2023 Toyota Tacoma

Twice, while backing out of my driveway, the brakes have locked up. The brakes stay locked until you tap them repetitively for a few minutes. Then the brakes will slowly release while going forward, but only lock up again when put in reverse. The vehicle cannot be driven until the next day, then it performs normally. luckily this happened in my driveway before I got on to the street. When the brakes lock, it is violent, throwing me against the seat back. The vehicle has been to two different dealers, but they could not duplicate the issue. When this happens multiple brake warning messages pop up on the dash. The manufacture has not inspected the vehicle. In fact, when I reported it to them, and sent pictures of the warning messages, they insinuated that the pictures were not from my vehicle. The manufacture stated that they do not consider this a safety issue. I do not feel safe driving this vehicle. If the brakes lock while out on the hi-way it could cause an accident.

The contact owns a 2023 Toyota Tacoma. The contact stated that while the vehicle was receiving maintenance by a local dealer, the technician became aware of a leak coming from the steering wheel. The technician stated that he needed to verify the vehicle a second time to confirm if the failure was a manufacturer’s defect. The vehicle was not repaired and remained with the dealer. The manufacturer was not made aware of the failure. The failure mileage was approximately 35,000.

The contact owns a 2023 Toyota Tacoma. The contact stated that while reversing, the RPM and engine surged while turning the steering wheel. There were no warning lights illuminated. The vehicle was taken to the local dealer, who informed the contact that there was no coverage for the failure of the vehicle. The vehicle was not diagnosed or repaired. The contact related the failure to TSB: 0125-18. The manufacturer was contacted and referred the contact to the NHTSA Hotline for assistance. The failure mileage was approximately 300.

The contact owns a 2023 Toyota Tacoma. The contact stated that while driving at approximately 15 MPH and attempting to make a right turn, the check engine warning light illuminated, and the vehicle started jerking. The vehicle was taken to the dealer, where the contact was informed that the vehicle could not be diagnosed because the check engine warning light was not illuminated. The contact stated that the failure persisted. The manufacturer was not made aware of the failure. The vehicle was not repaired. The failure mileage was 2,000.

When starting the truck and warming up a minute or so and then putting in reverse to back out or forward to pull into a carport, idling in gear with your foot only on the brake, the engines surges/revs up with just the slight turn of the steering wheel causing an unintended speed increase. I believe that this could cause a minor accident. It does not appear to be caused by the engine having a fast idle when cold as the idle drops when you shift into a gear. What appears to be happening is the ECU over compensates for the slight strain caused by the power steering pump when you turn the wheel. My carport is narrow and does not align exactly with the driveway, you have to jog left a foot or two and then right to pull in or back out. At the second service visit on 12/12/23 the dealer then checked and observed this behavior and reported "This is normal operation and directly related to power steering pump activation when wheel is turned in any direction" The vehicle was purchased new last May and currently has 3,995 miles on it. I think it probably had this problem from new but I had mostly just pulled straight in and out of the driveway until the fall when it was mostly parked in the carport as it was not being driven as regularly. I don't think it does it as bad when fully warmed up which takes quite a while for this engine.

The camera is horrible. Very gritty and grainy I took it to the dealership they agreed. Tried replacing but it is still bad. I previously owned a 2020 Rav 4 and the camera was very crisp and clear. Camera should be just as good if not better for a truck. They have more blind spots. This has been an issue since I purchased the vehicle in December 2023 which is only about 5 months.

The front driver's seat is loose and has movement/play. Described by dealer service tech as a 'wobble'. Seat is not fully secure/stable. Vehicle was taken to original delivery dealer (Dublin Toyota, 4321 Toyota Dr, Dublin CA 94568) for inspection, RO#[XXX]. The vehicle was returned without the issue being corrected. Received verbal response that the dealer was not able to do anything about it (incl replacement of components, etc. and was told other 2023 Model Year Tacomas exhibit the same behavior of the loose driver's seat). Called and spoke with Toyota Brand Engagement (800) 331-4331 as instructed by the service advisor. Ticket was recorded as case [XXX] and was closed without solving the issue. I was advised by the Toyota case in that case [XXX], where the agent recommended I speak with another dealer (Livermore Toyota) to get a second opinion before the case could get escalated. The vehicle was not repaired and I was sent home with the loose seat. Per the description from Repair Order [XXX], on [XXX]: "Cause: DRIVER'S SEAT SEEMS LOOSE AND WOBBLES.REMOVE SEAT ASSEMBLY AND CHECK ALL HARDWARE.EVERYTHING CHECKED OK.REINSTALL SEAT AND TIGHTEN MOUNTING BOLTS.CHECK WITH ANOTHER 2023 TACOMA VIN [XXX] . DRIVER'S SEAT OPERATION IS THE SAME. THANK YOU 2426" I strongly believe that a loose driver's seat that exhibits 'wobble' is unsafe and also causes discomfort / lack of confidence for the driver. INFORMATION REDACTED PURSUANT TO THE FREEDOM OF INFORMATION ACT (FOIA), 5 U.S.C. 552(B)(6)

The contact owns a 2023 Toyota Tacoma. The contact received notification of NHTSA Campaign Number: 24V152000 (Power Train) however, the part to do the recall repair was not yet available. The contact stated that the manufacturer had exceeded a reasonable amount of time for the recall repair. The dealer was made aware of the issue and confirmed that parts were not yet available. The manufacturer was made aware of the issue and confirmed that parts were not yet available. The contact had not experienced a failure. VIN tool confirms parts not available.