ALTHOUGH THE DEALER KNOWS OF THE PROBLEM, THEY HAVE BEEN UNABLE TO DUPLICATE IT SINCE IT IS INTERMITTENT. REPAIR HAS BEEN ATTEMPTED BY THE DEALER WITH NO IMPROVEMENT. VWOA HAS BEEN CONTACTED AND THEIR POSITION IS THE CAR MEETS FACTORY SPECIFICATIONS' SINCE THE DEALER CANNOT DUPLICATE THE PROBLEM. TO SAY THAT THE DEALER CANNOT …
Read full complaint
ALTHOUGH THE DEALER KNOWS OF THE PROBLEM, THEY HAVE BEEN UNABLE TO DUPLICATE IT SINCE IT IS INTERMITTENT. REPAIR HAS BEEN ATTEMPTED BY THE DEALER WITH NO IMPROVEMENT. VWOA HAS BEEN CONTACTED AND THEIR POSITION IS THE CAR MEETS FACTORY SPECIFICATIONS' SINCE THE DEALER CANNOT DUPLICATE THE PROBLEM. TO SAY THAT THE DEALER CANNOT DUPLICATE THE PROBLEM IS NOT THE SAME AS 'MEETING FACTORY SPECIFICATIONS. I HAVE ASKED VWOA TO CONSIDER REPLACING THE MOTORIZED BELT, WHICH HAS HAD MANY PROBLEMS BASED ON REPORTS PROVIDED TO CAR ENTHUSIAST LISTS, WITH THE CANADIAN STYLE 3 POINT SYSTEM AND ELIMINATE THE PROBLEMATIC MOTORIZED SYSTEM. THEIR RESPONSE HAS BEEN TO SAY THAT THERE IS NO PROBLEM. ANY AND ALL HELP WOULD BE APPRECIATED. THANK YOU...
VEHICLE DESCRIPTION: PASSENGER VEHICLES EQUIPPED WITH VR6 ENGINES. A COOLANT SYSTEM COMPONENT SUCH AS THE THERMO SWITCH, RADIATOR FAN, OR WATER PUMP, CAN MALFUNCTION CAUSING THE COOLANT TEMPERATURE AND COOLANT SYSTEM PRESSURE TO INCREASE SIGNIFICANTLY. OVER TIME, EXCESSIVE PRESSURE CAN CAUSE LEAKAGE OF COOLANT FROMTHE SYSTEM, INCLUDING LEAKAGE FROM THE HEAT EXCHANGER.
Consequence & remedy
Consequence: LEAKAGE OF HOT COOLANT FROM THE HEAT EXCHANGER CAN CAUSE INJURY TO THE FEET OF THE DRIVER OR STEAM UP THE INTERIOR OF THE VEHICLE TEMPORARILY IMPAIRING THE DRIVER'S VISION.
Remedy: DEALERS WILL INSTALL IN THE COOLANT INLET HOSE TO THE HEATER CORE, A PRESSURE REDUCER WITH A 5MM DIAMETER SECURED BY A SPRING TENSIONED HOSE CLAMP. ALSO A NEW RELAY THAT WILL CHANGE THE OPERATION OF THE SECONDARY ELECTRICAL COOLANT PUMP WILL BE INSTALLED. DEALERS WILL ALSO PERFORM A FUNCTIONAL CHECK OF THE COOLING SYSTEM TO MAKE SURE THAT ALL COOLING SYSTEM COMPONENTS OPERATE PROPERLY.
IMPROPER MATERIAL WAS USED IN MANUFACTURING THE RADIATOR FAN MOTOR SHAFT CAUSING THE SHAFT TO WEAR AND BECOME NOISY.
Consequence & remedy
Consequence: A WORN AND NOISY FAN MOTOR SHAFT CAN SEIZE RENDERINGTHE FAN MOTOR INOPERATIVE, EVENTUALLY CAUSING THE ENGINE TO OVERHEAT AND STALL. A STALLED VEHICLE IN TRAFFIC CAN INCREASE THE POTENTIAL FOR A VEHICLE ACCIDENT.
Remedy: DEALERS WILL REPLACE THE COMPLETE COOLING FAN ASSEMBLY ON VEHICLE HAVING THE POTENTIAL SHAFT MATERIAL PROBLEM. DEALERS WILL INSTALL A NEW FAN BLADE INCLUDING A NEW LOCK NUT ON VEHICLE WITH LOOSE FAN BLADE LOCK NUTS.
AN ENGINE COMPARTMENT ELECTRICAL WIRING HARNESS MAY HAVE BEEN ROUTED TOO CLOSE TO A SHEET METAL EDGE. THE WIRING CAN BECOME DAMAGED DURING NORMAL VEHICLE OPERATION DUE TO CHAFING, RESULTING IN AN ELECTRICAL SHORT.
Consequence & remedy
Consequence: IF A SHORT OCCURS, EITHER THE ENGINE COULD STALL ORTHE RADIATOR FAN COULD STOP OPERATING CAUSING THE ENGINE TO OVERHEAT. EITHERCONDITION COULD RESULT IN A VEHICLE ACCIDENT.
Remedy: REROUTE AND SECURE VARIOUS WIRING HARNESSES INSIDE THE ENGINE COMPARTMENT.
Model-level recall history does not show whether a particular VIN is affected or has received a repair. Check a VIN with NHTSA ↗
NHTSA investigations
0
No exact-year investigations in this snapshot.
1993 Volkswagen Corrado Problems, Complaints & Recalls | Skip That Year
Illustration