2020 Audi A4

My 2020 Audi A4 has an open safety recall campaign. Audi Corporate and my local dealership are formally refusing to perform the recall remedy unless I pay over $2,000 out-of-pocket to replace a broken J949 SOS Telematics Module. The manufacturer claims the module is separate from the recall, but its total failure physically blocks their diagnostic tools from applying the mandatory safety update. Conditioning a federal safety recall on a customer-paid repair violates recall compliance regulations, and has left my automatic emergency crash reporting and vehicle communication systems completely disabled.

The contact owns a 2020 Audi A4. The contact stated that while driving at an undisclosed speed, the message SOS module no longer connected was displayed on the instrument panel, and the vehicle failed to shut off. The contact believed that the failure was a safety issue due to the loss of communication, including the hands-free features, mobile phone connectivity, and the regular safety features failing to operate as needed. The vehicle was taken to a dealer to be diagnosed, and it was determined that the communication module failure was the same as the SOS module failure. The vehicle was not repaired. The manufacturer was notified of the failure. The failure mileage was 54,000.

The contact owns a 2020 Audi A4. The contact stated that the emergency-call/communication system was inoperable. The vehicle was taken to the local dealer to be repaired under TSB: 91-20-29; however, the software update was unsuccessful due to the module. The dealer informed the contact that the module needed to be replaced. The vehicle was not repaired. The contact had not experienced a failure prior to the vehicle being taken to the dealer. The manufacturer was contacted, but no assistance was provided. The failure mileage was approximately 26,000. The VIN was not available.

A metal bracket on the back left side of the driver seat snapped suddenly while driving straight and at a constant speed. Since this part is broken the seat is no longer connected to the track in that corner. The car is drivable for me because I am tall and sit with the seat at its lowest height setting. When turning or breaking quickly the seat moves, and it would obviously be a safety issue if I get into an accident. If the seat is adjusted higher it is not supported in that corner and it leans back. Yesterday I dropped it off at the dealer service center and they said it is the seat frame. I have not heard back from them yet. I am the first owner of this car, and it has not been in any serious accidents (I hit a deer once roughly 2 years ago). I am not unusually heavy.

Since I purchase my vehicle I have had to continuously replace my tires on the front. Going through my carfax acct I came across some recalls that showed up that I had no idea of the car may had which was prior to purchase from the dealers. I would think that these issues were fixed prior to reselling. I recently had to pull over on the freeway due to the tire making noises then realized that the tire wear was uneven again but this time shredded apart. I could feel metal poking out which the tires hadn’t been on for long. The loss pressure warning light went off. I later found the missing tire that has came off wrapped around the rotor which the tire shop near me hadn’t seen while replacing with new tires again. The wear on the brake pads were off as well as the rotors which I also ended up having to replace just recently. I’ve made an appointment with a dealer which is out of my way to hopefully have this resolved but needed to make a report of this safety issue.

Many times while driving the Audi MMI system which controls all radio/navigation/controls screen will completely shut off and reboot, leaving the screen blank and functionality gone. When researching online many others have reported the same issue, with Audi unable to provide a definitive cause or a fix for the issue. This is a safety issue as it could cause distraction while driving

My 2020 Audi A4 infotainment MMI keeps rebooting and takes over a minute or so to load back. This has been happening recently and i have rebooted the system and followed the Audi/reddit forums to seek any help but no resolution. It seems most of the 2020 Audis are facing similar issues. This issue is concerning and needs immediate attention since I have had instances where i lost backup camera while backing. Losing Navigation Capabilities or backup camera feature while backing up or driving has jeopardized me couple of times since i had to fumble and hit brakes as i was almost handicap momentarily. Audi is aware of this issue and have had issued TSB in 2020 which is attached here, but no recall was ever conducted which they should as this now an industry wide problem. Also, i got to know that S they have issued a 2021 MMI recall affecting over 44k Cars but not 2020, which is very surprising. Based on forums and other users it seems the Firmware version 3243 need an overhaul or even MMI module replacement if firmware update doesn't fix the issue. Request the authority to investigate this known issue for 2020 car line with similar intensity as this a widespread safety hazard. MMIs usually incorporate other modules as well so there is risk for ADAS failures or parking aids. Below is link to some on-going issues Audi 2020 users are facing [XXX] [XXX] INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)