Altec is recalling certain model year 2005-2013 AH75/85/100 aerial devices manufactured April 2005 through April 2013; and equipped with current leakage monitoring systems. The cable for the current leakage monitoring system may be too long and may breach the gap provided by the lower boom fiberglass insert chassis insulating system.
Consequence & remedy
Consequence: If the gap is breached, then the boom may conduct electrical current, increasing the risk of electrical shock to the operator.
Remedy: Altec will notify owners and dealers will inspect and properly secure the leakage monitor cable. The recall is expected to begin during September 2013. Altec's recall number is CSN 585. Owners may contact Altec at 1-877-462-5832.
Altec Industries, Inc. (Altec) is recalling certain model year 2002-2010 AH75, AH85 and AH100 aerial devices equipped with square pedestals. In the affected vehicles, the aerial device may develop cracks between the pedestal and the unit subbase.
Consequence & remedy
Consequence: Cracks in the pedestal may cause the aerial device to fail, increasing the risk of personal injury.
Remedy: Altec will notify owners informing them to inspect the pedestal and if any cracks are found, they will be repaired free of charge. The recall began on August 5, 2013. Owners may contact Altec at 1-800-860-0183. Altec's recall number is CSN 580.
Altec Industries, Inc. is recalling certain model year 2002-2009 AH75/85/100 and HL125 aerial device vehicles equipped with 16-foot radial outriggers. An improper torque was applied to the outrigger cylinder piston retention system during assembly. As a result, the cylinder could loosen from the rod allowing the outrigger leg to protrude beyond the confines of the chassis when it is in a stowed position.
Consequence & remedy
Consequence: If the cylinder loosens from the rod, the outrigger could strike a person or object, increasing the risk of injury or property damage.
Remedy: Altec will notify owners, and will increase the torque on the piston free of charge. The safety recall began on November 6, 2012. Owners may contact Altec Industries at 1-877-462-5832.
Altec Industries, Inc. is recalling certain model year 2008-2009 Aerial Device vehicles due to improper welding processes used to manufacture the boom pivot pins. Failure of the pin could cause separation of the boom from the turntable.
Consequence & remedy
Consequence: If the boom separates from the turntable, there is an increased risk of personal injury and/or property damage.
Remedy: Altec will notify owners, and will replace the pivot pins, free of charge. The safety recall began on September 12, 2012. Owners may contact Altec Industries at 1-877-462-5832.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
2008 Altec AH100 Problems, Complaints & Recalls | Skip That Year
Illustration