I kept having issues with the drivers seat belt not retracting properly (since purchased new) after use creating a tremendous amount of slack in the belt the next time it was used. I actually had to drive it several times with an extremely slack belt basically just hanging on my lap. Since this is a tri-point seat belt, in the event of a crash the entire belt would fail to keep the seat occupant safely belted to the seat including the chest strap AND lap belt. On further inspection by myself, I was able to determine the cause and keep it from happening again or at least correct the issue each time prior to driving the vehicle. I have recently seen this on 2 other Winnebago Forza's. 1 with the same floor plan (38W) and the other with a different plan. I have not mentioned this safety defect to either the manufacturer or any of their dealerships for fear they would simply fix mine and not look into all the other motorhomes they have made they may have the same issue. What is happening is that the seat belt was clearly installed prior to the interior finishing. When they installed the wood veneer that surrounds the place where the belt is attached to the sidewall (not floor). They didn't trim a large enough opening in the wood causing this pivot point on the belt to stick. When the driver pulls on the belt to attempt to free it, the belt twist and becomes bound up leading to slack in the belt. It's an easy fix to trim away some of the wood freeing this pivot up to operate normally.

NHTSA ODI #11535216

Official recalls

24V826000 · Latches/locks/linkages:hood:latch; Structure:body:hood:hinge And Attachments

Nov 1, 2024

Winnebago Industries, Inc. (Winnebago) is recalling certain 2014-2018 Sightseer, Itasca Sunova, 2016-2025 Forza, Vista, and Itasca/Winnebago Sunstar, 2015-2025 Adventurer, 2015-2024 Commercial Vehicle, 2015-2028 Itasca Suncruiser, and 2016-2017 Itasca Solei recreational vehicles. The hood bracket adhesive may have been incorrectly applied which can allow the bracket to detach.

Consequence & remedy

Consequence: A detached hood bracket may become a road hazard and increase the risk of a crash.

Remedy: Dealers will inspect and repair as necessary, free of charge. Owner notification letters began being mailed January 31, 2025. Owners may contact Winnebago at 1-800-537-1885. Winnebago's number for this recall is 192.

Additional source detail variants (2)

Latches/locks/linkages:hood:latch

Consequence: A detached hood bracket may become a road hazard and increase the risk of a crash.

Remedy: Dealers will inspect and repair as necessary, free of charge. Owner notification letters began being mailed January 31, 2025. Owners may contact Winnebago at 1-800-537-1885. Winnebago's number for this recall is 192.

Structure:body:hood:hinge And Attachments

Consequence: A detached hood bracket may become a road hazard and increase the risk of a crash.

24V733000 · Exterior Lighting:turn Signal

Oct 1, 2024

Winnebago Industries, Inc. (Winnebago) is recalling certain 2013-2017 Tour, 2013-2018 Journey, 2014-2022 Forza, 2015-2016 Brave, 2015-2019 Grand Tour, 2015-2021 Vista, 2016-2018 Adventurer, Sightseer, 2016-2021 Commercial Vehicle, 2018-2021 Intent, Sunstar, 2018-2020 Horizon, Itasca 2013-2017 Ellipse, Meridian, 2014-2017 Solei, 2015-2016 Tribute, 2015-2018 Sunstar, 2016-2018 Suncruiser, and Sunova motorhomes. The turn signals may have a smaller than required luminous lens area. As such these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) Number 108, "Lamps, Reflective Devices, and Associated Equipment."

Consequence & remedy

Consequence: A small lens can make it difficult for other drivers to see the turn signal, increasing the risk of a crash.

Remedy: Dealers will replace the turn signals, free of charge. Owner notification letters were mailed April 17, 2026. Owners may contact Winnebago Customer Care at 1-800-537-1885. Winnebago's number for this recall is 189.

23V365000 · Seat Belts:critical Fasteners

May 24, 2023

Winnebago Industries, Inc. (Winnebago) is recalling certain 2020-2023 Winnebago Shell, 2021-2023 Winnebago Inspire, 2022-2023 Winnebago Vista, Adventurer, Forza, Journey and Itasca Sunstar motorhomes. The seat belt attachment may have been improperly tightened. As such these vehicles fail to comply with the requirements of Federal Motor Vehicle Safety Standard (FMVSS) 210, "Seat Belt Assembly Anchorages."

Consequence & remedy

Consequence: A loose seat belt attachment may not properly restrain the occupant in the event of a crash, increasing the risk of injury.

Remedy: Dealers will inspect and tighten the seat belt attachment fasteners, as necessary, free of charge. Owner notification letters were mailed July 24, 2023. Owners may contact Winnebago at 1-800-537-1885. Winnebago's number for this recall is 175.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

No exact-year investigations in this snapshot.