "C"). However, a second dealership (Audi Cherry Hill) is refusing to honor the High-Voltage Battery Warranty or perform the necessary repairs because the safety code is currently showing as 'static' during their stationary test. Leaving an active high-voltage balancing and thermal tracking defect unaddressed poses an immediate risk of a sudden vehicle shutdown while driving or a potential thermal event.

The contact owns a 2022 Audi E-Tron. The contact stated that while driving at various speeds, the vehicle independently switched to SAFE Mode and failed to properly accelerate while depressing the accelerator pedal. Additionally, the mileage range was reduced, and the battery recharging time increased. The failure started after the vehicle was repaired under the NHTSA Campaign Number: 23V867000 (ELECTRICAL SYSTEM). The vehicle was taken to the local dealer, but no failure was found with the vehicle. The vehicle was later taken to an independent mechanic who reported that the amperage of the battery had been reduced from 400 amps to 130 amps. The manufacturer was notified of the failure, but no assistance was offered. The failure mileage was 16,000.

CATASTROPHIC ELECTRICAL FAILURE - SMOKE IN CABIN While driving with passengers, dashboard displayed "ELECTRICAL FAILURE - PULL OVER WHEN SAFE" followed by loud explosive POP and cabin filled with SMOKE. ROOT CAUSE: Prior undisclosed collision damage. Dealer (Morrie's Golden Valley Cadillac) removed front bumper in June 2025 (Repair Order #78683), then sold vehicle as "no accidents" in August 2025. Subsequent inspection revealed cut wiring and improper repairs (Invoice #94609). CURRENT STATUS: Vehicle inoperable 3+ months. Audi corporate technicians have repaired major problem however vehicle still has charging issues that happened right before the catastrophic failure unable to repair. SAFETY CONCERN: Smoke-filled cabin endangered occupants. Potential fire hazard.

The vehicles software system regularly crashes and/or does not load leaving all camera functionality and safety alerts inoperable. I have had the vehicle in to address these concerns 5 times with no resolve from the manufacturer. Even with video evidence they claim the vehicle is functioning as intended. This is in direct violation of FMVSS 111 as the rearview camera is regularly not available. Sometimes the system reboots within seconds and sometimes it takes 10 minutes or more.

The car occasionally does not respond to pushing the pedal to accelerate. The first time it happened, I though it was user error after sitting at a light. Well within the same 30 minutes it happened again entering a carwash. Today I was sitting at a light waiting for it to turn green. Once green, I pushed the accelerator to go and the car would not accelerate. This is the second time in two weeks and approximately fifth time since I purchased the car in October 2023. No dashboard warning prior to this.

The contact owns a 2022 Audi E-Tron. The contact received notification of NHTSA Campaign Number: 23V867000 (Electrical System); however, the part to do the recall repair was not yet available. The local dealer was not contacted. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was not made aware of the issue. The contact had not experienced a failure. VIN tool confirms parts not available.

Audi issued a recall notice in December 2023 regarding the high voltage battery possibly causing a fire. In the past 15 months since the recall I have not received any correspondence from Audi on a fix. I have checked with my Audi service manager several times and he stated Audi is monitoring the vehicle high voltage modules. I feel 15 months is excessive time for the manufacturer to provide a fix/repair to close the recall. This also affects the ability to trade or sell the car with a unrepaired recall.

I was driving on the interstate freeway in normal conditions when my 2022 Audi E-tron suddenly showed a message "Electrical system malfunction!" and lost all power to the motors. Thankfully I was in the rightmost lane already and I was able to steer and coast over to the shoulder even while pressing the gas pedal had no effect. If I had been in another lane it could have led to a major accident if my car stalled in the middle of a busy freeway. I had the vehicle towed to the local Audi dealer service center, but so far they have not been able to diagnose the problem.

The contact owns a 2022 Audi E-Tron. The contact received notification of NHTSA Campaign Number: 23V867000 (Electrical System); however, the part to do the recall repair was not yet available. The contact stated while charging the vehicle, the contact noticed that the charging outlet was burned and melted, and the juice box, the plug, and the charging cable had melted, nearly causing the contact's residence to catch on fire. The vehicle was taken to the dealer, where the onboard diagnostic software was installed on the vehicle and an unknown kit was replaced as an interim repair. The vehicle was not repaired. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The manufacturer was made aware of the failure. The failure mileage was approximately 13,000. VIN tool confirms parts not available.