← New search

1985 Volkswagen Jetta

Owner reports · Recalls · Investigations

Limited comparison data

There is not enough comparable history to draw a useful model-year comparison.

About this comparison →

How this year compares

Owner complaints by model year

Other model years Selected year
Compare all Jetta years →

Counts vary with age, sales and reporting. They are not failure rates.

What owners reported most

All reported categories

Tap a category to read its complaints. One report may name several components.

When problems were reported

Mileage at the reported incident

Limited mileage data: 0 of 13 reports include usable mileage. There isn’t enough coverage to show a useful chart.

NHTSA’s mileage field refers to the reported incident, not necessarily the filing date. This shows report counts, not the likelihood of a failure.

What to inspect

Issues worth paying extra attention to based on owner reports.

  • Power Train. Review the 4 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Service Brakes, Hydraulic. Review the 3 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →
  • Engine And Engine Cooling. Review the 2 owner reports in this category and discuss these concerns during a pre-purchase inspection. Read reports →

NHTSA owner reports · September 18, 2026 snapshot.

0 crash reports0 fire reports1 injury reports

Power Train complaints

4 reports
Clear category filter
Mileage unknown · Jun 24, 2002
Power Train

YOU CANNOT TELL IF THE CAR IS IN FIRST GEAR OR REVERSE. THIS IS EXTREEMLY DANGEROUS.*AK

NHTSA ODI #763390

Mileage unknown · Jun 9, 2000
Power Train

I THOUGHT THE PROBLEM WAS JUST MY CLUTCH CABLE NEEDING REPLACED BUT IT TURNED OUT TO BE THE PEDALS WELD POINT. THE ODOMETER HAS NEVER WORKED SINCE I'VE OWNED THE CAR BUT NO ONE CAN TELL WHY IT DOESN'T WORK. NO GEARS ARE STICKING AND THE SPEEDOMETER WORKS FINE. QUESTION, I REPLACED THE HEATER CORE AND HAD THE FUEL PUMP PROB…

Read full complaint

I THOUGHT THE PROBLEM WAS JUST MY CLUTCH CABLE NEEDING REPLACED BUT IT TURNED OUT TO BE THE PEDALS WELD POINT. THE ODOMETER HAS NEVER WORKED SINCE I'VE OWNED THE CAR BUT NO ONE CAN TELL WHY IT DOESN'T WORK. NO GEARS ARE STICKING AND THE SPEEDOMETER WORKS FINE. QUESTION, I REPLACED THE HEATER CORE AND HAD THE FUEL PUMP PROBLEM ALSO; HOW CAN I GET REIMBERSED FOR THESE RECALLS ?

NHTSA ODI #723783

Mileage unknown · Mar 31, 1998
Electrical SystemEngine And Engine CoolingPower Train

ALTERNATOR/STARTER FAILED.

NHTSA ODI #533448

Mileage unknown · Jun 16, 1995
Power Train

CLUTCH CABLE FAILED TWICE. *AK

NHTSA ODI #485394

Official recalls

3

92V050000 · Visibility:defroster/defogger/hvac System:heater Core

Apr 14, 1992

THE END CAP CONNECTING THE HEAT EXCHANGER'S CORE TO THE ENGINE COOLING SYSTEM COULD RUPTURE AND ALLOW HOT COOLANT TO ESCAPE INTO THE PASSENGER COMPARTMENT.

Consequence & remedy

Consequence: THE COOLANT ESCAPING INTO THE PASSENGER COMPARTMENT COULDCONTACT THE DRIVER'S FEET AND INJURE THE DRIVER. ALSO, STEAM FROM THE HEATEDLIQUID WILL CLOUD ON THE WINDOW SURFACES AND IMPAIR THE DRIVER'S VISION ANDCOULD RESULT IN A VEHICLE ACCIDENT.

Remedy: REPLACE THE HEATER CORE WITH AN IMPROVED HEATER CORE.

87V053000 · Fuel System, Gasoline:delivery:fuel Pump

Apr 14, 1987

FUEL PUMP, LOCATED INSIDE FUEL TANK, COULD SEIZE DURING HIGH AMBIENT TEMPERATURES BECAUSE OF AN EXTREME FINE MESH FUEL FILTER RESTRICTING THE FUEL FLOW.

Consequence & remedy

Consequence: FUEL SUPPLY TO ENGINE WOULD BE PARTIALLY INTERRUPTED,RESULTING IN STALLING.

Remedy: INSTALL A MODIFIED FUEL PUMP AND FILTER.

84V144000 · Service Brakes, Hydraulic:foundation Components:hoses, Lines/piping, And Fittings

Nov 14, 1984

THE CLIP LOCATED ABOVE THE EXHAUST PIPE WHERE IT ENTERS THE PRE-MUFFLER MAY MELT FROM EXCESSIVE HEAT CAUSED BY ENGINE IDLING.

Consequence & remedy

Consequence: Not supplied

Remedy: THE DEALER HAS INITIATED A TWO STEP CORRECTIVE PROCEDURE: THE FIRST STEP CONSISTS OF IMMEDIATE REMOVAL OF THE PLASTIC CLIP ON ALL AFFECTED VEHICLES. STEP TWO INVOLVES REPLACEMENT OF THE PLASTIC CLIP WITH A METAL ONE WHEN PARTS ARE AVAILABLE.

Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗

NHTSA investigations

3

EA91054 · Heater Core Failure

Opened Dec 9, 1991 · Closed Jun 12, 1992

Status: closed (inferred from source dates) · Visibility:defroster/defogger/hvac System

There is no summary currently available

PE91114 · Heater Core Failure

Opened Aug 26, 1991 · Closed Dec 9, 1991

Status: closed (inferred from source dates) · Visibility:defroster/defogger/hvac System

There is no summary currently available

PE91031 · Engine Mount Failure

Opened Jan 14, 1991 · Closed Apr 29, 1991

Status: closed (inferred from source dates) · Engine And Engine Cooling

There is no summary currently available