2024 Acura Zdx

The contact owns a 2024 Acura ZDX. The contact received notice of NHTSA Campaign Number: 26V306000 (Back Over Prevention). The contact stated that while in reverse(R), the rear-view camera became inoperable with a red or yellow caution sign displayed on the screen. Additionally, the contact stated that while the vehicle was in reverse(R) on several occasions, the electric side mirrors rotated down, and the driver could see objects and other vehicles behind the vehicle. The vehicle was taken to a dealer, and the contact was informed that a software update was needed. The software update was performed, but the failure persisted. The vehicle was diagnosed another time, and it was determined that the rear-view camera and an unknown part needed to be replaced. The vehicle was not repaired. The contact stated that on one occasion, after the dealer visit, while in reverse(R) with the rear-view camera displaying a blank screen, the vehicle reversed into another parked vehicle. The contact had to physically turn while reversing, but did not see the vehicle. There was no injury sustained. A Police report was not filed. The other vehicle sustained minor damage. The manufacturer was not notified of the failure. The failure mileage was approximately 11,915.

The contact owns a 2024 Acura ZDX. The contact received notification for NHTSA Campaign Number: 26V306000 (Back Over Prevention); however, the part to complete the recall repair was unavailable. The contact stated that the manufacturer exceeded a reasonable amount of time to perform the recall repair. The dealer was contacted and confirmed that the part was unavailable. The manufacturer was made aware of the issue. The contact had not experienced a failure.

My 2024 Acura ZDX A-Spec is impacted by the NHTSA Campaign Number 26V112000 (blank instrument panel/rearview camera). I took the vehicle to the dealership for the recall software update. The service invoice explicitly states: 'software update due performed software update on vehicle A11.' However, the update did not actually apply. The A11 module update is supposed to transition the infotainment system from Android 12 to Android 14 to resolve the safety issue. My vehicle is still stuck on Android 12, and Acura has incorrectly advised me that my trim does not get the update. The dealership's diagnostic tools are falsely reporting that the A11 safety recall update was successfully completed when it has not been, leaving my vehicle's camera and instrument panel vulnerable to failure. I have attached the service invoice as proof of the failed repair attempt. I have contacted Acura Customer Relations multiple times and advised that the recall is not complete. They have marked the recall update as complete.

On [XXX] at approximately 700 miles on a 2024 Acura ZDX A-Spec AWD (VIN [XXX] ), the Collision Mitigation Braking System (CMBS) failed to engage during a collision event. The system did not provide forward collision warning and did not initiate automatic emergency braking before impact. The collision resulted in minor damage to my vehicle. There were no injuries. CMBS is a manufacturer-installed automatic emergency braking system designed and marketed as a primary collision-avoidance safety feature; its failure to engage in an impending-impact scenario is a safety-critical defect. This CMBS failure is one of multiple safety system defects on this vehicle. Beginning at approximately 200 miles, the rear Advanced Driver Assistance System (ADAS) developed progressive failures, including: Rear Cross Traffic Alert and Rear Park Assist intermittently non-functional Blind Spot Monitoring failures on both left and right sides (DTCs U197A-00 confirmed by independent pre-repair diagnostic scan) A stress-cracked rear parking sensor housing A factory wiring harness routed incorrectly from the vehicle side, causing mechanical tension on the rear parking sensor connector and mounting bracket (confirmed in writing by the Acura dealer service manager on Repair Order [XXX][ dated February 25, 2026) American Honda Motor Co. (AHM) refused to honor the factory warranty, asserting without supporting forensic evidence that the defects were caused by an unspecified "outside influence" or "third-party repairs." I pursued and won binding consumer arbitration through the National Center for Dispute Settlement (NCDS Case [XXX]). On March 30, 2026, the arbitrator ruled that AHM had not met its warranty obligations and that no proof of any outside influence had been offered. The arbitrator ordered AHM to perform warranty repair of all the affected safety systems plus reimbursement of a diagnostic fee. AHM has not complied with the binding arbitration award. As of INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S

When reversing out of a parking spot, a driveway or around a corner, at random the vehicle will activate reverse automatic emergency braking for no reason. Sometimes multiple times in one maneuver. This is dangerous as it leaves you stopped in the middle of a street, particularly distressing when vehicles are coming and you have to take the extra time to take off the parking brake and continue the maneuver, hoping it doesn’t happen again.

The vehicle will slam on the brakes randomly without any warning or any object even near by. It will do it repeatedly to the point where I cannot reverse out of my driveway. This is dangerous as you find yourself stuck in the middle of the road with oncoming traffic because the car keeps automatically braking every few feet for no reason. The vehicles lane keep assist also will consistently intervene for no reason to the point you are constantly fighting it while driving if it’s on.